金属Mn^(2+)在烟草上的吸附性能

采用静态法,研究了Mn2+在烟草上的吸附及其解吸附性能,探讨了pH值对吸附的影响,测定了在不同温度、浓度下的吸附速率曲线和吸附等温线。结果表明,烟草对Mn2+的吸附速率快,吸附热效应高,pH值对吸附有较大的影响;吸附动力学过程可由lagergren一级动力学模式较好地描述;吸附等温模型符合Langmuir和Temkin等温吸附机理,在低浓度范围内吸附量与平衡浓度呈直线关系。

Thermal decomposition of magnesium ammonium phosphate and adsorption properties of its pyrolysis products toward ammonia nitrogen

High-purity magnesium ammonium phosphate （MAP） was precipitated by controlling pH value of the reaction system of 9.0-9.5. The thermal decomposition behavior of MAP and the adsorption properties of its pyrolysis products toward ammonia-nitrogen were also studied by XRD, SEM, TGA-DTA and FT-IR methods. The results indicated that high-purity MAP was obtained at pH value of 9.0-9.5. Upon heating to 100-120℃ for 120 min, MAP was thermally decomposed, losing water and ammonia concomitantly with a reduction in grain size and crystallinity. The capacity of pyrolysis products for ammonia nitrogen adsorption reached 72.5 mg/g, with a removal rate of up to 95% from an 800 mg/L solution. The characteristic diffraction peaks corresponding to MAP mainly appeared in their XRD patterns after adsorption of ammonia nitrogen. The pyrolysis products of MAP at 100-120 ℃ could be recycling-used as the chemical treatment regents of ammonia nitrogen in the practical application.

Ethylbenzene disproportionation and p-xylene selectivity enhancement in xylene isomerization using high crystallinity desilicated H-ZSM-5

Desilication accompanied with minimum loss of crystallinity effect of a high alumina ZSM-5 zeolite on the isomerization reaction of ethylbenzene/xylene mixtures has been considered.Desilication was assessed through XRF,XRD,FTIR,TEM,nitrogen adsorption/desorption,NH_3-TPD,^(29)Si and^(27)Al MAS NMR analytical techniques.Desilication was accompanied with the creation of super acid sites.There exists a limit(Si/Al molar ratio of9.67)for keeping high crystallinity and obtaining improved catalytic performance.Desilication promotes ethylbenzene conversion by disproportionation and trans-alkylation reactions while the same reactions are limited for the xylene isomers.The p-xylene approach to equilibrium improves by more than 7% at 400℃ and a WHSV of 2 h^(-1)for the optimum sample with respect to the parent zeolite.At the same conditions,the optimum sample exhibits the maximum ethylbenzene conversion of 89%,i.e.more than 40%w.r.t.of the parent zeolite.However,the xylene yield decreases only 3%.

Phosphorus Sorption-desorption Characteristics of Ditch Sediments from Different Land Uses in a Small Headwater Catchment in the Central Sichuan Basin of China

Investigation of phosphorus (P) sorption-desorption characteristics of drainage ditch sediments is important for better understanding on sediment P transport behaviors in ditches. Surface ditch sediment samples were collected from headwater sub-catchment of forestland, sloping cropland, paddy field, and residential area in a representative catchment in the central Sichuan Basin. These sediment samples were used for determination of P sorption-desorption characteristics by a batch equilibrium technique. Results showed that the maximum P sorption capacities (Qm) in the sediments ranged from 159.7 to 263.7 mg/kg, while higher Qm were observed in the ditch sediments from the paddy fields. The Qm was significantly and positively correlated with oxalate-extractable Fe and Al oxides (r=0.97 and 0.98, p < 0.01), clay fraction (r = 0.78, p < 0.05) and organic matter (r = 0.95, p < 0.01). Sediment pH, clay and organic matter influenced the P sorption through amorphous Fe and Al oxides. CaCO3 content was negatively correlated with the Qm (r = -0.83, p < 0.05), implying that saturated CaCO3 (> 50 g/kg) would not increase P sorption capacity in the ditch sediments. The ditch sediments featured a linear desorption curve, suggesting that P release risk would be enhanced with the increase of the P adsorption. The P desorption rate was positively correlated with Olsen P (r = 0.94, p < 0.01), but negatively related to the fine particle-size fractions (r = -0.92, p < 0.01), the sum of the amorphous Fe and Al oxides (r = -0.67, p < 0.05) and the P sorption capacity (r = -0.59, p < 0.05). The ditch sediments from residential area had a higher P release risk than that from the other ditches of forestland, sloping cropland and paddy field. The P sorption index (PSI) derived from single-point measurement was significantly correlated with the P sorption capacity (r = 0.99, p < 0.01), and could be used for estimating Qm as 1.64 times PSI plus 24.0 (Qm = 1.64 PSI + 24.0) for similar sediments with highly calcareous soils and sediments. Ditch cleaning and sediment removal for the ditch in residential area were recommended in this area to reduce the P release risk.

Preparation of MnO_2 and calcium silicate hydrate from electrolytic manganese residue and evaluation of adsorption properties

Electrolytic manganese residue(EMR), a high volume byproduct resulting from the electrolytic manganese industry, was used as a cheap and abundant chemical source for preparing MnO2 and EMR-made calcium silicate hydrate(EMR-CSH). The MnO2 is successfully synthesized from the metal cations extracted from EMR, which can effectively recycle the manganese in the EMR. By the combination of XRD, SEM and EDX analysis, the as-prepared MnO2 is found to exhibit a single-phase with the purity of 90.3%. Furthermore, EMR-CSH is synthesized from EMR via hydrothermal method. Based on the detailed analyses using XRD, FT-IR, FE-SEM, EDX and BET surface area measurement, the product synthesized under the optimum conditions(p H 12.0 and 100 °C) is identified to be a calcium silicate hydrate with a specific surface area of 205 m2/g incorporating the slag-derived metals(Al and Mg) in its structure. The as-synthesized material shows good adsorption properties for removal of Mn2+ and phosphate ions diluted in water, making it a promising candidate for efficient bulk wastewater treatment. This conversion process, which enables us to fabricate two different kinds of valuable materials from EMR at low cost and through convenient preparation steps, is surely beneficial from the viewpoint of the chemical and economical use of EMR.

Preparation and characterization of H_4SiW_(12)O_(40)@MIL-100(Fe) and its catalytic performance for synthesis of 4,4'-MDA

The catalytic performance of co mmonly used heteropolyacids （H3PW12O40, H4SiW12O40 and H3PMO12O40 synthesis of 4,4＇-methylenedianiline （4,4＇-MDA） from aniline and formaldehyde was evaluated and the result showed that H4SiW12O40 with moderate acid strength exhibited the best catalytic performance. Then HaSiW12O40@MIL-100（Fe） was prepared by encapsulating H4SiW12O40 within the pores of MIL-100（Fe） to facilitate its recovery and reuse. The prepared H4SiW12O40@MIL-100（Fe） was characterized by means of FT-IR, N2 adsorption-desorption, XRD, TG and then the catalytic performance was evaluated. The result showed that H4SiW12O40 was highly dispersed in the pores of MIL-100（Fe）, and both the Keggin structure of HaSiW12O40 and the crystal skeleton structure of MIL-100（Fe） could be effectively/preserved. Furthermore, H4SiW12O40@ MIL-100（Fe） showed excellent catalytic performance under the following reaction conditions： a molar ratio of aniline to formaldehyde = 5, a mass ratio of catalyst to formaldehyde = 1.2, a reaction temperature of 120 ℃ and a reaction time of 6 h. Under the above reaction conditions, the conversion of aniline was 41.1%, and the yield and selectivity of 4,4＇-MDA were 81,6% and 79.2%, respectively. Unfortunately, an appreciable loss in the catalytic activity of the recovered H4SiW12O40@MIL-100（Fe） was observed because of the blocking of the pores and the change of the acidity resulted from the adsorption of alkaline organics such as aniline and 4,4＇-MDA. The adsorbed alkaline organics could be cleaned up when the recovered catalyst was washed by methanol and DMF. Then the catalyst was effectively reused up to three cycles without much loss in its activity.

Conversion of bimetallic MOF to Ru-doped Cu electrocatalysts for efficient hydrogen evolution in alkaline media

The rational design and construction of inexpensive and highly active electrocatalysts for hydrogen evolution reaction(HER)is of great importance for water splitting.Herein,we develop a facile approach for preparation of porous carbon-confined Ru-doped Cu nanoparticles(denoted as Ru-Cu@C)by direct pyrolysis of the Ru-exchanged Cu-BTC metal–organic framework.When served as the electrocatalyst for HER,strikingly,the obtained Ru-Cu@C catalyst exhibits an ultralow overpotential(only 20 mV at 10 mA cm^(-2))with a small Tafel slope of 37 m V dec^(-1)in alkaline electrolyte.The excellent performance is comparable or even superior to that of commercial Pt/C catalyst.Density functional theory(DFT)calculations confirm that introducing Ru atoms into Cu nanocrystals can significantly alter the desorption of H_(2) to achieve a close-to-zero hydrogen adsorption energy and thereby boost the HER process.This strategy gives a fresh impetus to explore low-cost and high-performance catalysts for HER in alkaline media.