Three steam distillation devices (D-1, D-2 and D-4) or one simultaneous distillation (D-3, water-diethyl ether) as well as the process of CO2-SFE (Supercritical fluid extraction) were adopted in extraction of essentia...Three steam distillation devices (D-1, D-2 and D-4) or one simultaneous distillation (D-3, water-diethyl ether) as well as the process of CO2-SFE (Supercritical fluid extraction) were adopted in extraction of essential oils from Chinese-fir (Cunninghamia lancedata (Lamb) Hook.) and the chemical components of the extracted essential oil were analyzed by Gas chromatograph-MS analyses. The results showed that the essential oil could be almost extracted out within 2 hours and the device-3 had the highest extraction efficiency. The major chemical component of the oil was cedrol. The yield of the extracted essential oils from Chinese fir decreased gradually with the increase of the distillation time. The best condition for extraction by means of CO2-SFE is 100 kg·cm?2 in pressure and 40°C in temperature for. Keywords Chinese fir - Essential oil - Cedrol - Supercritical fluid extraction CLC number S781.4 Document code A Foundation item: This paper was support by the Key Foundation Research Project (G1999016001) of China and the Japan International Cooperation AgencyBiography: HUANG Luo-hua (1957-), male, Research associate, Research Institute of Wood Industry, Chinese Academy of forestry, Beijing 100091, P. R. ChinaResponsible editor: Song Funan展开更多
A continuous three-stage supercritical fluid extraction (SFE) process with a capacity of 1.0kg.h^-1 was setup to extract petroleum residue by pentane to obtain more oil for further upgrading. A discharging system inte...A continuous three-stage supercritical fluid extraction (SFE) process with a capacity of 1.0kg.h^-1 was setup to extract petroleum residue by pentane to obtain more oil for further upgrading. A discharging system integrated to the bottom of the extractor was used to recover solvent as gas while asphalt was obtained as fine particles. The influence of operating conditions on the yield and quality of extracts, i.e., deasphalted oil (DAO) and resin, was studied in the range of temperature 150-220℃, pressure of 4.0-6.0 MPa and the mass ratio of solvent to oil feed (S/O) 2.5-5.0. The particle size distribution, apparent forms and the packing density, which vary with operating pressure, were measured. The particle structures were observed by SEM as well. With the modification to conventional processes, furnace can be eliminated for solvent recovery from asphalt phase, so as to reduce energy consumption.展开更多
Supercritical CO2 (SC-CO2) extraction technology and ultrasonic technology were used to extract two active sex hormones, estradiol and progesterone, and insulin-like growth factor-1 (IGF-1) from antler velvet. The eff...Supercritical CO2 (SC-CO2) extraction technology and ultrasonic technology were used to extract two active sex hormones, estradiol and progesterone, and insulin-like growth factor-1 (IGF-1) from antler velvet. The effects of SC-CO2 extraction condition on the extraction yield and content of sex hormones, the ultrasonic extrac-tion condition on the content of IGF-1 and the SC-CO2 extraction condition on the activity remaining of IGF-1 were studied. The optimal conditions were obtained. The experimental results showed that, in presence of 75% ethanol as the co-solvent, the mean yield and content of estradiol and progesterone were 87.67 pg·g-1 and 1224.10 pg·g-1, 12.38 ng·g-1 and 354.06 ng·g-1, respectively, with extraction pressure of 30 MPa, temperature of 35°C, extraction time of 30 min and CO2 consumption of 15 L·g-1 at the flow rate of 2.0 L·min-1. The highest content of IGF-1 was 7425.75 ng·g-1 antler velvet residue, when the pH10 ammonia-ammonium chloride buffer solution was used as the solvent, the ratio of solvent to sample was 20/1 (volume/mass), the extraction temperature was 0-35°C, and the ex-traction time was 4×15 min. Under these conditions, 93.68% activity remaining of IGF-1 in the residue was ob-tained, while little IGF-1 activity exists in traditional residue. The experimental results indicate that the technology of SC-CO2 with co-solvent is of advantage for getting high content sexual hormones and keeping high activity of IGF-1 in the residue, which can not be achieved by traditional extraction methods.展开更多
Syzygium campanulatum Korth is a plant, which is a rich source of secondary metabolites （especially flavanones, chalcone, and triterpenoids）. In our present study, three conventional solvent extraction （CSE） techn...Syzygium campanulatum Korth is a plant, which is a rich source of secondary metabolites （especially flavanones, chalcone, and triterpenoids）. In our present study, three conventional solvent extraction （CSE） techniques and supercritical fluid extraction （SFE） techniques were performed to achieve a maximum recovery of two flavanones, chalcone, and two triterpenoids from S. campanulatum leaves. Furthermore, a Box-Behnken design was constructed for the SFE technique using pressure, temperature, and particle size as independent variables, and yields of crude extract, individual and total secondary metabolites as the dependent variables. In the CSE procedure, twenty extracts were produced using ten different solvents and three techniques （maceration, soxhletion, and reflux）. An enriched extract of five secondary metabolites was collected using n-hexane：methanol （1：1） soxhletion. Using food-grade ethanol as a modifier, the SFE methods produced a higher recovery （25.5%-84.9%） of selected secondary metabo- lites as compared to the CSE techniques （0.92%-66.00%）.展开更多
基金The Key Foundation Research Project (G1999016001) of China and the Japan International Cooperation Agency
文摘Three steam distillation devices (D-1, D-2 and D-4) or one simultaneous distillation (D-3, water-diethyl ether) as well as the process of CO2-SFE (Supercritical fluid extraction) were adopted in extraction of essential oils from Chinese-fir (Cunninghamia lancedata (Lamb) Hook.) and the chemical components of the extracted essential oil were analyzed by Gas chromatograph-MS analyses. The results showed that the essential oil could be almost extracted out within 2 hours and the device-3 had the highest extraction efficiency. The major chemical component of the oil was cedrol. The yield of the extracted essential oils from Chinese fir decreased gradually with the increase of the distillation time. The best condition for extraction by means of CO2-SFE is 100 kg·cm?2 in pressure and 40°C in temperature for. Keywords Chinese fir - Essential oil - Cedrol - Supercritical fluid extraction CLC number S781.4 Document code A Foundation item: This paper was support by the Key Foundation Research Project (G1999016001) of China and the Japan International Cooperation AgencyBiography: HUANG Luo-hua (1957-), male, Research associate, Research Institute of Wood Industry, Chinese Academy of forestry, Beijing 100091, P. R. ChinaResponsible editor: Song Funan
文摘A continuous three-stage supercritical fluid extraction (SFE) process with a capacity of 1.0kg.h^-1 was setup to extract petroleum residue by pentane to obtain more oil for further upgrading. A discharging system integrated to the bottom of the extractor was used to recover solvent as gas while asphalt was obtained as fine particles. The influence of operating conditions on the yield and quality of extracts, i.e., deasphalted oil (DAO) and resin, was studied in the range of temperature 150-220℃, pressure of 4.0-6.0 MPa and the mass ratio of solvent to oil feed (S/O) 2.5-5.0. The particle size distribution, apparent forms and the packing density, which vary with operating pressure, were measured. The particle structures were observed by SEM as well. With the modification to conventional processes, furnace can be eliminated for solvent recovery from asphalt phase, so as to reduce energy consumption.
基金Supported by the Natural Science Foundation of Tianjin (06YFJMJC10500)
文摘Supercritical CO2 (SC-CO2) extraction technology and ultrasonic technology were used to extract two active sex hormones, estradiol and progesterone, and insulin-like growth factor-1 (IGF-1) from antler velvet. The effects of SC-CO2 extraction condition on the extraction yield and content of sex hormones, the ultrasonic extrac-tion condition on the content of IGF-1 and the SC-CO2 extraction condition on the activity remaining of IGF-1 were studied. The optimal conditions were obtained. The experimental results showed that, in presence of 75% ethanol as the co-solvent, the mean yield and content of estradiol and progesterone were 87.67 pg·g-1 and 1224.10 pg·g-1, 12.38 ng·g-1 and 354.06 ng·g-1, respectively, with extraction pressure of 30 MPa, temperature of 35°C, extraction time of 30 min and CO2 consumption of 15 L·g-1 at the flow rate of 2.0 L·min-1. The highest content of IGF-1 was 7425.75 ng·g-1 antler velvet residue, when the pH10 ammonia-ammonium chloride buffer solution was used as the solvent, the ratio of solvent to sample was 20/1 (volume/mass), the extraction temperature was 0-35°C, and the ex-traction time was 4×15 min. Under these conditions, 93.68% activity remaining of IGF-1 in the residue was ob-tained, while little IGF-1 activity exists in traditional residue. The experimental results indicate that the technology of SC-CO2 with co-solvent is of advantage for getting high content sexual hormones and keeping high activity of IGF-1 in the residue, which can not be achieved by traditional extraction methods.
文摘Syzygium campanulatum Korth is a plant, which is a rich source of secondary metabolites （especially flavanones, chalcone, and triterpenoids）. In our present study, three conventional solvent extraction （CSE） techniques and supercritical fluid extraction （SFE） techniques were performed to achieve a maximum recovery of two flavanones, chalcone, and two triterpenoids from S. campanulatum leaves. Furthermore, a Box-Behnken design was constructed for the SFE technique using pressure, temperature, and particle size as independent variables, and yields of crude extract, individual and total secondary metabolites as the dependent variables. In the CSE procedure, twenty extracts were produced using ten different solvents and three techniques （maceration, soxhletion, and reflux）. An enriched extract of five secondary metabolites was collected using n-hexane：methanol （1：1） soxhletion. Using food-grade ethanol as a modifier, the SFE methods produced a higher recovery （25.5%-84.9%） of selected secondary metabo- lites as compared to the CSE techniques （0.92%-66.00%）.
