期刊文献+
共找到3篇文章
< 1 >
每页显示 20 50 100
近水平岩层边坡工程地质模型及稳定性研究 被引量:3
1
作者 郭兵兵 舒继森 +1 位作者 舒应秋 吕金星 《中国矿业》 北大核心 2012年第2期104-107,共4页
边坡工程地质模型是研究边坡破坏模式和稳定性计算的基础。说明了边坡工程地质模型的内容、露天矿层状边坡的基本工程地质模型、近水平岩层边坡的破坏模式。在工程地质工作的基础上,划分工程地质岩组,研究岩体结构和地下水影响,建立了... 边坡工程地质模型是研究边坡破坏模式和稳定性计算的基础。说明了边坡工程地质模型的内容、露天矿层状边坡的基本工程地质模型、近水平岩层边坡的破坏模式。在工程地质工作的基础上,划分工程地质岩组,研究岩体结构和地下水影响,建立了某露天矿东南帮边坡的工程地质模型,分析了可能的破坏模式是圆弧滑动和圆弧-顺层滑动,对不同破坏模式下的安全系数进行计算,评价了16#煤开采前后边坡的稳定性。 展开更多
关键词 露天矿 近水平岩层 边坡工程地质模型 边坡稳定
下载PDF
云盘头滑坡变形破坏机制研究 被引量:5
2
作者 张灵熹 陈筠 +2 位作者 刘恋嘉 王麒 池昌峰 《长江科学院院报》 CSCD 北大核心 2019年第11期27-33,共7页
缓倾顺层岩质边坡由于其岩层倾角较缓,具有不易察觉其失稳且识别难度大的特点。以一个典型的缓倾顺层岩质边坡(贵州云盘头滑坡)为例,基于工程地质勘察,建立边坡地质模型,并结合底摩擦试验、二维离散元和有限元模拟等方法,探讨云盘头滑... 缓倾顺层岩质边坡由于其岩层倾角较缓,具有不易察觉其失稳且识别难度大的特点。以一个典型的缓倾顺层岩质边坡(贵州云盘头滑坡)为例,基于工程地质勘察,建立边坡地质模型,并结合底摩擦试验、二维离散元和有限元模拟等方法,探讨云盘头滑坡的变形破坏机制。结果表明:云盘头滑坡的变形破坏过程可分为微裂纹发育阶段、裂纹拓展阶段、滑体变形阶段与完全破坏阶段,并在坡脚存在关键块体;滑坡形成的主要原因是,坡体经过开挖导致软弱夹层出露,坡体内部发育垂直于软弱夹层的拉裂纹并将滑体分割成块体,随着坡脚关键块体向临空面滑移,后部次级块体随之移动并产生多米诺骨牌效应导致坡体发生整体滑移,变形模式属于典型的滑移-拉裂式。研究成果为探究缓倾顺层岩质边坡的失稳破坏有现实意义。 展开更多
关键词 缓倾顺层岩质边坡 工程地质勘察 边坡地质模型 底摩擦试验 滑移-拉裂 云盘头滑坡
下载PDF
Effect of the inclined weak interlayers on the rainfall response of a bedded rock slope 被引量:6
3
作者 LI Long-qi 《Journal of Mountain Science》 SCIE CSCD 2016年第9期1663-1674,共12页
Engineering experience shows that outward dipping bedded rock slopes, especially including weak interlayers, are prone to slide under rainfall conditions. To investigate the effect of inclined weak interlayers at vari... Engineering experience shows that outward dipping bedded rock slopes, especially including weak interlayers, are prone to slide under rainfall conditions. To investigate the effect of inclined weak interlayers at various levels of depth below the surface on the variation of displacements and stresses in bedded rock slopes, four geo- mechanical model tests with artificial rainfall have been conducted. Displacements, water content as well as earth pressure in the model were monitored by means of various FBG (Fiber Bragg Grating) sensors. The results showed that the amount of displacement of a slope with a weak interlayer is 2.8 to 6.2 times larger than that of a slope without a weak interlayer during one rainfall event. Furthermore, the position of the weak interlayer in terms of depth below the surface has a significant effect on the zone of deformation in the model. In the slope with a high position weak interlayer, the recorded deformation was larger in the superficial layer of the model and smaller in the frontal portion than in the slope with a low position weak interlayer. The slope with two weak interlayers has the largest deformation at all locations of all test slopes. The slope without a weak interlayer was only saturated in its superficial layer, while the displacement decreased with depth. That was different from all slopes with a weak interlayer in which the largest displacement shifted from the superficial layer to the weak interlayer when rainfall persisted. Plastic deformation of the weak interlayer promoted the formation of cracks which caused more water to flow into the slope, thus causing larger deformation in the slope with weak interlayers. In addition, the slide thrust pressure showed a vibration phenomenon o.5 to 1 hour ahead of an abrupt increase of the deformation, which was interpreted as a predictor for rainfall-induced failure of bedded rock slopes. 展开更多
关键词 Bedded rock slope Inclined weakinterlayer RAINFALL Model test
下载PDF
上一页 1 下一页 到第
使用帮助 返回顶部