The microstructure,dielectric and ferroelectric properties of(1-y)Ba(Zr0.1Ti0.9)O3-yBa(Zn1/3Nb2/3)O3(y=0-0.05)ceramics prepared by traditional solid state method were investigated by X-ray diffractometer,scanning elec...The microstructure,dielectric and ferroelectric properties of(1-y)Ba(Zr0.1Ti0.9)O3-yBa(Zn1/3Nb2/3)O3(y=0-0.05)ceramics prepared by traditional solid state method were investigated by X-ray diffractometer,scanning electron microscope,electric parameter testing system and ferroelectric tester.It is found that the barium zirconate titanate based ceramics are single-phase perovskites as y increases up to 0.05 and their average grain size decreases with the increase of y.The permittivity maximumεr,max is suppressed from 8948 to 1611 at 1 kHz with increasing y,and the ferroelectric-paraelectric phase transition temperature Tm decreases from 93 to-89℃at 1 kHz as y increases.The composition-induced diffuse phase transition is enhanced with increasingy.The relaxor-like ferroelectric behavior with a strong frequency dispersion of Tm and permittivity at T<Tm accompanied by a strong diffuse phase transition is found for the system with high y value.The remnant polarization decreases with increasing y,while the coercive field decreases remarkably and then increases with the increase of y.展开更多
To make the ferroelectric BaTiO3 possess ferromagnetism simultaneously,magnetic Fe was doped into BaTiO3 ceramics at doping levels up to 10%(molar fraction).Both tetragonal and hexagonal phases coexisted in the Fe-dop...To make the ferroelectric BaTiO3 possess ferromagnetism simultaneously,magnetic Fe was doped into BaTiO3 ceramics at doping levels up to 10%(molar fraction).Both tetragonal and hexagonal phases coexisted in the Fe-doped BaTiO3 ceramics except at 1% doping level.X-ray diffraction analysis indicated that higher doping level of Fe,higher sintering temperature and longer sintering time promoted the formation of hexagonal phases in Fe-doped BaTiO3 ceramics.Ferroelectricity was observed in all samples at room temperature,but it was greatly depressed by Fe doping.Except at doping level of 1%,room-temperature ferromagnetism was observed in the BaTiO3 ceramics.The dependence of the saturation magnetization and coercivities of the Fe-doped BaTiO3 ceramics on doping level was systematically studied.Both the saturation magnetization and magnetic coercivities were found to be dependent on the doping level as well as the fraction of the hexagonal phase in the ceramics.展开更多
The environmentally-friendly(1-x)Ba(Zr_(1/3)Ti_(2/3))O_(3)-xBaMg_(0.1)Ta_(0.9))O_(3)(x=0,0.02,0.04,0.06,0.08)relaxor ferroelectric ceramics were prepared by the conventional solid-state method and sintered in air at 1...The environmentally-friendly(1-x)Ba(Zr_(1/3)Ti_(2/3))O_(3)-xBaMg_(0.1)Ta_(0.9))O_(3)(x=0,0.02,0.04,0.06,0.08)relaxor ferroelectric ceramics were prepared by the conventional solid-state method and sintered in air at 1400°C for 2 h.SEM and XRD analyses were utilized to study the surface morphologies and the crystalline structures,respectively.The effects of BaMg_(0.1)Ta_(0.9))O_(3)on the phase transformation,dielectric and ferroelectric properties of Ba(Zr_(1/3)Ti_(2/3))O_(3)ceramics were also investigated.It is found that the average grain size of(1-x)Ba(Zr_(1/3)Ti_(2/3))O_(3)-xBaMg_(0.1)Ta_(0.9))O_(3)(BZT-BMT)perovskite single-phase ceramics decreases as the content of BaMg_(0.1)Ta_(0.9))O_(3)(BMT)increases.The relaxor ferroelectric behavior with diffuse phase transition and well-defined frequency dispersion of dielectric maximum temperature is found for the ceramic with increasing x values.0.98BZT-0.02BMT ceramic shows very good dielectric properties with the relative permittivity and the dielectric loss,measured at 100 k Hz as 6034 and 0.01399 respectively at room temperature.Both remnant polarization and coercive field decreased with increasing BMT content,indicating a transition from the ferroelectric phase to the paraelectric phase at room temperature.展开更多
Abstract： Lead-free piezoelectric ceramics of （1 - x） Bi0.5K0.5TiO3-BaTiO3 （BKT-BT） were fabricated by the solid state reaction method with normal sintering. The influence of BT addition on the crystal structure,...Abstract： Lead-free piezoelectric ceramics of （1 - x） Bi0.5K0.5TiO3-BaTiO3 （BKT-BT） were fabricated by the solid state reaction method with normal sintering. The influence of BT addition on the crystal structure, phase transition and dielectric properties was investigated. The crystal structure and ferroelectric phase transition were studied by XRD （X-ray diffraction） and dielectric measurements. The complete solid solution of BKT-BT was observed for all compositions. In XRD results, all compositions showed a single phase perovskite structure with tetragonal symmetry at room temperature. With increasing BT content, the separation between diffraction peaks corresponded to increasing tetragonality. The phase transition temperature of ferroelectric tetragonal-paraelectric cubic （Tc） decreased with increasing BT content. As the amount of BT concentration increased, the ceramic became denser, and almost no porosity was finally obtained.展开更多
Oxygen vacancy, a kind of native point defects in ferroelectric ceramics, usually causes an increase of the dielectric loss. Based on experimental observations, it is believed that all of the oxygen vacancies are an u...Oxygen vacancy, a kind of native point defects in ferroelectric ceramics, usually causes an increase of the dielectric loss. Based on experimental observations, it is believed that all of the oxygen vacancies are an unfavorable factor for energy saving. By using molecular dynamics simulations, we show that the increase of coercive and saturated electric fields is due to the difficulty to switch local polarization near an oxygen vacancy, and so that a ferroelectric device has to sustain the rising consumption of energy. The simulation results also uncover how oxygen vacancies influence ferroelectric properties.展开更多
BiFeO_3 (BFO) thin films with BaTiO_3 (BTO) or SrTiO_3 (STO) as buffer layer were epitaxially grown on SrRuO_3-covered SrTiO_3 substrates. X-ray diffraction measurements show that the BTO buffer causes tensile strain ...BiFeO_3 (BFO) thin films with BaTiO_3 (BTO) or SrTiO_3 (STO) as buffer layer were epitaxially grown on SrRuO_3-covered SrTiO_3 substrates. X-ray diffraction measurements show that the BTO buffer causes tensile strain in the BFO films, whereas the STO buffer causes compressive strain. Different ferroelectric domain structures caused by these two strain statuses are revealed by piezoelectric force microscopy. Electrical and magnetical measurements show that the tensile-strained BFO/BTO samples have reduced leakage current and large ferroelectric polarization and magnetization, compared with compressively strained BFO/STO. These results demonstrate that the electrical and magnetical properties of BFO thin films can be artificially modified by using a buffer layer.展开更多
基金sponsored by the National Demonstration Center for Experimental Materials Science and Engineering Education (Jiangsu University of Science and Technology, China)the Priority Academic Program Development (PAPD) of Jiangsu Higher Education Institutions, China
文摘The microstructure,dielectric and ferroelectric properties of(1-y)Ba(Zr0.1Ti0.9)O3-yBa(Zn1/3Nb2/3)O3(y=0-0.05)ceramics prepared by traditional solid state method were investigated by X-ray diffractometer,scanning electron microscope,electric parameter testing system and ferroelectric tester.It is found that the barium zirconate titanate based ceramics are single-phase perovskites as y increases up to 0.05 and their average grain size decreases with the increase of y.The permittivity maximumεr,max is suppressed from 8948 to 1611 at 1 kHz with increasing y,and the ferroelectric-paraelectric phase transition temperature Tm decreases from 93 to-89℃at 1 kHz as y increases.The composition-induced diffuse phase transition is enhanced with increasingy.The relaxor-like ferroelectric behavior with a strong frequency dispersion of Tm and permittivity at T<Tm accompanied by a strong diffuse phase transition is found for the system with high y value.The remnant polarization decreases with increasing y,while the coercive field decreases remarkably and then increases with the increase of y.
基金Project(60661001) supported by the National Natural Science Foundation of China
文摘To make the ferroelectric BaTiO3 possess ferromagnetism simultaneously,magnetic Fe was doped into BaTiO3 ceramics at doping levels up to 10%(molar fraction).Both tetragonal and hexagonal phases coexisted in the Fe-doped BaTiO3 ceramics except at 1% doping level.X-ray diffraction analysis indicated that higher doping level of Fe,higher sintering temperature and longer sintering time promoted the formation of hexagonal phases in Fe-doped BaTiO3 ceramics.Ferroelectricity was observed in all samples at room temperature,but it was greatly depressed by Fe doping.Except at doping level of 1%,room-temperature ferromagnetism was observed in the BaTiO3 ceramics.The dependence of the saturation magnetization and coercivities of the Fe-doped BaTiO3 ceramics on doping level was systematically studied.Both the saturation magnetization and magnetic coercivities were found to be dependent on the doping level as well as the fraction of the hexagonal phase in the ceramics.
基金fully sponsored by the National Demonstration Center for Experimental Materials Science and Engineering Education(Jiangsu University of Science and Technology,China)funded by the Priority Academic Program Development(PAPD)of Jiangsu Higher Education Institutions,China。
文摘The environmentally-friendly(1-x)Ba(Zr_(1/3)Ti_(2/3))O_(3)-xBaMg_(0.1)Ta_(0.9))O_(3)(x=0,0.02,0.04,0.06,0.08)relaxor ferroelectric ceramics were prepared by the conventional solid-state method and sintered in air at 1400°C for 2 h.SEM and XRD analyses were utilized to study the surface morphologies and the crystalline structures,respectively.The effects of BaMg_(0.1)Ta_(0.9))O_(3)on the phase transformation,dielectric and ferroelectric properties of Ba(Zr_(1/3)Ti_(2/3))O_(3)ceramics were also investigated.It is found that the average grain size of(1-x)Ba(Zr_(1/3)Ti_(2/3))O_(3)-xBaMg_(0.1)Ta_(0.9))O_(3)(BZT-BMT)perovskite single-phase ceramics decreases as the content of BaMg_(0.1)Ta_(0.9))O_(3)(BMT)increases.The relaxor ferroelectric behavior with diffuse phase transition and well-defined frequency dispersion of dielectric maximum temperature is found for the ceramic with increasing x values.0.98BZT-0.02BMT ceramic shows very good dielectric properties with the relative permittivity and the dielectric loss,measured at 100 k Hz as 6034 and 0.01399 respectively at room temperature.Both remnant polarization and coercive field decreased with increasing BMT content,indicating a transition from the ferroelectric phase to the paraelectric phase at room temperature.
文摘Abstract： Lead-free piezoelectric ceramics of （1 - x） Bi0.5K0.5TiO3-BaTiO3 （BKT-BT） were fabricated by the solid state reaction method with normal sintering. The influence of BT addition on the crystal structure, phase transition and dielectric properties was investigated. The crystal structure and ferroelectric phase transition were studied by XRD （X-ray diffraction） and dielectric measurements. The complete solid solution of BKT-BT was observed for all compositions. In XRD results, all compositions showed a single phase perovskite structure with tetragonal symmetry at room temperature. With increasing BT content, the separation between diffraction peaks corresponded to increasing tetragonality. The phase transition temperature of ferroelectric tetragonal-paraelectric cubic （Tc） decreased with increasing BT content. As the amount of BT concentration increased, the ceramic became denser, and almost no porosity was finally obtained.
基金the National Natural Science Foundation of China(Grant Nos.11172024 and 11232013)the National Key Basic Research Program of China(Grant No.2012CB937500)+3 种基金the Research Grant Council of the Hong Kong Special Administrative Region,China(Grant No.9042201(City U 11211015))resources provided by the Pawsey Supercomputing Centre with funding from the Australian Government and the Government of Western Australiathe LNMGrid of the State Key Laboratory of Nonlinear Mechanics and the Sc Grid of Supercomputing CenterComputer Network Information Center of the Chinese Academy of Sciences
文摘Oxygen vacancy, a kind of native point defects in ferroelectric ceramics, usually causes an increase of the dielectric loss. Based on experimental observations, it is believed that all of the oxygen vacancies are an unfavorable factor for energy saving. By using molecular dynamics simulations, we show that the increase of coercive and saturated electric fields is due to the difficulty to switch local polarization near an oxygen vacancy, and so that a ferroelectric device has to sustain the rising consumption of energy. The simulation results also uncover how oxygen vacancies influence ferroelectric properties.
基金supported by the National Key Basic Research Program of China (Grant Nos. 2014CB921002, and 2013CBA01703)the National Natural Science Foundation of China (Grant Nos. 11174355, 11674385, and 11574365)the Strategic Priority Research Program (B) of the Chinese Academy of Sciences (Grant No. XDB07030200)
文摘BiFeO_3 (BFO) thin films with BaTiO_3 (BTO) or SrTiO_3 (STO) as buffer layer were epitaxially grown on SrRuO_3-covered SrTiO_3 substrates. X-ray diffraction measurements show that the BTO buffer causes tensile strain in the BFO films, whereas the STO buffer causes compressive strain. Different ferroelectric domain structures caused by these two strain statuses are revealed by piezoelectric force microscopy. Electrical and magnetical measurements show that the tensile-strained BFO/BTO samples have reduced leakage current and large ferroelectric polarization and magnetization, compared with compressively strained BFO/STO. These results demonstrate that the electrical and magnetical properties of BFO thin films can be artificially modified by using a buffer layer.
