期刊文献+
共找到8篇文章
< 1 >
每页显示 20 50 100
镍铁液中三价铁的分析方法
1
作者 李双云 《上海电镀》 1990年第1期25-26,共2页
关键词 电镀 镍铁液 三价铁 分析法
下载PDF
镍铁镀液硼酸含量分析中的几个问题 被引量:1
2
作者 王宇清 《电镀与涂饰》 CAS CSCD 1989年第2期46-47,共2页
镍铁合金镀液是近年来发展较快的镀种之一,许多电镀厂家的镍铁镀液都是从原来的亮镍镀液转化过来.同样地,镍铁镀液中的硼酸含量分析也可以仿照亮镍镀液中的硼酸分析方法进行.笔者采用快速法之一,即用柠檬酸钠络合镍、用丙二醇和硼酸生... 镍铁合金镀液是近年来发展较快的镀种之一,许多电镀厂家的镍铁镀液都是从原来的亮镍镀液转化过来.同样地,镍铁镀液中的硼酸含量分析也可以仿照亮镍镀液中的硼酸分析方法进行.笔者采用快速法之一,即用柠檬酸钠络合镍、用丙二醇和硼酸生成络合酸、以酚酞为指示剂、用碱滴定的方法,经对照验证,总结以下几点,供同行参考:一、关于滴定终点的颜色亮镍镀液中硼酸分析的滴定颜色变化是由淡绿色变灰蓝色为终点.而在镍铁镀液中,由于铁离子的影响,颜色的变化是淡绿—草黄—黄中略见红色为终点. 展开更多
关键词 硼酸 硼酸含量分析 镍铁
下载PDF
镍铁电镀液一次严重故障的排除
3
作者 曾祥德 《电镀与涂饰》 CAS CSCD 1991年第4期72-74,共3页
故障情况电镀车间最近发生一次严重故障,造成停产半个月.故障出现在镍铁合金镀液.镀件是连杆(圆柱体工件φ70×760).由于受镀槽深度限制,这些连仟只能横镀不能竖镀,每槽两个挂具共镀10根.出现故障时,发现连镀两槽都是在每根连杆下... 故障情况电镀车间最近发生一次严重故障,造成停产半个月.故障出现在镍铁合金镀液.镀件是连杆(圆柱体工件φ70×760).由于受镀槽深度限制,这些连仟只能横镀不能竖镀,每槽两个挂具共镀10根.出现故障时,发现连镀两槽都是在每根连杆下部有一条宽约20mm的灰黑发绿、呈粉末状的疏松镀层,杆的两端镀层较厚,有结瘤现象,其余则镀层很薄,光泽性差,且发雾.用于轻擦镀层即脱落,露出一线很薄的黑色底层。 展开更多
关键词 电镀 镍铁电镀 故障 排除
下载PDF
化学镀Ni-Fe-P镀液中Ni^(2+)、Fe^(2+)的容量分析
4
作者 宁润娣 《电镀与环保》 CAS CSCD 2003年第3期36-37,共2页
研究了络合滴定法测定Ni Fe P化学镀液中Ni2 + 、Fe2 + 浓度的方法和影响滴定结果的因素。研究表明 ,对Ni2 + 进行滴定时 ,以三乙醇胺为掩蔽剂、紫脲酸铵为指示剂进行滴定 ,可以得到较准确的结果 ;对Fe2 + 进行滴定时 ,以酒石酸为掩蔽... 研究了络合滴定法测定Ni Fe P化学镀液中Ni2 + 、Fe2 + 浓度的方法和影响滴定结果的因素。研究表明 ,对Ni2 + 进行滴定时 ,以三乙醇胺为掩蔽剂、紫脲酸铵为指示剂进行滴定 ,可以得到较准确的结果 ;对Fe2 + 进行滴定时 ,以酒石酸为掩蔽剂、磺基水杨酸为指示剂进行滴定 。 展开更多
关键词 化学镀 络合滴定法 测定 Ni-Fe-P镀 镍铁磷镀 镍离子 铁离子 浓度
下载PDF
一次镍-铁镀液的故障处理
5
作者 陈自然 《材料保护》 CAS CSCD 北大核心 1993年第11期40-40,共1页
前一个时期,我厂一条手工电镀镍铁线,槽液已经有几个月时间不太正常,而且越镀越不好,已经停产。一、故障现象镀层不光亮,发雾,呈阴阳面,工件向上的一面呈灰白色;结晶粗糙,有毛刺;零件的深凹处无沉积镀层,高电流区则出现条纹,镀层脆裂;... 前一个时期,我厂一条手工电镀镍铁线,槽液已经有几个月时间不太正常,而且越镀越不好,已经停产。一、故障现象镀层不光亮,发雾,呈阴阳面,工件向上的一面呈灰白色;结晶粗糙,有毛刺;零件的深凹处无沉积镀层,高电流区则出现条纹,镀层脆裂;开动阴极移动上述故障更为严重。因此已经镀了镍铁合金的零件必须进行抛光才能镀铬。 展开更多
关键词 电镀 镍铁 故障处理
下载PDF
Preparation of ammonium jarosite from clinker digestion solution of nickel oxide ore roasted using(NH_4 )_2SO_4 被引量:4
6
作者 申晓毅 邵鸿媚 +1 位作者 王佳东 翟玉春 《Transactions of Nonferrous Metals Society of China》 SCIE EI CAS CSCD 2013年第11期3434-3439,共6页
To obtain the appropriate conditions for eliminating Fe3+from NiSO4 solution, the digestion solution of the clinker was used as raw material, which was obtained from roasting the nickel oxide ore with (NH4)2SO4. Th... To obtain the appropriate conditions for eliminating Fe3+from NiSO4 solution, the digestion solution of the clinker was used as raw material, which was obtained from roasting the nickel oxide ore with (NH4)2SO4. The ammonium jarosite was successfully synthesized from the solution with analytic grade NH4HCO3. The effects of reaction temperature, reaction time, end pH value of reaction on the removal rate of iron were investigated, and the effect of the initial concentration of Fe3+was also discussed. All of those factors had significant effects on the removal rate of Fe3+, among which the reaction temperature was the most prominent. The appropriate reaction conditions were concluded as follows: reaction temperature 95 ℃ reaction time 3.5 h, end pH value of reaction 2.5 at initial concentration of Fe3+19.36 g/L. The physical aspect of (NH4)2Fe6(SO4)4(OH)12 was cluster figure composed of sheet or prismatic particles with smooth surface. 展开更多
关键词 nickel oxide ore ammonium jarosite influence factor digestion solution
下载PDF
Catalyses of Metals and Their Sulfides in Selective Hydrogenation of 9,10-Diphenylanthracene 被引量:2
7
作者 周仕禄 倪中海 +2 位作者 袁新华 宗志敏 魏贤勇 《Journal of China University of Mining and Technology》 2001年第1期80-82,共3页
Catalytic hydrogenation and hydrocracking of 9,10 diphenylanthracene (9,10 DPA) , used as a coal related model compound, was investigated at a relatively low temperature. The results show that the Fe and Ni mainly cat... Catalytic hydrogenation and hydrocracking of 9,10 diphenylanthracene (9,10 DPA) , used as a coal related model compound, was investigated at a relatively low temperature. The results show that the Fe and Ni mainly catalyze non ipso hydrogenation of 9,10 DPA without sulfur, but selectively promote ipso hydrogenation of 9,10 DPA in the presence of sulfur. 展开更多
关键词 CATALYSIS METAL SULFIDE HYDROGENATION 9 10-diphenylanthracene
下载PDF
Nitric acid pressure leaching of limonitic laterite ores:Regeneration of HNO3 and simultaneous synthesis of fibrous CaSO4·2H2O by-products 被引量:9
8
作者 SHAO Shuang MA Bao-zhong +3 位作者 WANG Xin ZHANG Wen-juan CHEN Yong-qiang WANG Cheng-yan 《Journal of Central South University》 SCIE EI CAS CSCD 2020年第11期3249-3258,共10页
An innovative technology,nitric acid pressure leaching of limonitic laterite ores,was proposed by our research team.The HNO3 regeneration is considerable significance for the improvement of the proposed technology and... An innovative technology,nitric acid pressure leaching of limonitic laterite ores,was proposed by our research team.The HNO3 regeneration is considerable significance for the improvement of the proposed technology and its commercial application,but it has not been systematically investigated.Herein,regenerating HNO3 from Ca(NO3)2 solution with low-cost H2SO4,and simultaneous synthesis of fibrous CaSO4·2H2O by-products were studied.As a theoretical basis,the solubility of CaSO4·2H2O in HNO3 medium is studied.It is concluded that the solubility of CaSO4·2H2O increases with increasing temperature or increasing HNO3 concentration,which has considerable guiding significance for the subsequent experimental research and analysis.Then,the effects of various factors on the residual Ca^2+ concentration of filtrate,the regenerated HNO3 concentration and the morphology of synthesized products are investigated using ICP-AES and SEM.And the effect mechanism is also analyzed.The results indicate the regenerated HNO3 concentration reaches 116 g/L with the residual Ca^2+ concentration being 9.7 g/L at the optimum conditions.Moreover,fibrous CaSO4·2H2O by-products with high aspect ratios(length,406.32μm;diameter,14.71μm;aspect ratio,27.62)can be simultaneously synthesized. 展开更多
关键词 limonitic laterite ores Ca(NO3)2 solution HNO3 regeneration CaSO4·2H2O by-products SOLUBILITY
下载PDF
上一页 1 下一页 到第
使用帮助 返回顶部