Travel time function for basic link considering signal control in network traffic model

In order to describe the travel time of signalcontrolled roads, a travel time model for urban basic roads based on the cumulative curve is proposed. First, the traffic wave method is used to analyze the formation and dispersion of the vehicle queue. Cumulative curves for road entrances and exits are established. Based on the cumulative curves, the travel time of the one-lane road under stable flow input is derived. And then, the multi-lane road is decomposed into a series of single-lane links based on its topological characteristics. Hence, the travel time function for the basic road is obtained. The travel time is a function of road length, flow and control parameters. Numerical analyses show that the travel time depends on the supply-demand condition, and it has high sensitivity during peak hours.

6个购买鞋子的窍门

【窍门１】中午买鞋人体起床后经过一上午的外部活动和体内血液循环，到中午时脚部比晨起时略有肿胀，到晚上时肿胀最甚，即人的脚掌，早晨最短最小，晚上最长最宽。因此，中午购买鞋子时，只要大小合适，脚面能完全舒开，脚尖不顶不挤，且略有宽余即可使日后正式穿着时舒...

Signal timing optimization model based on dual-ring phase scheme for roundabout

A signal optimization model for roundabout was control concept were used to eliminate the conflict points proposed based on dual-ring scheme and two stop lines for left turns and weaving sections at a roundabout. A cycle length minimization problem was considered to generate optimal signal timings for roundabout, and a set of constraints to ensure feasibility and safety of the resulting optimal signal settings were proposed. Extensive experimental analyses in comparison with signalized intersection reveal that the proposed model is quite promising for application in design of roundabout signals, and the minimum cycle length can decrease from 186 s to 79 s while the capacity increases from 8 682 pcu/h to 9 011 pcu/h under high demand scenario. Sensitivity analysis with respect to the system performance show that the lane assignment plan, number of circulatory lanes and left turn ratio are three critical factors which have dominate impacts on performance of signalized roundabout

Impact of Channel Length and Width for Charge Transportation of Graphene Field Effect Transistor

The effect of channel length and width on the large and small-signal parameters of the graphene field effect transistor have been explored using an analytical approach.In the case of faster saturation as well as extremely high transit frequency,the graphene field effect transistor shows outstanding performance.From the transfer curve,it is observed that there is a positive shift of Dirac point from the voltage of 0.15 V to 0.35 V because of reducing channel length from 440 nm to 20 nm and this curve depicts that graphene shows ambipolar behavior.Besides,it is found that because of widening channel the drain current increases and the maximum current is found approximately 2.4 mA and 6 mA for channel width 2μm and 5μm respectively.Furthermore,an approximate symmetrical capacitance-voltage(C-V)characteristic of the graphene field effect transistor is obtained and the capacitance reduces when the channel length decreases but the capacitance can be increased by raising the channel width.In addition,a high transconductance,that demands high-speed radio frequency(RF)applications,of 6.4 mS at channel length 20 nm and 4.45 mS at channel width 5μm along with a high transit frequency of 3.95 THz have been found that demands high-speed radio frequency applications.

Effect of Flats Speed on Card Sliver Quality

The effect of flats speed,especially higher flats speed,on card sliver quality was studied.Card sliver produced at seven flats speeds was tested with Uster AFIS.Test results show that over-high flats speed is not beneficial to removing impurities and neps of card sliver.The flats speed from 450 to 550 mm/min is the best for removing impurity;while a speed of 450 or 650 mm/min is the best for removing neps of card sliver.The 1 050 mm/min flats speed is the best for removing short fibers.Accordingly,the flats speed of 450 mm/min is the most advantageous to improve the comprehensive quality of card sliver.It is also found that installing back-web-cleaner is very helpful to remove neps.It is also favorable to reduce short fibers,thus increasing the average length.But it is not helpful to reduce impurities in the sliver.

Effects of internal waves on signal temporal correlation length in the South China Sea

We simulated the temporal correlation of sound transmission using a two-dimensional advective frozen-ocean model with temperature data from a temperature sensor array on a propagation path in the South China Sea （SCS） Experiment 2009, and investigated the relationships of temporal correlation length, source-receiver range, and maximal sound speed fluctuation mainly caused by the solitary internal waves. We found that the temporal correlation length is -h2-power dependent on source-receiver range and -0.9-power dependent on maximal sound speed fluctuation. The empirical relationship is deduced from one-day environmental measurements in a limited area, needing more works and verification in the future with more acoustic data. But the relationship is useful in many applications in the area of SCS Experiment 2009.

A fuzzy adaptive smoothing approach to robust endpoint detection based on MDL using sub-band speech

To develop a more robust endpoint detection algorithm, this paper first proposes a fuzzy adaptive smoothing algorithm. The general idea underlying adaptive smoothing is to adapt the short-term sub-band mean of the amplitude to the local attributes of speech on the basis of discontinuity measures. The adaptive smoothing algorithm in this paper utilizes a scale-space framework through the minimal description length （MDL）. We recommend using the fuzzy muhi-attribute decision making approach to select the proper sub-bands where the word boundary can be more reliably detected. The process and simulation of the fuzzy adaptive smoothing algorithm are given. The parameters utilize the mean amplitude of the audible frequency range （300 -3 700 Hz） and the sub-band mean of the amplitude （16 band filter-bank）. We selected the audible band energy because of its usefulness in detecting high-energy regions and making the distinction between speech and noise. Otherwise, the fuzzy adaptive smoothing algorithm is processed in sub-band speech to utilize the full range of frequency information.

New key-stream generation scheme based on Henon chaotic system

As known to all that Henon chaotic system is not appropriate for generating the key-streams because it has non-uniformly distributed output signal, a new key-stream generation scheme based on Henon chaotic system is presented. In order to get the key-streams with good statistics and long enough cycle length, a specific method for dividing the enon attractor into numerous non-overlapping sub-regions, and a new one-to-one mapping strategy between the divided sub-regions and elements of dynamically generated matrix consisting of O＇s and l＇s are proposed. Experimental results demonstrate that the generated key-streams are with long enough cycle length and very sensitive to the initial values and secret keys. For example, key-streams with the cycle length of 10^32 can easily be obtained. Moreover, even if the fluctuation to the initial values or secret keys is as small as 10^- 14 uncorrelated key-streams will be generated. Experimental results also demonstrate that the generated key-streams have good randomness and they can pass all the standard criteria specified in FIPS PUB 140^-2 with no less than 98%.