ZrO2-mullite nano-ceramics were fabricated by in-situ controlled crystallizing from SiO2-Al2O3-ZrO2 amorphous bulk. The thermal transformation sequences of the SiO2-Al2O3-ZrO2 amorphous bulk were investigated by X-ray...ZrO2-mullite nano-ceramics were fabricated by in-situ controlled crystallizing from SiO2-Al2O3-ZrO2 amorphous bulk. The thermal transformation sequences of the SiO2-Al2O3-ZrO2 amorphous bulk were investigated by X-ray diffraction, infrared spectrum, scanning electron microscope and differential scanning calorimetric. And the mechanical properties of the nano-ceramics were studied. The results show that the bulks are still in amorphous state at 900 ℃ and the t-ZrO2 forms at about 950 ℃ with a faint spinel-like phase which changes into mullite on further heating. ZrO2 and mullite become major phases at 1 100 ℃ and an amount of m-ZrO2 occur at the same time. The sample heated at 950 ℃ for 2 h and then at 1 100 ℃ for 1 h shows very dense and homogenous microstructure with ball-like grains in size of 20-50 nm. With the increase of crystallization temperature up to 1 350 ℃, the grains grow quickly and some grow into lath-shaped grains with major diameter of 5 μm. After two-step treatment the highest micro-hardness, flexural strength and fracture toughness of the samples are 13.72 GPa, 520 MPa and 5.13 MPa·m1/2, respectively.展开更多
Ultrasonic field was applied in the treatment of oil emulsification wastewater by ZrO2 ceramic mem-brane. The permeate flux, rejection ratio in the filtration process and recovery ratio of flux in the membrane cleanin...Ultrasonic field was applied in the treatment of oil emulsification wastewater by ZrO2 ceramic mem-brane. The permeate flux, rejection ratio in the filtration process and recovery ratio of flux in the membrane cleaning process were measured. Great improvement in the permeate flux and rejection ratio have been observed for the membrane process enhanced by the ultrasonic field. The permeate flux of water through the membrane was about 210L.m^-2.h^-1 and the oil rejection ratio was over 99.9% under the optimal ultrasonic treatment conditions, which were 8W of ultrasonic power, 7cm of ultrasonic probe length introduced into the membrane channel and the same ultrasonic radiation direction as the wastewater flow. The resistance of the membrane process was compared between the cases with and without ultrasound, and the total resistance was reduced 68% by the use of ultrasound, Four methods including water cleaning, water cleaning under sonication, chemical cleaning and chemical cleaning under sonication were used to recover membrane flux. It was found that the flux recovery ratio increased with the increase of ultrasonic cleaning power. In addition, the use of chemical agents combining with ultrasonic irradiation showed a synergistic effect, which resulted in the highest cleaning efficiency and the shorter cleaning time.展开更多
The hydrophobically modi fied ceramic membranes have great potential for energy-ef ficient membrane distillation.In this work,flat-sheet ceramic membranes with a superhydrophobic surface were fabricated by grafting 1H...The hydrophobically modi fied ceramic membranes have great potential for energy-ef ficient membrane distillation.In this work,flat-sheet ceramic membranes with a superhydrophobic surface were fabricated by grafting 1H,1H,2H,2H-per fluorooctyltrichlorosilane or 1H,1H,2H,2H-per fluorodecyltriethoxysilane and followed by ultraviolet irradiation.The surface water contact angle was improved from 46° of original ceramic membrane to 159°,which exhibited a stable and excellent superhydrophobic effect.The modi fied membranes showed a high flux of 27.28 kg·m^(-2)·h^(-1) and simultaneously maintained an excellent retention rate of 99.99%,when used in vacuum membrane distillation process for treatment of a 1 wt% NaCl(75 °C) aqueous solution.These results suggested that superhydrophobic modi fication of ceramic surface is a facile and cost-effective way to achieve higher membrane distillation performance.The superhydrophobically-modi fied ceramic membrane with an excellent desalination capacity would show considerable potential in practical membrane distillation utilizations.展开更多
Stabilized ZnTiO4 was prepared by doping magnesium oxide through traditional solid state reaction. The experimental results indicate that zinc titanate crystals doped with magnesium oxide grow well and the decompositi...Stabilized ZnTiO4 was prepared by doping magnesium oxide through traditional solid state reaction. The experimental results indicate that zinc titanate crystals doped with magnesium oxide grow well and the decomposition into Zn2TiO4 and TiO2 is restrained through traditional solid state reaction, By adjusting molar ratio of MgO, better properties can be obtained The dielectric properties of the ceramics doped with 30% MgO（ molar percentage） sintered at 1060℃ are as follows：the value of quality factor is greater than 20000（6.5 GHz ）, the temperature coefficient of resonance frequency is about 2 ± 10^-6 /℃,the dielectric constant ranges from 180 to 22.Besides,it is proved that heat treatment can optimize microstructure and the value of quality factor, which increases from 23833.93 to 47584.00 after 2h of heat treatment at 1040℃.展开更多
基金Project(2003AA332040) supported by the National High Technology Research and Development Program of China
文摘ZrO2-mullite nano-ceramics were fabricated by in-situ controlled crystallizing from SiO2-Al2O3-ZrO2 amorphous bulk. The thermal transformation sequences of the SiO2-Al2O3-ZrO2 amorphous bulk were investigated by X-ray diffraction, infrared spectrum, scanning electron microscope and differential scanning calorimetric. And the mechanical properties of the nano-ceramics were studied. The results show that the bulks are still in amorphous state at 900 ℃ and the t-ZrO2 forms at about 950 ℃ with a faint spinel-like phase which changes into mullite on further heating. ZrO2 and mullite become major phases at 1 100 ℃ and an amount of m-ZrO2 occur at the same time. The sample heated at 950 ℃ for 2 h and then at 1 100 ℃ for 1 h shows very dense and homogenous microstructure with ball-like grains in size of 20-50 nm. With the increase of crystallization temperature up to 1 350 ℃, the grains grow quickly and some grow into lath-shaped grains with major diameter of 5 μm. After two-step treatment the highest micro-hardness, flexural strength and fracture toughness of the samples are 13.72 GPa, 520 MPa and 5.13 MPa·m1/2, respectively.
基金Supported by the Special Funds for Major State Basic Research Program of China （973 Program, No.2003CB615707） and the National Natural Science Foundation of China （No.20436030）.
文摘Ultrasonic field was applied in the treatment of oil emulsification wastewater by ZrO2 ceramic mem-brane. The permeate flux, rejection ratio in the filtration process and recovery ratio of flux in the membrane cleaning process were measured. Great improvement in the permeate flux and rejection ratio have been observed for the membrane process enhanced by the ultrasonic field. The permeate flux of water through the membrane was about 210L.m^-2.h^-1 and the oil rejection ratio was over 99.9% under the optimal ultrasonic treatment conditions, which were 8W of ultrasonic power, 7cm of ultrasonic probe length introduced into the membrane channel and the same ultrasonic radiation direction as the wastewater flow. The resistance of the membrane process was compared between the cases with and without ultrasound, and the total resistance was reduced 68% by the use of ultrasound, Four methods including water cleaning, water cleaning under sonication, chemical cleaning and chemical cleaning under sonication were used to recover membrane flux. It was found that the flux recovery ratio increased with the increase of ultrasonic cleaning power. In addition, the use of chemical agents combining with ultrasonic irradiation showed a synergistic effect, which resulted in the highest cleaning efficiency and the shorter cleaning time.
基金Supported by the National Natural Science Foundation of China(51473013)
文摘The hydrophobically modi fied ceramic membranes have great potential for energy-ef ficient membrane distillation.In this work,flat-sheet ceramic membranes with a superhydrophobic surface were fabricated by grafting 1H,1H,2H,2H-per fluorooctyltrichlorosilane or 1H,1H,2H,2H-per fluorodecyltriethoxysilane and followed by ultraviolet irradiation.The surface water contact angle was improved from 46° of original ceramic membrane to 159°,which exhibited a stable and excellent superhydrophobic effect.The modi fied membranes showed a high flux of 27.28 kg·m^(-2)·h^(-1) and simultaneously maintained an excellent retention rate of 99.99%,when used in vacuum membrane distillation process for treatment of a 1 wt% NaCl(75 °C) aqueous solution.These results suggested that superhydrophobic modi fication of ceramic surface is a facile and cost-effective way to achieve higher membrane distillation performance.The superhydrophobically-modi fied ceramic membrane with an excellent desalination capacity would show considerable potential in practical membrane distillation utilizations.
基金SUPPORTED BY NATIONAL NATURAL SCIENCE FOUNDATION OF CHINA( NO. 50172035).
文摘Stabilized ZnTiO4 was prepared by doping magnesium oxide through traditional solid state reaction. The experimental results indicate that zinc titanate crystals doped with magnesium oxide grow well and the decomposition into Zn2TiO4 and TiO2 is restrained through traditional solid state reaction, By adjusting molar ratio of MgO, better properties can be obtained The dielectric properties of the ceramics doped with 30% MgO（ molar percentage） sintered at 1060℃ are as follows：the value of quality factor is greater than 20000（6.5 GHz ）, the temperature coefficient of resonance frequency is about 2 ± 10^-6 /℃,the dielectric constant ranges from 180 to 22.Besides,it is proved that heat treatment can optimize microstructure and the value of quality factor, which increases from 23833.93 to 47584.00 after 2h of heat treatment at 1040℃.
