Since the traditional Miner rule ignores the influence of the load sequence on the fatigue life, the fuzzy rules are used to analyze the fuzziness of the fatigue damage caused by the stress nearby the fatigue limit un...Since the traditional Miner rule ignores the influence of the load sequence on the fatigue life, the fuzzy rules are used to analyze the fuzziness of the fatigue damage caused by the stress nearby the fatigue limit under different load sequences. The improved fuzzy Miner rule can reflect the influence of the load sequence on the fatigue life. Results of the example show that the prediction error can be reduced from 61.6% to 21.7%.展开更多
Ni/Al2O3 catalysts were derived from spinel NiAl2O4 with different Ni content ((2.5, 5 and 7.5) wt%). The catalysts were obtained by H-2 reduction and were investigated for the low-temperature hydrogenation of maleic ...Ni/Al2O3 catalysts were derived from spinel NiAl2O4 with different Ni content ((2.5, 5 and 7.5) wt%). The catalysts were obtained by H-2 reduction and were investigated for the low-temperature hydrogenation of maleic anhydride (MA) to produce succinic anhydride (SA). The characterization results showed that Ni-0 active sites were mainly derived during the H2 reduction from spinel NiAl2O4 Among the catalysts studied, employing the optimum preparation and reaction conditions with Ni(5%)/Al2O3 yielded the highest catalytic performance. A near-100% conversion of MA and similar to 90% selectivity to SA were achieved at 120 degrees C and 0.5 MPa of H-2 with a weighted hourly space velocity (MA) of 2 h(-1). (C) 2017, Dalian Institute of Chemical Physics, Chinese Academy of Sciences. Published by Elsevier B.V. All rights reserved.展开更多
Welding sequence has a significant effect on distortion pattern of large orthogonally stiffened panels normally used in ships and offshore structures. These deformations adversely affect the subsequent fitup and align...Welding sequence has a significant effect on distortion pattern of large orthogonally stiffened panels normally used in ships and offshore structures. These deformations adversely affect the subsequent fitup and alignment of the adjacent panels. It may also result in loss of structural integrity. These panels primarily suffer from angular and buckling distortions. The extent of distortion depends on several parameters such as welding speed, plate thickness, welding current, voltage, restraints applied to the job while welding, thermal history as well as sequence of welding. Numerical modeling of welding and experimental validation of the FE model has been carried out for estimation of thermal history and resulting distortions. In the present work an FE model has been developed for studying the effect of welding sequence on the distortion pattern and its magnitude in fabrication of orthogonally stiffened plate panels.展开更多
We report the successful treatment of multiple lung metastases after hepatic resection for hepatocellular carcinoma (HCC) with combined docetaxel, cisplatin (CDDP), and enteric-coated tegafur/uracil (UFT-E). A 68-year...We report the successful treatment of multiple lung metastases after hepatic resection for hepatocellular carcinoma (HCC) with combined docetaxel, cisplatin (CDDP), and enteric-coated tegafur/uracil (UFT-E). A 68-year-old man was diagnosed with multiple lung metastases of HCC 7 mo after partial hepatectomy for HCC. Oral UFT-E was given daily and docetaxel and CDDP were given intra-arterially (administered just before the bronchial arteries) every 2 wk via a subcutaneous injection port. One month after starting chemotherapy, levels of tumor marker, protein induced by vitamin K absence(PIVKA--), decreased rapidly,and after a further month, chest X-ray and computed tomography revealed the complete disappearance of multiple liver metastases. Two years after the combined chemotherapy, HCC recurred in the liver and was treated but no pulmonary recurrence occurred. In the absence of a standardized highly effective therapy, this combined chemotherapy with docetaxel, CDDP and UFT-E may be an attractive option for multiple lung metastases of HCC.展开更多
Eight concrete-filled steel tubular(CFT) columns were tested subjected to cyclic loading under constant axial load. Experimental parameters included axial compression ratio, loading sequences, and strength of concrete...Eight concrete-filled steel tubular(CFT) columns were tested subjected to cyclic loading under constant axial load. Experimental parameters included axial compression ratio, loading sequences, and strength of concrete and steel. The seismic performance of CFT columns and failure modes were analyzed. The test results show that different axial load ratios and loading sequences have effects on the load carrying capacity, ductility and energy dissipation capacity of CFT columns, as well as the failure modes of the CFT columns. The failure pattern can be categorized into two types: local buckling failure of steel tube in compression zone, and low cycle fatigue tearing rupture failure of steel tube. The seismic behavior was evaluated through the energy index obtained from each cycle.展开更多
基金the National Natural Science Foundation of China(60472118)~~
文摘Since the traditional Miner rule ignores the influence of the load sequence on the fatigue life, the fuzzy rules are used to analyze the fuzziness of the fatigue damage caused by the stress nearby the fatigue limit under different load sequences. The improved fuzzy Miner rule can reflect the influence of the load sequence on the fatigue life. Results of the example show that the prediction error can be reduced from 61.6% to 21.7%.
基金supported by the National Natural Science Foundation of China(21173050,21371035)SINOPEC(X514005)~~
文摘Ni/Al2O3 catalysts were derived from spinel NiAl2O4 with different Ni content ((2.5, 5 and 7.5) wt%). The catalysts were obtained by H-2 reduction and were investigated for the low-temperature hydrogenation of maleic anhydride (MA) to produce succinic anhydride (SA). The characterization results showed that Ni-0 active sites were mainly derived during the H2 reduction from spinel NiAl2O4 Among the catalysts studied, employing the optimum preparation and reaction conditions with Ni(5%)/Al2O3 yielded the highest catalytic performance. A near-100% conversion of MA and similar to 90% selectivity to SA were achieved at 120 degrees C and 0.5 MPa of H-2 with a weighted hourly space velocity (MA) of 2 h(-1). (C) 2017, Dalian Institute of Chemical Physics, Chinese Academy of Sciences. Published by Elsevier B.V. All rights reserved.
文摘Welding sequence has a significant effect on distortion pattern of large orthogonally stiffened panels normally used in ships and offshore structures. These deformations adversely affect the subsequent fitup and alignment of the adjacent panels. It may also result in loss of structural integrity. These panels primarily suffer from angular and buckling distortions. The extent of distortion depends on several parameters such as welding speed, plate thickness, welding current, voltage, restraints applied to the job while welding, thermal history as well as sequence of welding. Numerical modeling of welding and experimental validation of the FE model has been carried out for estimation of thermal history and resulting distortions. In the present work an FE model has been developed for studying the effect of welding sequence on the distortion pattern and its magnitude in fabrication of orthogonally stiffened plate panels.
文摘We report the successful treatment of multiple lung metastases after hepatic resection for hepatocellular carcinoma (HCC) with combined docetaxel, cisplatin (CDDP), and enteric-coated tegafur/uracil (UFT-E). A 68-year-old man was diagnosed with multiple lung metastases of HCC 7 mo after partial hepatectomy for HCC. Oral UFT-E was given daily and docetaxel and CDDP were given intra-arterially (administered just before the bronchial arteries) every 2 wk via a subcutaneous injection port. One month after starting chemotherapy, levels of tumor marker, protein induced by vitamin K absence(PIVKA--), decreased rapidly,and after a further month, chest X-ray and computed tomography revealed the complete disappearance of multiple liver metastases. Two years after the combined chemotherapy, HCC recurred in the liver and was treated but no pulmonary recurrence occurred. In the absence of a standardized highly effective therapy, this combined chemotherapy with docetaxel, CDDP and UFT-E may be an attractive option for multiple lung metastases of HCC.
基金Projects(51178174,51308201)supported by the National Natural Science Foundation of China
文摘Eight concrete-filled steel tubular(CFT) columns were tested subjected to cyclic loading under constant axial load. Experimental parameters included axial compression ratio, loading sequences, and strength of concrete and steel. The seismic performance of CFT columns and failure modes were analyzed. The test results show that different axial load ratios and loading sequences have effects on the load carrying capacity, ductility and energy dissipation capacity of CFT columns, as well as the failure modes of the CFT columns. The failure pattern can be categorized into two types: local buckling failure of steel tube in compression zone, and low cycle fatigue tearing rupture failure of steel tube. The seismic behavior was evaluated through the energy index obtained from each cycle.
