期刊文献+
共找到5篇文章
< 1 >
每页显示 20 50 100
300MW循环流化床锅炉机组床温特性及调整 被引量:13
1
作者 龚鹏 赵凯 +1 位作者 向俊 袁建丽 《中国电力》 CSCD 北大核心 2011年第3期47-51,共5页
床温控制是循环流化床锅炉燃烧调整的重要内容。对东方锅炉(集团)股份有限公司自主型300 MWCFB锅炉的床温控制方法进行了研究;分别从启动、带负荷、额定负荷等工况对床温特性及控制方法进行了试验分析。试验结果表明:启动过程中通过调... 床温控制是循环流化床锅炉燃烧调整的重要内容。对东方锅炉(集团)股份有限公司自主型300 MWCFB锅炉的床温控制方法进行了研究;分别从启动、带负荷、额定负荷等工况对床温特性及控制方法进行了试验分析。试验结果表明:启动过程中通过调节一次风量、油枪出力以及点动布煤来控制床温;带负荷过程中通过调节与负荷对应的风量和煤量对床温进行控制;额定负荷下通过改变给煤分布对床温进行控制;稳定工况下床温调整方法有限,通过调整一、二次风量比例可调整炉内燃烧份额,增加一次风量,床温下降;降低一次风量,床温上升,但调整幅度有限。 展开更多
关键词 循环流化床 床温特性 调整方法 一、二次风风量比例
下载PDF
秸秆直燃锅炉燃烧数值模拟 被引量:3
2
作者 商宇薇 吴新 +2 位作者 吴凯 王军龙 赵长遂 《太阳能学报》 EI CAS CSCD 北大核心 2014年第7期1210-1217,共8页
对某75 t/h秸秆层燃锅炉进行数值模拟并用现场实测数据加以验证。计算结果与实测结果基本吻合,较好地反映出实际炉排炉稻杆层燃特性。通过对炉排炉一次风各风室比例的调整计算表明,一次风风量比例对床层稻杆的燃烧具有重要影响。针对该... 对某75 t/h秸秆层燃锅炉进行数值模拟并用现场实测数据加以验证。计算结果与实测结果基本吻合,较好地反映出实际炉排炉稻杆层燃特性。通过对炉排炉一次风各风室比例的调整计算表明,一次风风量比例对床层稻杆的燃烧具有重要影响。针对该模型和设计燃料,当一次风4个风室风量比例为0.22∶0.32∶0.34∶0.12时运行综合效果最佳。在保证燃料水分析出段和挥发分析出燃烧段所需风量时,适当增加焦炭燃烧段的供风量有利于缩短燃烧时间,降低底灰含碳量。 展开更多
关键词 秸秆层燃锅炉 数值模拟 燃烧特性 一次风风量比例
下载PDF
基于CFD除霜风道结构分析及优化设计 被引量:4
3
作者 董小杏 《机械》 2018年第12期26-28,32,共4页
采用了CFD方法,并进行网格划分、边界条件的设置。进行了除霜风道出口风量比例分析、除霜风道内壁表面压强分布情况分析、风道内部流场速度流线分析以及风道内部速度矢量图分析。从除霜风道风量分配来看,侧后视镜两出口流量占风道总风量... 采用了CFD方法,并进行网格划分、边界条件的设置。进行了除霜风道出口风量比例分析、除霜风道内壁表面压强分布情况分析、风道内部流场速度流线分析以及风道内部速度矢量图分析。从除霜风道风量分配来看,侧后视镜两出口流量占风道总风量的24.38%,风量合理。从除霜风道速度矢量图可以看出,出风口2、出风口3出口平面风量分配不均,影响前挡玻璃的除霜效果。建议在除霜风管内部增加导流板长度,使得出口平面的风量分布均匀。 展开更多
关键词 除霜风道 CFD方法 风量比例 压强分布
下载PDF
上邻近保护层开采Y型通风采空区瓦斯分布规律及控制——平煤六矿戊_(8)-32010工作面案例研究 被引量:1
4
作者 薛俊华 马骞 +2 位作者 李延河 李洪彪 袁占栋 《西安科技大学学报》 CAS 北大核心 2021年第1期15-22,共8页
为掌握上邻近保护层开采时Y型通风工作面采空区的瓦斯分布规律,并控制采空区的瓦斯涌出,文中首先针对平煤六矿戊_(8)-32010工作面建立了采空区瓦斯涌出理论模型,依据现场情况设置瓦斯涌出条件并设置了机巷风量与风巷风量配比分别为1∶3,... 为掌握上邻近保护层开采时Y型通风工作面采空区的瓦斯分布规律,并控制采空区的瓦斯涌出,文中首先针对平煤六矿戊_(8)-32010工作面建立了采空区瓦斯涌出理论模型,依据现场情况设置瓦斯涌出条件并设置了机巷风量与风巷风量配比分别为1∶3,1∶2和1∶1.5时的入口风速,建立了瓦斯-空气混合气体在采空区里运移的方程组,利用FLUENT软件进行了这3种风量配比条件下的采空区瓦斯分布规律的数值试验,将此结果与现场工业性试验结果进行了对比分析,确定了适合该工作面的风量分配,最后利用数值模拟分析了留巷钻孔法的抽采效果。结果表明:越往Y型通风采空区以深,瓦斯浓度越高,且采空区尾部风巷侧体积分数高于尾部留巷侧;风巷风量越大,工作面瓦斯浓度越小,风巷风量越小,工作面和留巷瓦斯浓度越大;在留巷向采空区尾部施工抽采钻孔可以实现瓦斯的高效高浓抽采。 展开更多
关键词 安全科学与工程 瓦斯分布规律 FLUENT数值模型 上邻近保护层开采 风量分配比例
下载PDF
Judgment of Aroma Types of Middle and Upper Flue-cured Tobacco Leaves Based on Stepwise Discriminant Analysis
5
作者 詹军 周芳芳 +5 位作者 董石飞 饶智 朱海滨 资文华 蒋美红 罗华元 《Agricultural Science & Technology》 CAS 2014年第9期1550-1557,共8页
[Objective] The aim of this study was to establish mathematical models for judging the aroma types of middle and upper flue-cured tobacco leaves according to the contents and proportions of aroma compositions. [Method... [Objective] The aim of this study was to establish mathematical models for judging the aroma types of middle and upper flue-cured tobacco leaves according to the contents and proportions of aroma compositions. [Method] The aroma types of tobacco leaves were judged based on stepwise discriminant analysis, using 63 C3F and 65 B2F tobacco leaf samples from 13 tobacco producing regions in 11 provinces of China (Huili in Sichuan, Baokang in Hubei, Wulong in Chongqing, Lu- oyang in Henan, Zhucheng in Shandong, Wuyi Mountain in Fujian, Malong in Yun- nan, Chuxiong in Yunnan, Bijie in Guizhou, Liuyang in Hunan, Suiyang in Guizhou, Kaiyuan in Liaoning, Nanxiong in Guangdong) as calibration samples, and 67 aroma components as indices. And the Fisher discriminant functions were verified using 21 C3F and 19 B2F tobacco leaf samples. [Result] Variation coefficients of the propor- tions were lower than that of contents of most aroma components in middle and upper leaves of the samples, indicating that the proportions were more stable than contents of aroma components. The proportions of benzyl alcohol, solanone, β-dam- ascone, neophytadiene, farnesylacetone A, palmitic acid, thunbergol, methyl linole- nate and cembratriene-diol were all over 1% in both middle and upper leaves, al- though the dominant aroma components of the same aroma type varied between middle and upper leaves. Moreover, 11, 18, 7 and 11 aroma components were re- spectively introduced into the Fisher discriminant functions established based on the contents and proportions of middle and upper flue-cured tobacco leaves, which ex- hibited accuracy rates of 91.7%, 100%, 91.7% and 91.7% in the judgments of other tobacco leaf samples. The results revealed that the components those determined aroma types in middle leaves were obviously more than in upper leaves. In middle leaves, the accuracy rates of aroma type judgment could be improved by using the proportions rather than the contents of aroma components as indices. However, the functions based on the proportions and the contents of aroma components in upper leaves gave close accuracy rates. [Conclusion] The results of the study will provide references for identifying aroma types of flue-cured tobacco leaves in future work. 展开更多
关键词 Flue-cured tobacco leaves Middle leaves Upper leaves Aroma com- ponents Content PROPORTION Aroma type Discriminant analysis
下载PDF
上一页 1 下一页 到第
使用帮助 返回顶部