An accurate circuit of PWM/PFM mode converting and a circuit of auto-adaptively adjusting dimension of power transistor are described.The duty cycle of the signal when the control mode converts can be gained accuratel...An accurate circuit of PWM/PFM mode converting and a circuit of auto-adaptively adjusting dimension of power transistor are described.The duty cycle of the signal when the control mode converts can be gained accurately by using ratios of currents and capacitances,and an optimal dimension of power transistor is derived with different loads.The converter is designed by 0.35μm standard CMOS technology.Simulation results indicate that the converter starts work at 0.8 V input voltage.Combined with synchronized rectification,the transfer efficiency is higher than 90%with full load range,and achieves 97.5%at rating output.展开更多
In this study, a vertical axis tidal turbine with flexible blades is investigated. The focus is on analyzing the effect of flexible airfoils types and blade flexibility on turbine net output power. To this end, five d...In this study, a vertical axis tidal turbine with flexible blades is investigated. The focus is on analyzing the effect of flexible airfoils types and blade flexibility on turbine net output power. To this end, five different flexible airfoils （Symmetric and Non-symmetric） are employed. The results show that the use of a thick flexible symmetric airfoil can effectively increase output power compared to that achievable with a conventional rigid blade. Moreover, the use of highly flexible blades, as opposed to less flexible or rigid blades, is not recommended.展开更多
Based on the analysis of the impact of Doppler shift to the railway dedicated mobile communication quality under the condition of high-speed mobility,this paper presents a Doppler shift measurement approach based on t...Based on the analysis of the impact of Doppler shift to the railway dedicated mobile communication quality under the condition of high-speed mobility,this paper presents a Doppler shift measurement approach based on the phase estimation of frequency correction channel(FCCH) which correctly reflects the time-varying characteristic of the channel with a testing system developed.The Doppler shift data under the high-speed condition is collected,processed,analyzed,and compared with the simulation results.The scientific laws of the Doppler shift distribution of radio channel under high-speed condition are obtained.These data and analysis are essential for the establishment of high-speed railway Doppler power spectrum model and the development of the key technology of antiDoppler shift.展开更多
DFSM （doubly fed synchronous machine） presents several advantages such as efficiency improvement, weight reduction and increase of the utilization factor （kW/kg）. In this paper the authors focus on impact of the D...DFSM （doubly fed synchronous machine） presents several advantages such as efficiency improvement, weight reduction and increase of the utilization factor （kW/kg）. In this paper the authors focus on impact of the DFSM on the efficiency and machine weight in comparison to conventional synchronous generator with wound rotor. Different topologies of DFSM are briefly described and the different methods and models for performances prediction are presented.展开更多
Lower hybrid wave （LHW）, electro cyclotron （EC） and neutral beam injection （NBI） etc. are the important methods of auxiliary heating. They would be devoted to the HL-2A tokamak step by step. In order to satisfy ...Lower hybrid wave （LHW）, electro cyclotron （EC） and neutral beam injection （NBI） etc. are the important methods of auxiliary heating. They would be devoted to the HL-2A tokamak step by step. In order to satisfy the debug of each system and the need of the experiment, the system should be equipped with high voltage pulse power （HVPP） according to the requirement.展开更多
3 sets of 500 MHz 300kW RF amplifiers to be used at the main ring of the Shanghai Synchrotron Radiation Facility (SSRF) have been installed on site.The Site Acceptance Test (SAT) of the first RF power source was compl...3 sets of 500 MHz 300kW RF amplifiers to be used at the main ring of the Shanghai Synchrotron Radiation Facility (SSRF) have been installed on site.The Site Acceptance Test (SAT) of the first RF power source was completed in last March.The second and third RF power sources are going well and will be finished in October.The type choice, the layout of the RF power sources and the comparison between the SAT conclusion and the design goals are presented.展开更多
The heat generation model and three-dimensional computational fluid dynamics model for lithium ion cells were established with boundary conditions defined.In order to provide a better insight about the behaviors of hi...The heat generation model and three-dimensional computational fluid dynamics model for lithium ion cells were established with boundary conditions defined.In order to provide a better insight about the behaviors of high-power lithium ion cells under realistic discharge conditions,the temperature difference of the cells and an active thermal management system with a pure air-cooling mode were analyzed and predicted with the factors affecting the unevenness of temperature field discussed.The results show a significant effect of the cooling flow rate on the temperature rise of the cells for all discharge rates.Average surface temperatures are relatively uniform at lower discharge rate that makes it easier to control the temperature of the pack.Cell temperatures are expected to rise significantly toward the end of discharge and they show non-uniformity at higher discharge rates.Adequate air flow rate of active cooling is required at high discharge rate and high ambient temperature for practical pack thermal management system.展开更多
基金Supported by National Youth Science Foundation of China(No.60806010)
文摘An accurate circuit of PWM/PFM mode converting and a circuit of auto-adaptively adjusting dimension of power transistor are described.The duty cycle of the signal when the control mode converts can be gained accurately by using ratios of currents and capacitances,and an optimal dimension of power transistor is derived with different loads.The converter is designed by 0.35μm standard CMOS technology.Simulation results indicate that the converter starts work at 0.8 V input voltage.Combined with synchronized rectification,the transfer efficiency is higher than 90%with full load range,and achieves 97.5%at rating output.
文摘In this study, a vertical axis tidal turbine with flexible blades is investigated. The focus is on analyzing the effect of flexible airfoils types and blade flexibility on turbine net output power. To this end, five different flexible airfoils （Symmetric and Non-symmetric） are employed. The results show that the use of a thick flexible symmetric airfoil can effectively increase output power compared to that achievable with a conventional rigid blade. Moreover, the use of highly flexible blades, as opposed to less flexible or rigid blades, is not recommended.
基金Supported by the National Natural Science Foundation of China(No.U133420261222105)+1 种基金the Key Grant Project of Chinese Ministry of Education(No.313006)the Project of State Key Lab of Rail Traffic Control and Safety(No.RCS 2014ZT11)
文摘Based on the analysis of the impact of Doppler shift to the railway dedicated mobile communication quality under the condition of high-speed mobility,this paper presents a Doppler shift measurement approach based on the phase estimation of frequency correction channel(FCCH) which correctly reflects the time-varying characteristic of the channel with a testing system developed.The Doppler shift data under the high-speed condition is collected,processed,analyzed,and compared with the simulation results.The scientific laws of the Doppler shift distribution of radio channel under high-speed condition are obtained.These data and analysis are essential for the establishment of high-speed railway Doppler power spectrum model and the development of the key technology of antiDoppler shift.
文摘DFSM （doubly fed synchronous machine） presents several advantages such as efficiency improvement, weight reduction and increase of the utilization factor （kW/kg）. In this paper the authors focus on impact of the DFSM on the efficiency and machine weight in comparison to conventional synchronous generator with wound rotor. Different topologies of DFSM are briefly described and the different methods and models for performances prediction are presented.
文摘Lower hybrid wave （LHW）, electro cyclotron （EC） and neutral beam injection （NBI） etc. are the important methods of auxiliary heating. They would be devoted to the HL-2A tokamak step by step. In order to satisfy the debug of each system and the need of the experiment, the system should be equipped with high voltage pulse power （HVPP） according to the requirement.
文摘3 sets of 500 MHz 300kW RF amplifiers to be used at the main ring of the Shanghai Synchrotron Radiation Facility (SSRF) have been installed on site.The Site Acceptance Test (SAT) of the first RF power source was completed in last March.The second and third RF power sources are going well and will be finished in October.The type choice, the layout of the RF power sources and the comparison between the SAT conclusion and the design goals are presented.
基金supported by the National Natural Science Foundation of China(No.50976011)the Fundamental Research Funds for the Central Universities(No.2009JBM090)
文摘The heat generation model and three-dimensional computational fluid dynamics model for lithium ion cells were established with boundary conditions defined.In order to provide a better insight about the behaviors of high-power lithium ion cells under realistic discharge conditions,the temperature difference of the cells and an active thermal management system with a pure air-cooling mode were analyzed and predicted with the factors affecting the unevenness of temperature field discussed.The results show a significant effect of the cooling flow rate on the temperature rise of the cells for all discharge rates.Average surface temperatures are relatively uniform at lower discharge rate that makes it easier to control the temperature of the pack.Cell temperatures are expected to rise significantly toward the end of discharge and they show non-uniformity at higher discharge rates.Adequate air flow rate of active cooling is required at high discharge rate and high ambient temperature for practical pack thermal management system.
