The hard tissues of squid can provide important information for species identification. In this study, we used statolith and beak to identify three squid species including Uroteuthis duvaucelii, Loliolus beka, and U. ...The hard tissues of squid can provide important information for species identification. In this study, we used statolith and beak to identify three squid species including Uroteuthis duvaucelii, Loliolus beka, and U. edulis in the South China Sea. Because of the highly overlapping habitat and similar body morphology of the three squid species, we explored four different ways to identify them, by using statolith, upper beak, lower beak and a combination of statolith and beak. An outline geometric morphometric method and stepwise discriminant analysis were used to evaluate the most suitable method for the identification. We found that the combination of statolith and beak had the highest cross validation rate that was 75.0%, 87.5% and 88.7% for U. duvaucelii, L. beka and U. edulis, respectively. Using two beaks had similar results and the lowest cross validation rate was 60.0%, 50.0%, and 73.7% for the upper beak, 46.9%, 58.5% and 75.3% for the lower beak of U. duvaucelii, L. beka and U. edulis, respectively. Analyzing with the statolith had moderate cross validation which was 72.2%, 80.0%, and 87.7% for U. duvaucelii, L. beka and U. edulis, respectively. From the results it is suggested when the entire body of a squid is available, a combination of statolith and beak should be used for the identification. When only one hard tissue is available, species identification can be subjected to large errors.展开更多
Log centering accuracy depends on the computerized simulative level of its three-dimension outline. In this paper, the basic methods about distinguishing three dimensions outline of log by means of computerized simula...Log centering accuracy depends on the computerized simulative level of its three-dimension outline. In this paper, the basic methods about distinguishing three dimensions outline of log by means of computerized simulation are discussed. It is suggested that straight lines or certain curves should be introduced to connect the separated points along some log generatrices. Taking bent logs for example verify the accuracy of computerized simulative method.展开更多
Objective: Phase-contrast X-ray imaging which reduces radiation exposure, is a promising technique for observing the inner structures of biological soft tissues without the aid of contrast agents. The present study in...Objective: Phase-contrast X-ray imaging which reduces radiation exposure, is a promising technique for observing the inner structures of biological soft tissues without the aid of contrast agents. The present study intends to depict blood vessels of rabbits and human livers with hard X-ray in-line outline imaging without contrast agents using synchrotron radiation. Methods: All samples were fixed with formalin and sliced into 6 mm sections. The imaging experiments were performed with Fuji-IX80 films on the 4W1A light beam of the first generation synchrotron radiation in Beijing, China. The device of the experiment, which supplies a maximum light spot size of 20×10 mm was similar to that of in-line holography. The photon energy was set at 8 KeV and high quality imagines were obtained by altering the distance between the sample and the film. Results: The trees of rabbit-liver blood vessels and the curved vessels of the cirrhotic human liver were revealed on the images, where vessels < 20 μm in diameter were differentiated. Conclusion: These results show that the blood vessels of liver samples can be revealed by using hard X-ray in-line outline imaging with the first generation synchrotron radiation without contrast agents.展开更多
It has been made known by the Ministry of Machine-Building Industry that the stipulated policy on the auto industry is to make it a pillar industry of China by the year 2010, with this goal realized in three steps. Th...It has been made known by the Ministry of Machine-Building Industry that the stipulated policy on the auto industry is to make it a pillar industry of China by the year 2010, with this goal realized in three steps. The foundation-laying stage will last two years from 1994 to 1996 and focus on adjusting product structure and completing the production of cars and light-duty buses. Some technical renovation projects will begin before 1996, thus ensuring that China-made components for imported cars reach 60 percent to 80 percent. In addition, co-展开更多
This article is a preliminary summary of Paleogene biostratigraphy of the Liguanqiao, Tantou andYuanqu basins, with a new proposal for Paleogene paleobiogeographic provinces of China. On the basis of asynthetic analys...This article is a preliminary summary of Paleogene biostratigraphy of the Liguanqiao, Tantou andYuanqu basins, with a new proposal for Paleogene paleobiogeographic provinces of China. On the basis of asynthetic analysis of the geological data, characters of the mammalian assemblages and their comparisons withother corresponding faunas, a new scheme on Paleogene biostratigraphic subdivision of the basins has been putforward here. Based on differences of biostratigraphic sequences, characteristics of mammalian assemblagesand directions of faults controlling Paleogene basins in China, six Paleogene paleobiogeographic provinces ofChina have been proposed in this paper, that is: Tianshan-Yinshan-Tumen Province; Tarim-North China Prov-ince; Kunlun-Qinling Province, Yangtze Province, Nanling and Southeastern Coastal Province, Qinghai andTibet Province.展开更多
In this paper, we conduct research on development outline of contemporary art of Chinese sports under the background of differences between Chinese and western culture. The development of any industry must experience ...In this paper, we conduct research on development outline of contemporary art of Chinese sports under the background of differences between Chinese and western culture. The development of any industry must experience the formation, growth, maturity and decline of the industry life cycle. Its period in the entire industry by the proportion of growth, the sports industry is no exception. But due to the particularity of the Chinese system, China’s sports industry life cycle has its particularity. Technology, is the carrier of knowledge talent, technology, knowledge of competition, is essentially talent competition while the country is increasing investment in sports industry, scientifi c research, education, strengthen the training of management personnel, to improve the quality of sports market management. Therefore, we propose the novel idea on the issues that is meaningful.展开更多
The metallurgy department of Kunm-ing Institute of Technology,with its empha-sis on nonferrous metallurgy,is one of themajor academic and technical centres underthe China National Nonferrous Metals In-dustry Corporati...The metallurgy department of Kunm-ing Institute of Technology,with its empha-sis on nonferrous metallurgy,is one of themajor academic and technical centres underthe China National Nonferrous Metals In-dustry Corporation(CNNC).The province of Yunnan,of whichKunming is the capital city,is very rich withresources of nonferrous metals,such as展开更多
1.This study is one of The Applied Economic Institutes Linkages Project(AERIL)which is funded by theCanadian International Development Agency(CIDA)and jiontly managed by The Conference Board of Canada(CBOC)and the Int...1.This study is one of The Applied Economic Institutes Linkages Project(AERIL)which is funded by theCanadian International Development Agency(CIDA)and jiontly managed by The Conference Board of Canada(CBOC)and the International Trade Research Institute in China.It is jointly implemented by the Institute ofEconomic Research of the Chinese State Planning Commission and the North—South Institute of Canada。展开更多
The General Office of the State Council released the 13th Five-Year Plan for China's National Emergency System Construction(Plan for short).According to the Plan,China's emergency management laws and regulatio...The General Office of the State Council released the 13th Five-Year Plan for China's National Emergency System Construction(Plan for short).According to the Plan,China's emergency management laws and regulations and standards system need to be further improved and the basic capabilities of emergency management should continue to be enhanced.展开更多
基金the National Natural Science Foundation of China (No. NSFC41476129)the Shanghai Leading Academic Discipline Project (Fisheries Discipline)supported by Shanghai Ocean University International Center for Marine Studies and Shanghai 1000 Talents Program
文摘The hard tissues of squid can provide important information for species identification. In this study, we used statolith and beak to identify three squid species including Uroteuthis duvaucelii, Loliolus beka, and U. edulis in the South China Sea. Because of the highly overlapping habitat and similar body morphology of the three squid species, we explored four different ways to identify them, by using statolith, upper beak, lower beak and a combination of statolith and beak. An outline geometric morphometric method and stepwise discriminant analysis were used to evaluate the most suitable method for the identification. We found that the combination of statolith and beak had the highest cross validation rate that was 75.0%, 87.5% and 88.7% for U. duvaucelii, L. beka and U. edulis, respectively. Using two beaks had similar results and the lowest cross validation rate was 60.0%, 50.0%, and 73.7% for the upper beak, 46.9%, 58.5% and 75.3% for the lower beak of U. duvaucelii, L. beka and U. edulis, respectively. Analyzing with the statolith had moderate cross validation which was 72.2%, 80.0%, and 87.7% for U. duvaucelii, L. beka and U. edulis, respectively. From the results it is suggested when the entire body of a squid is available, a combination of statolith and beak should be used for the identification. When only one hard tissue is available, species identification can be subjected to large errors.
文摘Log centering accuracy depends on the computerized simulative level of its three-dimension outline. In this paper, the basic methods about distinguishing three dimensions outline of log by means of computerized simulation are discussed. It is suggested that straight lines or certain curves should be introduced to connect the separated points along some log generatrices. Taking bent logs for example verify the accuracy of computerized simulative method.
基金Supported by National Natural Science Foundation of China (10275087)Shanghai Optic Science Fund (022261023)Shanghai Natural Science Fund (02ZF14116)
文摘Objective: Phase-contrast X-ray imaging which reduces radiation exposure, is a promising technique for observing the inner structures of biological soft tissues without the aid of contrast agents. The present study intends to depict blood vessels of rabbits and human livers with hard X-ray in-line outline imaging without contrast agents using synchrotron radiation. Methods: All samples were fixed with formalin and sliced into 6 mm sections. The imaging experiments were performed with Fuji-IX80 films on the 4W1A light beam of the first generation synchrotron radiation in Beijing, China. The device of the experiment, which supplies a maximum light spot size of 20×10 mm was similar to that of in-line holography. The photon energy was set at 8 KeV and high quality imagines were obtained by altering the distance between the sample and the film. Results: The trees of rabbit-liver blood vessels and the curved vessels of the cirrhotic human liver were revealed on the images, where vessels < 20 μm in diameter were differentiated. Conclusion: These results show that the blood vessels of liver samples can be revealed by using hard X-ray in-line outline imaging with the first generation synchrotron radiation without contrast agents.
文摘It has been made known by the Ministry of Machine-Building Industry that the stipulated policy on the auto industry is to make it a pillar industry of China by the year 2010, with this goal realized in three steps. The foundation-laying stage will last two years from 1994 to 1996 and focus on adjusting product structure and completing the production of cars and light-duty buses. Some technical renovation projects will begin before 1996, thus ensuring that China-made components for imported cars reach 60 percent to 80 percent. In addition, co-
文摘This article is a preliminary summary of Paleogene biostratigraphy of the Liguanqiao, Tantou andYuanqu basins, with a new proposal for Paleogene paleobiogeographic provinces of China. On the basis of asynthetic analysis of the geological data, characters of the mammalian assemblages and their comparisons withother corresponding faunas, a new scheme on Paleogene biostratigraphic subdivision of the basins has been putforward here. Based on differences of biostratigraphic sequences, characteristics of mammalian assemblagesand directions of faults controlling Paleogene basins in China, six Paleogene paleobiogeographic provinces ofChina have been proposed in this paper, that is: Tianshan-Yinshan-Tumen Province; Tarim-North China Prov-ince; Kunlun-Qinling Province, Yangtze Province, Nanling and Southeastern Coastal Province, Qinghai andTibet Province.
文摘In this paper, we conduct research on development outline of contemporary art of Chinese sports under the background of differences between Chinese and western culture. The development of any industry must experience the formation, growth, maturity and decline of the industry life cycle. Its period in the entire industry by the proportion of growth, the sports industry is no exception. But due to the particularity of the Chinese system, China’s sports industry life cycle has its particularity. Technology, is the carrier of knowledge talent, technology, knowledge of competition, is essentially talent competition while the country is increasing investment in sports industry, scientifi c research, education, strengthen the training of management personnel, to improve the quality of sports market management. Therefore, we propose the novel idea on the issues that is meaningful.
文摘The metallurgy department of Kunm-ing Institute of Technology,with its empha-sis on nonferrous metallurgy,is one of themajor academic and technical centres underthe China National Nonferrous Metals In-dustry Corporation(CNNC).The province of Yunnan,of whichKunming is the capital city,is very rich withresources of nonferrous metals,such as
文摘1.This study is one of The Applied Economic Institutes Linkages Project(AERIL)which is funded by theCanadian International Development Agency(CIDA)and jiontly managed by The Conference Board of Canada(CBOC)and the International Trade Research Institute in China.It is jointly implemented by the Institute ofEconomic Research of the Chinese State Planning Commission and the North—South Institute of Canada。
文摘The General Office of the State Council released the 13th Five-Year Plan for China's National Emergency System Construction(Plan for short).According to the Plan,China's emergency management laws and regulations and standards system need to be further improved and the basic capabilities of emergency management should continue to be enhanced.
