The synthesis process for La 1- x Sr x Mn 1- y Co y O 3- δ ( x = 0.2, 0.3; y = 0.2, 0.8, designated as LSMC below) perovskite oxides prepared by solid state reaction was investigated using DSC/TG, XRD, EPMA and parti...The synthesis process for La 1- x Sr x Mn 1- y Co y O 3- δ ( x = 0.2, 0.3; y = 0.2, 0.8, designated as LSMC below) perovskite oxides prepared by solid state reaction was investigated using DSC/TG, XRD, EPMA and particle size analysis methods. It was found that LSMCs were all of single phase and the synthesis process might be divided into three stages: the decomposition of reactants, the formation of LaMn(Co)O 3 based oxides, and the formation of LSMC solid solution. Typical average and the peak value of particle size, and the specific surface area are 14.65?μm, 16.4?μm and 1.38?m 2/mL, respectively, for mixed reactants and are 23.81?μm, 32.11?μm and 0.5?m 2/mL, respectively, for powder synthesized at 1?200?℃ for 8?h in air.展开更多
A series of photocatalysts of un-doped, single-doped and co-doped nanometer titanium diox- ide （TiO2） have been successfully prepared by template method using Fe（NO3）3.9H2O, La（NO3）3.6H2O, and tetrabutyl titanat...A series of photocatalysts of un-doped, single-doped and co-doped nanometer titanium diox- ide （TiO2） have been successfully prepared by template method using Fe（NO3）3.9H2O, La（NO3）3.6H2O, and tetrabutyl titanate as precursors and glucan as template. Scanning electron microscopy, X-ray diffraction, and N2 adsorption-desorption measurement were employed to characterize the morphology, crystal structure and surface structure of the samples. The photo-absorbance of the obtained catalysts was measured by UV-Vis absorption spectroscopy, and the photocatalytic activities of the prepared samples under UV and visible light were estimated by measuring the degradation rate of methyl orange in an aqueous solution. The characterizations indicated that the prepared photocatalysts consisted of anatase phase and possessed high surface area of ca. 163-176 m2/g. It was shown that the Fe and La co-doped nano-TiO2 could be activated by visible light and could thus be used as an effective catalyst in photo-oxidation reactions. The synergistic effect of Fe and La co-doping played an important role in improving the photocatalytic activity. In addition, the possibility of cyclic usage of co-doped nano-TiO2 was also confirmed, the photocatalytic activity of codoped nano-TiO2 remained above 89.6% of the fresh sample after being used four times.展开更多
The Sr/F co-doped CaP(Sr/F-CaP)coatings were prepared by micro-arc oxidation(MAO)under different voltages to modify the microstructure and corrosion behavior of Mg-4Zn-1Mn alloy.The surface and interface characteristi...The Sr/F co-doped CaP(Sr/F-CaP)coatings were prepared by micro-arc oxidation(MAO)under different voltages to modify the microstructure and corrosion behavior of Mg-4Zn-1Mn alloy.The surface and interface characteristics investigated using scanning electron microscopy(SEM)and energy dispersive X-ray spectrometer(EDS)showed that the MAO coatings displayed uneven crater-like holes and tiny cracks under lower voltage,while they exhibited relatively homogeneous crater-like holes without cracks under higher voltage.The thickness of MAO coatings increased with increasing voltage.The corrosion behavior of Mg-4Zn-1Mn alloy was improved by the MAO coatings.The MAO coatings prepared under 450 V and 500 V voltages possessed the best corrosion resistance with regard to the electrochemical corrosion tests and immersion corrosion tests,respectively.The MAO coatings fabricated under 450-500 V could provide a better corrosion protection effect for the substrate.展开更多
A new sol-gel process is applied to fabricate the BST （BaxSr1-xTiO3） sol and nano-powder of La-Mn-Al co-doping with Ba/Sr ratio 65/35, and the BST thick film is prepared in the Pt/Ti/SiO2/Si substrate. The powder an...A new sol-gel process is applied to fabricate the BST （BaxSr1-xTiO3） sol and nano-powder of La-Mn-Al co-doping with Ba/Sr ratio 65/35, and the BST thick film is prepared in the Pt/Ti/SiO2/Si substrate. The powder and thick film are characterized by X-ray diffraction and transmission electron microscope. The influence of La-Mn-Al co-doping on the dielectric properties and micro-structure of BST thick film is analyzed. The results show that the La, Mn, and Al ions can take an obvious restraint on the growth of BaSrTiO3 grains. The polycrystalline particles come into being during the crystallization of thick film, which may improve the uniformity and compactness of thick film. The influence of unequal-valence and doping amount on the leakage current, dielectric loss, and dielectric property are mainly discussed. The dielectric constant and dielectric loss of thick film are 1200 and 0.03, respectively, in the case of 1mol% La doping, 2mol% Mn doping, and 1mol% Al doping.展开更多
采用自制线管式介质阻挡放电反应器,针对非热等离子体协同Mn-Ce/La/γ-Al_2O_3催化剂对低浓度甲苯的去除开展研究。研究中制备了Mn/γ-Al_2O_3、Mn-Ce/γ-Al_2O_3、Mn-La/γ-Al_2O_3催化剂,从甲苯去除率、产物O_3生成、CO_x选择性及其...采用自制线管式介质阻挡放电反应器,针对非热等离子体协同Mn-Ce/La/γ-Al_2O_3催化剂对低浓度甲苯的去除开展研究。研究中制备了Mn/γ-Al_2O_3、Mn-Ce/γ-Al_2O_3、Mn-La/γ-Al_2O_3催化剂,从甲苯去除率、产物O_3生成、CO_x选择性及其他副产物生成情况考察比较了空管放电、协同催化剂放电时催化降解甲苯性能,并对催化剂进行了BET、SEM、H2-TPR和ICP-OES表征研究。结果表明:稀土助剂的加入有助于提高甲苯去除率及降低程度,且La催化性能优于Ce.,当外加电压22 k V、气量6 L·min-1、甲苯初始浓度600 mg·m-3时,Mn-La/γ-Al_2O_3催化剂对甲苯去除率达到72.74%。H2-TPR结果表明,稀土助剂的加入提高了催化剂低温活性及储氧能力,添加La的效果优于Ce。催化剂有助于抑制副产物O_3生成,提高CO_2和COx选择性。展开更多
文摘The synthesis process for La 1- x Sr x Mn 1- y Co y O 3- δ ( x = 0.2, 0.3; y = 0.2, 0.8, designated as LSMC below) perovskite oxides prepared by solid state reaction was investigated using DSC/TG, XRD, EPMA and particle size analysis methods. It was found that LSMCs were all of single phase and the synthesis process might be divided into three stages: the decomposition of reactants, the formation of LaMn(Co)O 3 based oxides, and the formation of LSMC solid solution. Typical average and the peak value of particle size, and the specific surface area are 14.65?μm, 16.4?μm and 1.38?m 2/mL, respectively, for mixed reactants and are 23.81?μm, 32.11?μm and 0.5?m 2/mL, respectively, for powder synthesized at 1?200?℃ for 8?h in air.
文摘A series of photocatalysts of un-doped, single-doped and co-doped nanometer titanium diox- ide （TiO2） have been successfully prepared by template method using Fe（NO3）3.9H2O, La（NO3）3.6H2O, and tetrabutyl titanate as precursors and glucan as template. Scanning electron microscopy, X-ray diffraction, and N2 adsorption-desorption measurement were employed to characterize the morphology, crystal structure and surface structure of the samples. The photo-absorbance of the obtained catalysts was measured by UV-Vis absorption spectroscopy, and the photocatalytic activities of the prepared samples under UV and visible light were estimated by measuring the degradation rate of methyl orange in an aqueous solution. The characterizations indicated that the prepared photocatalysts consisted of anatase phase and possessed high surface area of ca. 163-176 m2/g. It was shown that the Fe and La co-doped nano-TiO2 could be activated by visible light and could thus be used as an effective catalyst in photo-oxidation reactions. The synergistic effect of Fe and La co-doping played an important role in improving the photocatalytic activity. In addition, the possibility of cyclic usage of co-doped nano-TiO2 was also confirmed, the photocatalytic activity of codoped nano-TiO2 remained above 89.6% of the fresh sample after being used four times.
文摘The Sr/F co-doped CaP(Sr/F-CaP)coatings were prepared by micro-arc oxidation(MAO)under different voltages to modify the microstructure and corrosion behavior of Mg-4Zn-1Mn alloy.The surface and interface characteristics investigated using scanning electron microscopy(SEM)and energy dispersive X-ray spectrometer(EDS)showed that the MAO coatings displayed uneven crater-like holes and tiny cracks under lower voltage,while they exhibited relatively homogeneous crater-like holes without cracks under higher voltage.The thickness of MAO coatings increased with increasing voltage.The corrosion behavior of Mg-4Zn-1Mn alloy was improved by the MAO coatings.The MAO coatings prepared under 450 V and 500 V voltages possessed the best corrosion resistance with regard to the electrochemical corrosion tests and immersion corrosion tests,respectively.The MAO coatings fabricated under 450-500 V could provide a better corrosion protection effect for the substrate.
基金supported by the National High Technology Research and Development Program of China under Grant No2007AA032120the National Natural Science Foundation of China under Grant No 60777043
文摘A new sol-gel process is applied to fabricate the BST （BaxSr1-xTiO3） sol and nano-powder of La-Mn-Al co-doping with Ba/Sr ratio 65/35, and the BST thick film is prepared in the Pt/Ti/SiO2/Si substrate. The powder and thick film are characterized by X-ray diffraction and transmission electron microscope. The influence of La-Mn-Al co-doping on the dielectric properties and micro-structure of BST thick film is analyzed. The results show that the La, Mn, and Al ions can take an obvious restraint on the growth of BaSrTiO3 grains. The polycrystalline particles come into being during the crystallization of thick film, which may improve the uniformity and compactness of thick film. The influence of unequal-valence and doping amount on the leakage current, dielectric loss, and dielectric property are mainly discussed. The dielectric constant and dielectric loss of thick film are 1200 and 0.03, respectively, in the case of 1mol% La doping, 2mol% Mn doping, and 1mol% Al doping.
文摘采用自制线管式介质阻挡放电反应器,针对非热等离子体协同Mn-Ce/La/γ-Al_2O_3催化剂对低浓度甲苯的去除开展研究。研究中制备了Mn/γ-Al_2O_3、Mn-Ce/γ-Al_2O_3、Mn-La/γ-Al_2O_3催化剂,从甲苯去除率、产物O_3生成、CO_x选择性及其他副产物生成情况考察比较了空管放电、协同催化剂放电时催化降解甲苯性能,并对催化剂进行了BET、SEM、H2-TPR和ICP-OES表征研究。结果表明:稀土助剂的加入有助于提高甲苯去除率及降低程度,且La催化性能优于Ce.,当外加电压22 k V、气量6 L·min-1、甲苯初始浓度600 mg·m-3时,Mn-La/γ-Al_2O_3催化剂对甲苯去除率达到72.74%。H2-TPR结果表明,稀土助剂的加入提高了催化剂低温活性及储氧能力,添加La的效果优于Ce。催化剂有助于抑制副产物O_3生成,提高CO_2和COx选择性。
