针对在室温环境下探测瓦斯浓度,提出一种基于钯掺杂单壁碳纳米管(Pd-SWCNTs)的超宽带射频识别(UWB-RFID)传感器。传感器为薄型标签,由传感探头和电磁界面组成,其中传感探头为一PdSWCNTs加载的交叉指型电极(IDE);电磁界面由天线、微带线...针对在室温环境下探测瓦斯浓度,提出一种基于钯掺杂单壁碳纳米管(Pd-SWCNTs)的超宽带射频识别(UWB-RFID)传感器。传感器为薄型标签,由传感探头和电磁界面组成,其中传感探头为一PdSWCNTs加载的交叉指型电极(IDE);电磁界面由天线、微带线和终端负载组成。Pd-SWCNTs感知瓦斯浓度,引起IDE电流的变化,形成带隙幅度调制和带隙频率调制两种识别模式。当瓦斯浓度从0×10-6增加到100×10-6,基于带隙调幅调制的识别灵敏度为-9.32 d B;而基于带隙调频调制的识别灵敏度为-11.30 d B。展开更多
A new SnO2-Fe2O3/SWCNTs（single-walled carbon nanotubes） ternary nanocomposite was first synthesized by a facile hydrothermal approach.SnO2 and Fe2O3 nanoparticles（NPs） were homogeneously located on the surface of ...A new SnO2-Fe2O3/SWCNTs（single-walled carbon nanotubes） ternary nanocomposite was first synthesized by a facile hydrothermal approach.SnO2 and Fe2O3 nanoparticles（NPs） were homogeneously located on the surface of SWCNTs,as confirmed by X-ray diffraction（XRD）,transmission electron microscope（TEM） and energy dispersive X-ray spectroscopy（EDX）.Due to the synergistic effect of different components,the as synthesized SnO2-Fe2O3/SWCNTs composite as an anode material for lithium-ion batteries exhibited excellent electrochemical performance with a high capacity of 692 mAh·g-1 which could be maintained after 50 cycles at 200 mA·g-1.Even at a high rate of2000 mA·g-1,the capacity was still remained at 656 mAh·g-1.展开更多
Novel nanocomposites of PEO/PVDF loaded by different contents of SWCNTs were prepared. From UV-Vis spectra, the estimated values of absorption edge, absorption coefficient, energy of tail and extinction coefficient we...Novel nanocomposites of PEO/PVDF loaded by different contents of SWCNTs were prepared. From UV-Vis spectra, the estimated values of absorption edge, absorption coefficient, energy of tail and extinction coefficient were calculated. The exponential decay tail at low energy is due to the presence of localized states in the energy band gap. The shift of Raman spectra indicates the possibility of SWCNTs to be attached with OH group in the side chain of polymer molecules. The X-ray measurements indicate that the addition of SWCNTs is a rich amorphous region in polymeric matrices and complete complexation between PEO/PVDF blend and SWCNTs. The SEM images show smooth surface of PEO/PVDF and they become rough with single rod with a good distribution within surface region in polymeric matrices after loading SWCNTs. TEM images showed that SWCNTs were dispersed well in polymeric matrices. The broken ends of nanotubes were showing that the SWCNTs were broken apart rather than from at the fracture surface. The films show some defects like rags on the tube walls. There are some black regions in TEM images attributed to amorphous nature carbon. The prepared nanocomposites are very useful in technical application.展开更多
In this paper, a new modified approach to design the photovoltaic cell has been presented by adding Single Wall Carbon Nanotubes (SWCNTs) as type (i). The main issue is to increase the efficiency of the photovoltaic c...In this paper, a new modified approach to design the photovoltaic cell has been presented by adding Single Wall Carbon Nanotubes (SWCNTs) as type (i). The main issue is to increase the efficiency of the photovoltaic cell, on the other hand, to exploit a larger range of electromagnetic wave frequencies, specifically a range within terahertz (THz) frequency domain, using 3D EM computer simulation technology (CST). It is clear in the normal PV cell start working at frequency of 500 THz, while the frequency at which the PV cell with SWCNTs operates is much less and it is close to zero, on the other hand, the PV cell with SWCNTs needs a larger cross-section area of 2800 nm2 to operate at frequency of 500 THz. This cell can be easily produced industrially, which means increases the efficiency of solar cell.展开更多
文摘针对在室温环境下探测瓦斯浓度,提出一种基于钯掺杂单壁碳纳米管(Pd-SWCNTs)的超宽带射频识别(UWB-RFID)传感器。传感器为薄型标签,由传感探头和电磁界面组成,其中传感探头为一PdSWCNTs加载的交叉指型电极(IDE);电磁界面由天线、微带线和终端负载组成。Pd-SWCNTs感知瓦斯浓度,引起IDE电流的变化,形成带隙幅度调制和带隙频率调制两种识别模式。当瓦斯浓度从0×10-6增加到100×10-6,基于带隙调幅调制的识别灵敏度为-9.32 d B;而基于带隙调频调制的识别灵敏度为-11.30 d B。
基金supported by the National Key Project on Basic Research(Grant No.2011CB935904)the National Natural Science Foundation of China(Grant No.21171163,91127020)NSF for Distinguished Young Scholars of Fujian Province(Grant No.2013J06006)
文摘A new SnO2-Fe2O3/SWCNTs（single-walled carbon nanotubes） ternary nanocomposite was first synthesized by a facile hydrothermal approach.SnO2 and Fe2O3 nanoparticles（NPs） were homogeneously located on the surface of SWCNTs,as confirmed by X-ray diffraction（XRD）,transmission electron microscope（TEM） and energy dispersive X-ray spectroscopy（EDX）.Due to the synergistic effect of different components,the as synthesized SnO2-Fe2O3/SWCNTs composite as an anode material for lithium-ion batteries exhibited excellent electrochemical performance with a high capacity of 692 mAh·g-1 which could be maintained after 50 cycles at 200 mA·g-1.Even at a high rate of2000 mA·g-1,the capacity was still remained at 656 mAh·g-1.
文摘Novel nanocomposites of PEO/PVDF loaded by different contents of SWCNTs were prepared. From UV-Vis spectra, the estimated values of absorption edge, absorption coefficient, energy of tail and extinction coefficient were calculated. The exponential decay tail at low energy is due to the presence of localized states in the energy band gap. The shift of Raman spectra indicates the possibility of SWCNTs to be attached with OH group in the side chain of polymer molecules. The X-ray measurements indicate that the addition of SWCNTs is a rich amorphous region in polymeric matrices and complete complexation between PEO/PVDF blend and SWCNTs. The SEM images show smooth surface of PEO/PVDF and they become rough with single rod with a good distribution within surface region in polymeric matrices after loading SWCNTs. TEM images showed that SWCNTs were dispersed well in polymeric matrices. The broken ends of nanotubes were showing that the SWCNTs were broken apart rather than from at the fracture surface. The films show some defects like rags on the tube walls. There are some black regions in TEM images attributed to amorphous nature carbon. The prepared nanocomposites are very useful in technical application.
文摘In this paper, a new modified approach to design the photovoltaic cell has been presented by adding Single Wall Carbon Nanotubes (SWCNTs) as type (i). The main issue is to increase the efficiency of the photovoltaic cell, on the other hand, to exploit a larger range of electromagnetic wave frequencies, specifically a range within terahertz (THz) frequency domain, using 3D EM computer simulation technology (CST). It is clear in the normal PV cell start working at frequency of 500 THz, while the frequency at which the PV cell with SWCNTs operates is much less and it is close to zero, on the other hand, the PV cell with SWCNTs needs a larger cross-section area of 2800 nm2 to operate at frequency of 500 THz. This cell can be easily produced industrially, which means increases the efficiency of solar cell.
