Design of the pressure regulation algorithm for active braking in vehicle ACC system

To develop the pressure control algorithm for active braking of adaptive cruise control（ACC） system,a test bench with real parts of the tested vehicle is built.With the dynamic analysis of the active braking actuators,it is demonstrated that different duty of pulse-width modulation（PWM） signals could control the pressure changing rate of the wheel cylinder.To obtain that signal,a modified proportional-integral-differential（PID） control algorithm is developed using the variable parameter method,the control value reset method,the dead zone method and the integral saturation method.Experimental results show that the delay and overshoot of the pressure response could be reduced considerably using the modified PID algorithm compared with the conventional one.The proposed pressure control algorithm could be used for the further development of the ACC＇s controller.

Lateral Stability Improvement of Car-Trailer Systems Using Active Trailer Braking Control

An active trailer braking controller to improve the lateral stability of car-trailer systems is presented. The special and complex structures of these types of vehicles exhibit unique unstable motion behavior, such as the trailer swing, jack-knifing and rollover. These unstable motion modes may lead to fatal accidents. The effects of passive mechanical parameters on the stability of car-trailer systems have been thoroughly investigated. Some of the passive parameters, such as the center of gravity of the trailer, may be drastically varied during various operating conditions. Even for an optimal design of a car-trailer system, based on a specific passive parameter set, the lateral stability cannot be guaranteed. In order to improve the lateral stability of car-trailer systems, an active trailer braking controller is designed using the Linear Quadratic Regular （LQR） technique. To derive the controller, a vehicle model with 3 Degrees Of Freedom （DOF） is developed to represent the car-trailer system. A single lane-change maneuver has been simulated to examine the performance of the controller and the numerical results are compared with those of the baseline design. The benchmark investigation indicates that the optimal controller based on the LQR technique can effectively improve the high-speed lateral stability of the car-trailer system.

Integrated yaw and rollover control based on differential braking for off-road vehicles with mechanical elastic wheel

Aiming at the issue of yaw and rollover stability control for off-road vehicles with non-pneumatic mechanical elastic wheel(MEW),an integrated control system based on fuzzy differential braking is developed.By simplifying the structure of the MEW,a corresponding fitting brush tire model is constructed and its longitudinal and lateral tire force expressions are set up,respectively.Then,a nonlinear vehicle simulation model with MEW is established to validate the proposed control scheme based on Carsim.The designed yaw and rollover control system is a two-level structure with the upper additional moment controller,which utilizes a predictive load transfer ratio(PLTR)as the rollover index.In order to design the upper integrated control algorithm,fuzzy proportional-integral-derivative(PID)is adopted to coordinate the yaw and rollover control,simultaneously.And the lower control allocator realizes the additional moment to the vehicle by differential braking.Finally,a Carsim-simulink co-simulation model is constructed,and simulation results show that the integrated control system could improve the vehicle yaw and roll stability,and prevent rollover happening.