Hardware for multi-superconducting qubit control and readout

We have developed an electronic hardware system for the control and readout of multi-superconducting qubit devices.The hardware system is based on the design ideas of good scalability,high synchronization and low latency.The system,housed inside a VPX-6U chassis,includes multiple arbitrary-waveform generator(AWG)channels,analog-digital-converter(ADC)channels as well as direct current source channels.The system can be used for the control and readout of up to twelve superconducting transmon qubits in one chassis,and control and readout of more and more qubit can be carried out by interconnecting the chassis.By using field programmable gate array(FPGA)processors,the system incorporates three features that are specifically useful for superconducting qubit research.Firstly,qubit signals can be processed using the on-board FPGA after being acquired by ADCs,significantly reducing data processing time and data amount for storage and transmission.Secondly,different output modes,such as direct output and sequential output modes,of AWG can be implemented with pre-encoded FPGA.Thirdly,with data acquisition ADCs and control AWGs jointly controlled by the same FPGA,the feedback latency can be reduced,and in our test a 178.4 ns latency time is realized.This is very useful for future quantum feedback experiments.Finally,we demonstrate the functionality of the system by applying the system to the control and readout of a 10 qubit superconducting quantum processor.

Extracavity Parametric Oscillation with Continuous and/or Discontinuous Frequency Tuning

A continuously or/and discontinuously tunable LiNbO3 Optical Parametric Oscillator (OPO) with the spectral range of 1.42 - 4.24 um and shifting of 0…12 nm is created and investigated. The OPO resonator ring circuit provides for the radiation energy output value of up to 50 mJ. Radiation bandwidth narrowing of up to 0.7 cm–1 by introducing of the Fabry-Perot etalon into the OPO resonator has been obtained.

Performance Analysis of ZF and RZF in Low-Resolution ADC/DAC Massive MIMO Systems

Large number of antennas and higher bandwidth usage in massive multiple-input-multipleoutput(MIMO)systems create immense burden on receiver in terms of higher power consumption.The power consumption at the receiver radio frequency(RF)circuits can be significantly reduced by the application of analog-to-digital converter(ADC)of low resolution.In this paper we investigate bandwidth efficiency(BE)of massive MIMO with perfect channel state information(CSI)by applying low resolution ADCs with Rician fadings.We start our analysis by deriving the additive quantization noise model,which helps to understand the effects of ADC resolution on BE by keeping the power constraint at the receiver in radar.We also investigate deeply the effects of using higher bit rates and the number of BS antennas on bandwidth efficiency(BE)of the system.We emphasize that good bandwidth efficiency can be achieved by even using low resolution ADC by using regularized zero-forcing(RZF)combining algorithm.We also provide a generic analysis of energy efficiency(EE)with different options of bits by calculating the energy efficiencies(EE)using the achievable rates.We emphasize that satisfactory BE can be achieved by even using low-resolution ADC/DAC in massive MIMO.

Waveform timing performance of a 5 GS/s fast pulse sampling module with DRS4

We first clarify timing issues of non-uniform sampling intervals regarding a 5 GS/s fast pulse sampling module with DRS4. A calibration strategy is proposed, and as a result, the waveform timing performance is improved to below 10 ps RMS. We then further evaluate waveform-timing performance of the module by comparing with a 10 GS/s oscilloscope in a setup with plastic scintillators and fast PMTs. Different waveform timing algorithms are employed for analysis, and the module shows comparable timing performance with that of the oscilloscope.