The Tan-Lu fault zone is a large NNE-trending fault zone in eastern China.Investigations of the structures of the fault zone and its surrounding areas have attracted much attention.In this study,we used dense-array am...The Tan-Lu fault zone is a large NNE-trending fault zone in eastern China.Investigations of the structures of the fault zone and its surrounding areas have attracted much attention.In this study,we used dense-array ambient noise tomography to construct a threedimensional shear wave velocity model of shallow crust in an area about 80km×70km in Lujiang,Anhui Province,eastern China.For approximately one month we collected continuous ambient noise signals recorded by 90 short-period seismographs in the region,and obtained the short-period Rayleigh wave empirical Green's functions between stations by the cross-correlation method;we also extracted 0.5–8 s fundamental mode Rayleigh wave group velocity and phase velocity dispersion curves.Based on the direct surface wave tomography method,we jointly inverted the group velocity and phase velocity dispersion data of all paths and obtained the 3-D shear wave velocity structure in the depth range of 0–5 km.The results revealed important geological structural features of the study area.In the north region,the sedimentary center of the Hefei Basin—the southwestern part of the Chaohu Lake—shows a significant low-velocity anomaly to a depth of at least 5 km.The southwestern and southeastern regions of the array are the eastern margin of the Dabie orogenic belt and the intrusion area of Luzong volcanic rocks,respectively,and both show obvious high-speed anomalies;the sedimentary area within the Tan-Lu fault zone(about 10 km wide)shows low-velocity anomalies.However,the volcanic rock intrusion area in the fault zone is shown as high velocity.Our shallow crustal imaging results reflect the characteristics of different structures in the study area,especially the high-speed intrusive rocks in the Tan-Lu fault zone,which were probably partially derived from the magmatic activity of Luzong volcanic basin.From the Late Cretaceous to Early Tertiary,the Tan-Lu fault zone was in a period of extensional activity;the special stress environment and the fractured fault zone morphology provided conditions for magma in the Luzong volcanic basin to intrude into the Tan-Lu fault zone in the west.Our 3-D model can also provide important information for deep resource exploration and earthquake strong ground motion simulation.展开更多
Two grabens were developed in the Yi-Shu segment of the Tan-Lu fault zone (TLFZ) during its extensional activities, and are now confined by four major NNE-trending normal faults and filled with Cretaceous sediments. T...Two grabens were developed in the Yi-Shu segment of the Tan-Lu fault zone (TLFZ) during its extensional activities, and are now confined by four major NNE-trending normal faults and filled with Cretaceous sediments. These faults were developed due to their reactivities, containing gouge and cutting the graben sediments. Detailed fieldwork demonstrates that the faults experienced sinistral transtensional moment related to regional NE-SW extension during the reactivity. X-ray diffraction (XRD) analysis of the finest gouge samples gives illite crystallinity values higher than 0.42°Δ2θ, indicating temperatures experienced by the gouge samples were less than 150°C. From the relation between K-Ar data and proportions of detrital illite in different size fractions of the gouge samples, we conclude that refaulting for the western boundary fault of the TLFZ, abbreviated to F4, took place at ca. 90 Ma and for the eastern boundary fault, abbreviated to F1, happened from 70 to 60 Ma. During the two phases of reactivity imposed by the same NE-SW extension, the TLFZ experienced uplifting and no sediments were deposited in the two grabens. It is suggested that the TLFZ experienced extension during the Late Cretaceous, which supports the inference that lithospheric thinning was still undergoing in the east of the North China Craton during the Late Cretaceous magmatic hiatus.展开更多
基金the National Natural Science Foundation of China(project 41790464)the China Postdoctoral Fund(BH2080000099).
文摘The Tan-Lu fault zone is a large NNE-trending fault zone in eastern China.Investigations of the structures of the fault zone and its surrounding areas have attracted much attention.In this study,we used dense-array ambient noise tomography to construct a threedimensional shear wave velocity model of shallow crust in an area about 80km×70km in Lujiang,Anhui Province,eastern China.For approximately one month we collected continuous ambient noise signals recorded by 90 short-period seismographs in the region,and obtained the short-period Rayleigh wave empirical Green's functions between stations by the cross-correlation method;we also extracted 0.5–8 s fundamental mode Rayleigh wave group velocity and phase velocity dispersion curves.Based on the direct surface wave tomography method,we jointly inverted the group velocity and phase velocity dispersion data of all paths and obtained the 3-D shear wave velocity structure in the depth range of 0–5 km.The results revealed important geological structural features of the study area.In the north region,the sedimentary center of the Hefei Basin—the southwestern part of the Chaohu Lake—shows a significant low-velocity anomaly to a depth of at least 5 km.The southwestern and southeastern regions of the array are the eastern margin of the Dabie orogenic belt and the intrusion area of Luzong volcanic rocks,respectively,and both show obvious high-speed anomalies;the sedimentary area within the Tan-Lu fault zone(about 10 km wide)shows low-velocity anomalies.However,the volcanic rock intrusion area in the fault zone is shown as high velocity.Our shallow crustal imaging results reflect the characteristics of different structures in the study area,especially the high-speed intrusive rocks in the Tan-Lu fault zone,which were probably partially derived from the magmatic activity of Luzong volcanic basin.From the Late Cretaceous to Early Tertiary,the Tan-Lu fault zone was in a period of extensional activity;the special stress environment and the fractured fault zone morphology provided conditions for magma in the Luzong volcanic basin to intrude into the Tan-Lu fault zone in the west.Our 3-D model can also provide important information for deep resource exploration and earthquake strong ground motion simulation.
基金Supported by National Natural Science Foundation of China (Grant Nos. 90714004, 40672131)
文摘Two grabens were developed in the Yi-Shu segment of the Tan-Lu fault zone (TLFZ) during its extensional activities, and are now confined by four major NNE-trending normal faults and filled with Cretaceous sediments. These faults were developed due to their reactivities, containing gouge and cutting the graben sediments. Detailed fieldwork demonstrates that the faults experienced sinistral transtensional moment related to regional NE-SW extension during the reactivity. X-ray diffraction (XRD) analysis of the finest gouge samples gives illite crystallinity values higher than 0.42°Δ2θ, indicating temperatures experienced by the gouge samples were less than 150°C. From the relation between K-Ar data and proportions of detrital illite in different size fractions of the gouge samples, we conclude that refaulting for the western boundary fault of the TLFZ, abbreviated to F4, took place at ca. 90 Ma and for the eastern boundary fault, abbreviated to F1, happened from 70 to 60 Ma. During the two phases of reactivity imposed by the same NE-SW extension, the TLFZ experienced uplifting and no sediments were deposited in the two grabens. It is suggested that the TLFZ experienced extension during the Late Cretaceous, which supports the inference that lithospheric thinning was still undergoing in the east of the North China Craton during the Late Cretaceous magmatic hiatus.
