Aiming at the potential presence of mixing automatic identification system(AIS) signals,a new demodulation scheme was proposed for separating other interfering signals in satellite systems.The combined iterative cross...Aiming at the potential presence of mixing automatic identification system(AIS) signals,a new demodulation scheme was proposed for separating other interfering signals in satellite systems.The combined iterative cross-correlation demodulation scheme,referred to as CICCD,yielded a set of single short signals based on the prior information of AIS,after the frequency,code rate and modulation index were estimated.It demodulates the corresponding short codes according to the maximum peak of cross-correlation,which is simple and easy to implement.Numerical simulations show that the bit error rate of proposed algorithm improves by about 40% compared with existing ones,and about 3 dB beyond the standard AIS receiver.In addition,the proposed demodulation scheme shows the satisfying performance and engineering value in mixing AIS environment and can also perform well in low signal-to-noise conditions.展开更多
Aims: To prevent fetal damage by excess oxytocin administration of manually controlled infusion, by automatic and safe increasing infusion setting with monitoring uterine contraction and fetal heart rate. Methods: Sta...Aims: To prevent fetal damage by excess oxytocin administration of manually controlled infusion, by automatic and safe increasing infusion setting with monitoring uterine contraction and fetal heart rate. Methods: Starting infusion level was 2 milliU/ml, as oxytocin sensitivity of a pregnant uterus is unknown, to avoid hyper contraction and fetal bradycardia caused by unexpected excess oxytocin sensitivity. The infusion automatically increased with automatic monitoring of uterine contraction curve, then the increasing stopped when contraction reached to normal labor level, where the infusion level maintained, which continued until delivery, if there is no trouble. However, the infusion continued until expiring all fluid in case of insensitive uterus, where the induction was performed in another day. The infusion stopped automatically when contraction was too strong, or fetal heart rate is abnormal. Thus, oxytocin sensitive case is protected from excess contraction and fetal asphyxia. Results: Normal vaginal delivery was achieved in 28/33 cases (85%), which was more than manually controlled infusion. No case was abnormal in successful oxytocin infusion. Conclusion: The automated technique will be applied to oxytocin labor induction.展开更多
Wavelet forced de-noising algorithm is suitable for denoising of unsteady drilling fluid pulse signal, including baseline drift rectification and two-stage de-noising processing of frame synchronization signal and ins...Wavelet forced de-noising algorithm is suitable for denoising of unsteady drilling fluid pulse signal, including baseline drift rectification and two-stage de-noising processing of frame synchronization signal and instruction signal. Two-stage de-noising processing can reduce the impact of baseline drift and determine automatic peak detection threshold range for signal recognition by distinguishing different features of frame synchronization pulse and instruction pulse. Rising and falling edge relative protruding threshold is defined for peak detection in signal recognition, which can make full use of the degree of the signal peak change and detect peaks flexibly with rising and falling edge relative protruding threshold combination. A synchronous decoding method was designed to reduce position uncertainty of the frame synchronization pulse and eliminate the accumulative error of time base drift, which determines the first instruction pulse position according to position of the frame synchronization pulse and decodes subsequent instruction pulse by taking current instruction pulse as new bit synchronization pulse. Special tool software was developed to tune algorithm parameters, which has a decoding success rate of about 95% for the universal coded signals. For the special coded signals with check byte, decoding success rate using the automatic threshold adjustment algorithm is as high as 99%.展开更多
A large part of our daily lives is spent with audio information. Massive obstacles are frequently presented by the colossal amounts of acoustic information and the incredibly quick processing times. This results in th...A large part of our daily lives is spent with audio information. Massive obstacles are frequently presented by the colossal amounts of acoustic information and the incredibly quick processing times. This results in the need for applications and methodologies that are capable of automatically analyzing these contents. These technologies can be applied in automatic contentanalysis and emergency response systems. Breaks in manual communication usually occur in emergencies leading to accidents and equipment damage. The audio signal does a good job by sending a signal underground, which warrants action from an emergency management team at the surface. This paper, therefore, seeks to design and simulate an audio signal alerting and automatic control system using Unity Pro XL to substitute manual communication of emergencies and manual control of equipment. Sound data were trained using the neural network technique of machine learning. The metrics used are Fast Fourier transform magnitude, zero crossing rate, root mean square, and percentage error. Sounds were detected with an error of approximately 17%;thus, the system can detect sounds with an accuracy of 83%. With more data training, the system can detect sounds with minimal or no error. The paper, therefore, has critical policy implications about communication, safety, and health for underground mine.展开更多
From 1980’s decade,the introduction of carbon composite materials in structural applications has been consistently increased in the successive generations of civil aircraft from Single Aisle to Middle-long Range to a...From 1980’s decade,the introduction of carbon composite materials in structural applications has been consistently increased in the successive generations of civil aircraft from Single Aisle to Middle-long Range to achieve a culminant point with more than 50%in structure weight in recent commercial civil aircraft.This evolution,done through successive iterations,has been possible by combining in the same time the improvement of intrinsic composite material performances and its transformation into prepreg production technologies together with the development of new manufacturing process for material lay-up automation at composite shop-floor manufacturer of aircraft composite parts.New challenges are still coming to continuously develop materials and technologies in order to pursue the production more cost-effective composite parts.Associated to higher aircraft production rate for single aisle,new challenges may force material and aircraft designers and producers to furthermore drive new products and processes introduction and new ways of transformation within in next decade of composite aircraft designs.We propose to illustrate these trends using past and recent developments and our return of experience from Hexcel on Civil Aircraft programs.展开更多
A new adaptive(automatic)time stepping algorithm,called RCA(Rate of Convergence Algorithm)is presented.The new algorithm was applied in nonlinear finite element analysis of path-dependent problems.The step size is adj...A new adaptive(automatic)time stepping algorithm,called RCA(Rate of Convergence Algorithm)is presented.The new algorithm was applied in nonlinear finite element analysis of path-dependent problems.The step size is adjusted by monitoring the estimated convergence rate of the nonlinear iterative process.The RCA algorithm is relatively simple to implement,robust and its performance is comparable to,and in some cases better than,the automatic load incrementaion algorithm existent in commercial codes.Discussions about the convergence rate of nonlinear iterative processes,an estimation of the rate and a study of the parameters of the RCA algorithm are presented.To show the capacity of the algorithm to adjust the increment size,detailed discussions based on results for different limit load analyses are presented.The results obtained by RCA algorithm are compared with those by ABAQUS?,one of the most powerful nonlinear FEA(Finite Element Analysis)commercial software,in order to verify the capability of RCA algorithm to adjust the increment size along nonlinear analyses.展开更多
Equation based TCP-friendly rate control (TFRC) protocol has been proposed to support video streaming applications. In order to improve TFRC performance in wireless channels, the link level automatic repeat request (A...Equation based TCP-friendly rate control (TFRC) protocol has been proposed to support video streaming applications. In order to improve TFRC performance in wireless channels, the link level automatic repeat request (ARQ) scheme is usually deployed. However, ARQ cannot ensure strict delay guarantees, especially over multihop links. This paper introduces a theoretical model to deduce an equation for packet size adjustment in transport layer to minimize retransmission delay by taking into con- sideration the causative reasons inducing retransmission in link layer. An enhanced TFRC (ETFRC) scheme is proposed inte- grating TFRC with variable packet size policy. Simulation results demonstrate that higher goodput, lower packet loss rate (PLR), lower frame transmission delay and jitter with good fairness can be achieved by our proposed mechanism.展开更多
基金Project(9140C860304) supported by the National Defense Key Laboratory Foundation of China
文摘Aiming at the potential presence of mixing automatic identification system(AIS) signals,a new demodulation scheme was proposed for separating other interfering signals in satellite systems.The combined iterative cross-correlation demodulation scheme,referred to as CICCD,yielded a set of single short signals based on the prior information of AIS,after the frequency,code rate and modulation index were estimated.It demodulates the corresponding short codes according to the maximum peak of cross-correlation,which is simple and easy to implement.Numerical simulations show that the bit error rate of proposed algorithm improves by about 40% compared with existing ones,and about 3 dB beyond the standard AIS receiver.In addition,the proposed demodulation scheme shows the satisfying performance and engineering value in mixing AIS environment and can also perform well in low signal-to-noise conditions.
文摘Aims: To prevent fetal damage by excess oxytocin administration of manually controlled infusion, by automatic and safe increasing infusion setting with monitoring uterine contraction and fetal heart rate. Methods: Starting infusion level was 2 milliU/ml, as oxytocin sensitivity of a pregnant uterus is unknown, to avoid hyper contraction and fetal bradycardia caused by unexpected excess oxytocin sensitivity. The infusion automatically increased with automatic monitoring of uterine contraction curve, then the increasing stopped when contraction reached to normal labor level, where the infusion level maintained, which continued until delivery, if there is no trouble. However, the infusion continued until expiring all fluid in case of insensitive uterus, where the induction was performed in another day. The infusion stopped automatically when contraction was too strong, or fetal heart rate is abnormal. Thus, oxytocin sensitive case is protected from excess contraction and fetal asphyxia. Results: Normal vaginal delivery was achieved in 28/33 cases (85%), which was more than manually controlled infusion. No case was abnormal in successful oxytocin infusion. Conclusion: The automated technique will be applied to oxytocin labor induction.
基金Supported by the China National Science and Technology Major Project(2016ZX05020005-001)
文摘Wavelet forced de-noising algorithm is suitable for denoising of unsteady drilling fluid pulse signal, including baseline drift rectification and two-stage de-noising processing of frame synchronization signal and instruction signal. Two-stage de-noising processing can reduce the impact of baseline drift and determine automatic peak detection threshold range for signal recognition by distinguishing different features of frame synchronization pulse and instruction pulse. Rising and falling edge relative protruding threshold is defined for peak detection in signal recognition, which can make full use of the degree of the signal peak change and detect peaks flexibly with rising and falling edge relative protruding threshold combination. A synchronous decoding method was designed to reduce position uncertainty of the frame synchronization pulse and eliminate the accumulative error of time base drift, which determines the first instruction pulse position according to position of the frame synchronization pulse and decodes subsequent instruction pulse by taking current instruction pulse as new bit synchronization pulse. Special tool software was developed to tune algorithm parameters, which has a decoding success rate of about 95% for the universal coded signals. For the special coded signals with check byte, decoding success rate using the automatic threshold adjustment algorithm is as high as 99%.
文摘A large part of our daily lives is spent with audio information. Massive obstacles are frequently presented by the colossal amounts of acoustic information and the incredibly quick processing times. This results in the need for applications and methodologies that are capable of automatically analyzing these contents. These technologies can be applied in automatic contentanalysis and emergency response systems. Breaks in manual communication usually occur in emergencies leading to accidents and equipment damage. The audio signal does a good job by sending a signal underground, which warrants action from an emergency management team at the surface. This paper, therefore, seeks to design and simulate an audio signal alerting and automatic control system using Unity Pro XL to substitute manual communication of emergencies and manual control of equipment. Sound data were trained using the neural network technique of machine learning. The metrics used are Fast Fourier transform magnitude, zero crossing rate, root mean square, and percentage error. Sounds were detected with an error of approximately 17%;thus, the system can detect sounds with an accuracy of 83%. With more data training, the system can detect sounds with minimal or no error. The paper, therefore, has critical policy implications about communication, safety, and health for underground mine.
文摘From 1980’s decade,the introduction of carbon composite materials in structural applications has been consistently increased in the successive generations of civil aircraft from Single Aisle to Middle-long Range to achieve a culminant point with more than 50%in structure weight in recent commercial civil aircraft.This evolution,done through successive iterations,has been possible by combining in the same time the improvement of intrinsic composite material performances and its transformation into prepreg production technologies together with the development of new manufacturing process for material lay-up automation at composite shop-floor manufacturer of aircraft composite parts.New challenges are still coming to continuously develop materials and technologies in order to pursue the production more cost-effective composite parts.Associated to higher aircraft production rate for single aisle,new challenges may force material and aircraft designers and producers to furthermore drive new products and processes introduction and new ways of transformation within in next decade of composite aircraft designs.We propose to illustrate these trends using past and recent developments and our return of experience from Hexcel on Civil Aircraft programs.
文摘A new adaptive(automatic)time stepping algorithm,called RCA(Rate of Convergence Algorithm)is presented.The new algorithm was applied in nonlinear finite element analysis of path-dependent problems.The step size is adjusted by monitoring the estimated convergence rate of the nonlinear iterative process.The RCA algorithm is relatively simple to implement,robust and its performance is comparable to,and in some cases better than,the automatic load incrementaion algorithm existent in commercial codes.Discussions about the convergence rate of nonlinear iterative processes,an estimation of the rate and a study of the parameters of the RCA algorithm are presented.To show the capacity of the algorithm to adjust the increment size,detailed discussions based on results for different limit load analyses are presented.The results obtained by RCA algorithm are compared with those by ABAQUS?,one of the most powerful nonlinear FEA(Finite Element Analysis)commercial software,in order to verify the capability of RCA algorithm to adjust the increment size along nonlinear analyses.
基金Project supported by the National Natural Science Foundation ofChina (No. 60302004) and the Natural Science Foundation of HubeiProvince (No. 2005ABA264), China
文摘Equation based TCP-friendly rate control (TFRC) protocol has been proposed to support video streaming applications. In order to improve TFRC performance in wireless channels, the link level automatic repeat request (ARQ) scheme is usually deployed. However, ARQ cannot ensure strict delay guarantees, especially over multihop links. This paper introduces a theoretical model to deduce an equation for packet size adjustment in transport layer to minimize retransmission delay by taking into con- sideration the causative reasons inducing retransmission in link layer. An enhanced TFRC (ETFRC) scheme is proposed inte- grating TFRC with variable packet size policy. Simulation results demonstrate that higher goodput, lower packet loss rate (PLR), lower frame transmission delay and jitter with good fairness can be achieved by our proposed mechanism.
