Theoretical models for designing a 220-GHz folded waveguide backward wave oscillator

In this paper, the basic equations of beam-wave interaction for designing the 220 GHz folded waveguide （FW） backward wave oscillator （BWO） are described. On the whole, these equations are mainly classified into small signal model （SSM）, large signal model （LSM）, and simplified small signal model （SSSM）. Using these linear and nonlinear one-dimensional （1D） models, the oscillation characteristics of the FW BWO of a given configuration of slow wave struc- ture （SWS） can be calculated by numerical iteration algorithm, which is more time efficient than three-dimensional （3D） particle-in-cell （PIC） simulation. The SSSM expressed by analytical formulas is innovatively derived for determining the initial values of the FW SWS conveniently. The dispersion characteristics of the FW are obtained by equivalent circuit analysis. The space charge effect, the end reflection effect, the lossy wall effect, and the relativistic effect are all considered in our models to offer more accurate results. The design process of the FW BWO tube with output power of watt scale in a frequency range between 215 GHz and 225 GHz based on these 1D models is demonstrated. The 3D PIC method is adopted to verify the theoretical design results, which shows that they are in good agreement with each other.

Research of sine waveguide slow-wave structure for a 220-GHz backward wave oscillator

A watt-class backward wave oscillator is proposed, using the concise sine waveguide slow-wave structure combined with a pencil electron beam to operate at 220 GHz. Firstly, the dispersion curve of the sine waveguide is calculated, then, the oscillation frequency and operating voltage of the device are predicted and the circuit transmission loss is calculated. Finally, the particle-in-cell simulation method is used to forecast its radiation performance. The results show that this novel backward wave oscillator can produce over 1-W continuous wave power output in a frequency range from 210 GHz to 230 GHz. Therefore, it will be considered as a very promising high-power millimeter-wave to terahertz-wave radiation source.

Cell-type continuous electromagnetic radiation system generating millimeter waves for active denial system applications

The cell-type continuous electromagnetic radiation system is a demonstration device capable of generating high-power millimeter electromagnetic waves of a specific wavelength and observing their effects on living organisms.It irradiates a biological sample placed in a 30×30×50 cm^(3)cell with electromagnetic waves in the 3.15-mm-wavelength region(with an output of≥1 W)and analyzes the temperature change of the sample.A vacuum electronic device-based coupled-cavity backward-wave oscillator converts the electron energy of the electron beam into radiofrequency(RF)energy and radiates it to the target through an antenna,increasing the temperature through the absorption of RF energy in the skin.The system causes pain and ultimately reduces combat power.A cell-type continuous electromagnetic radiation system consisting of four parts—an electromagnetic-wave generator,a highvoltage power supply,a test cell,and a system controller—generates an RF signal of≥1 W in a continuous waveform at a 95-GHz center frequency,as well as a chemical solution with a dielectric constant similar to that of the skin of a living organism.An increase of 5°C lasting approximately 10 s was confirmed through an experiment.

Investigation of Resonator BWO-Based Spectroscopy of the Atmosphere in the THz Region

This paper intends to give a code about atmospheric propagation effects affecting terahertz (THz) communication system. The main focus is on attenuation caused by atmospheric gases with the radiation transmission theory and the empirical continuum absorption based on the HITRAN database. Theoretical aspects about them are presented, emphasizing on those which deserve special attention as frequency increases. Laboratory measurements of the absorption spectra of laboratory air and major atmospheric gases mixed with water vapor in the 250 - 350 GHz frequency range at atmospheric pressure and room temperature on a basis of backward wave oscillators (BWOs) are obtained. The results of experiments are compared with the calculations. It is found that the water vapor transmittance is greater than the calculation. Data of these measurements agree with the results of analysis of atmospheric spectra with in statistical accuracy of experiments. Accurate measurements are also needed for further studies of the physics of the molecules and their interactions. The investigation makes it significant for enhancing accuracy of models of radiation propagation in the atmosphere.

Development of the relativistic backward wave oscillator with a permanent magnet

Firstly, an X-band relativistic backward wave oscillator with a low guiding magnetic field is simulated, whose output microwave power is 520 MW. Then, an experiment is carried out on an accelerator to investigate a relativistic backward wave oscillator with a permanent magnetic field whose strength is 0.46 T. When the energy of the electron is 630 keV and the current of the electron beam is 6.7 kA, a 15 ns width pulsed microwave with 510 MW output power at 8.0 GHz microwave frequency is achieved.

Theoretical investigation of a backward wave oscillator

From the linear Vlasov equation, the theoretical investigation on relativistic backward wave oscillator is performed. The relationship between the microwave power and the guiding magnetic field, which accords with the results of the particle simulation and experiments, is deduced.

Study of superradiance based on a low-voltage backward wave oscillator

According to the small size requirement for wide-band high-power microwave radiation, a superradiance backward wave oscillator （BWO） is proposed to generate such high-power microwave radiation with a low voltage （～20 kV） pulse power supply and low guiding magnet field （～0.1T）. In order to get a high-efficiency C-band superradiance BWO with a low beam voltage and a low guiding magnet field, the mechanism of superradiance in a BWO is explored in particle-in-cell simulation. With the oversized structure, the simulation shows that a microwave power of 405 kW with a frequency of 5.6 GHz and a spectrum width of 500 MHz can be obtained with a voltage of 23 kV and magnetic field of 0.1 T.