期刊文献+
共找到3篇文章
< 1 >
每页显示 20 50 100
Lumped Parameter Mass Flow Rate and Pressure Control Characteristics Model for High-Speed Pneumatic PWM on/off Valve
1
作者 向忠 胡旭东 +1 位作者 刘昊 汝晶炜 《Journal of Donghua University(English Edition)》 EI CAS 2014年第3期293-303,共11页
Aiming at solving the problem of strong coupling characteristic of the key parameters of high-speed pneumatic pulse width modulation( PWM) on / off valve, a general lumped parameter mathematical model based on the val... Aiming at solving the problem of strong coupling characteristic of the key parameters of high-speed pneumatic pulse width modulation( PWM) on / off valve, a general lumped parameter mathematical model based on the valves time periods was well developed. With this model,the mass flow rate and dynamic pressure characteristics of constant volumes controlled by high-speed pneumatic PWM on /off valves was well described. A variable flow rate coefficient model was proposed to substitute for the constant one used in most of the prior works to investigate PWM on /off valves' dynamical pressure response, and a formula for disclosing the inherent relationship among the PWM command signal,static mass flow rate,and sonic conductance of the valve was newly derived.Finally,an extensive set of analytical experimental comparisons were implemented to verify the validity of the proposed mathematica model. With the proposed model, PWM on /off valves' characteristics,such as mass flow rate,step pressure response of the valve control system,mean pressure and ripple amplitude,not only in the linear range,but also in the nonlinear range can be wel predicted; Good agreement between measured and calculated results was obtained,which proved that the model is helpful for designing a control strategy in a closed loop control system. 展开更多
关键词 lumped parameter model pneumatic on/off valve pulse width modulation(PWM) mass flow rate pressure characteristic
下载PDF
基于主动脉内血泵的集中参数模型研究 被引量:5
2
作者 谷凯云 高斌 +1 位作者 常宇 刘有军 《医用生物力学》 EI CAS CSCD 2011年第4期367-372,共6页
目的为研究主动脉内血泵出入口的压力差和血液流率之间的关系,并以此预测血泵的血流动力学参数,建立主动脉内血泵非线性集中参数模型。方法该模型依靠血泵本体参数,不包含循环系统的血流动力学参数。模型包括:电流源,与血泵转速相关,表... 目的为研究主动脉内血泵出入口的压力差和血液流率之间的关系,并以此预测血泵的血流动力学参数,建立主动脉内血泵非线性集中参数模型。方法该模型依靠血泵本体参数,不包含循环系统的血流动力学参数。模型包括:电流源,与血泵转速相关,表示被血泵叶轮推出的流率;内阻,用来模拟主动脉内血泵径向间隙之间的阻力;电感,表示流过主动脉内血泵径向间隙的血液的惯性。结果模型可模拟从肺淤血到心室塌陷等各种心脏的生理状态。通过模型得到了血泵的特征方程,方程中参数值由体外循环实验确定。结论通过比较预测血泵压力差和实际测量压力差验证特征方程准确性,结果显示误差小于5%,因此该模型能够准确预测血泵压力差。 展开更多
关键词 主动脉内血泵 集中参数模型 压力差 流率 建模 血流动力学
下载PDF
人体肺支气管树内的气流分布研究 被引量:4
3
作者 赖伟 谭小苹 裴觉民 《生物医学工程学杂志》 EI CAS CSCD 2004年第2期229-232,共4页
在 Weible的人体肺支气管树统计数据的基础上 ,参照肺解剖图形 ,运用流体网络理论建立支气管树在前 5~ 7级为不对称分叉 ,后面的分级为对称分叉的三参数集中参数模型。采用 GEAR算法求解常微分方程组 ,探讨在正常呼吸过程中气体在肺支... 在 Weible的人体肺支气管树统计数据的基础上 ,参照肺解剖图形 ,运用流体网络理论建立支气管树在前 5~ 7级为不对称分叉 ,后面的分级为对称分叉的三参数集中参数模型。采用 GEAR算法求解常微分方程组 ,探讨在正常呼吸过程中气体在肺支气管树内不同分段的压力流量分布。在此基础上探讨了支气管局部受阻时 ,肺支气管树内不同部位的压力和流量的分布状况 ,并进行了比较。该模型对认识肺支气管树在生理。 展开更多
关键词 人体 肺支气管树 气流分布 气体压力 流量分布
下载PDF
上一页 1 下一页 到第
使用帮助 返回顶部