期刊文献+
共找到5篇文章
< 1 >
每页显示 20 50 100
Gas Holdups of Small and Large Bubbles in a Large-scale Bubble Column with Elevated Pressure 被引量:1
1
作者 JINHai-bo YANGSuo-he ZHANGTong-wang TONGZe-min 《Chemical Research in Chinese Universities》 SCIE CAS CSCD 2004年第4期462-465,共4页
Gas holdups of large bubbles and small bubbles were measured by means of dynamic gas disengagement approach in the pressured bubble column with a diameter of 0.3 m and a height of 6.6 m. The effects of superficial gas... Gas holdups of large bubbles and small bubbles were measured by means of dynamic gas disengagement approach in the pressured bubble column with a diameter of 0.3 m and a height of 6.6 m. The effects of superficial gas velocity, liquid surface tension, liquid viscosity and system pressure on gas holdups of small bubbles and large bubbles were investigated. The holdup of large bubbles increases and the holdup of small bubbles decreases with an increase of liquid viscosity. Meanwhile, the holdup of large bubbles decreases with increasing the system pressure. A correlation for the holdup of small bubbles was obtained from the experimental data. 展开更多
关键词 bubble column elevated pressure large bubble small bubble holdup
下载PDF
采用压力传感技术测量鼓泡床中流体力学参数 被引量:16
2
作者 张同旺 靳海波 +2 位作者 何广湘 杨索和 佟泽民 《磁流体发电情报》 EI CAS 2004年第3期476-480,共5页
Based on the multi-class bubble model and the assumption that bubbles rise in plug flow during dynamic gas disengagement, the function between gas holdup and time was obtained by using the pressure transducing technol... Based on the multi-class bubble model and the assumption that bubbles rise in plug flow during dynamic gas disengagement, the function between gas holdup and time was obtained by using the pressure transducing technology. The plot obtained by the model agreed with the plot obtained by experiment. The pressure transducing technology is shown to be a good method for the measurement of hydrodynamics in a bubble column. The changes of gas holdup, large bubble holdup and small bubble holdup, bubble rising velocity with superficial gas velocity and liquid viscosity were obtained by using dynamic gas disengagement. 展开更多
关键词 鼓泡床 测量 流体力学参数 压力传感技术 固含率 气含率
下载PDF
加压大型鼓泡床反应器内大小气泡气含率研究 被引量:9
3
作者 张同旺 靳海波 +2 位作者 何广湘 佟泽民 朱建华 《化学工程》 CAS CSCD 北大核心 2004年第5期29-33,49,共6页
在内径0.3m、高6.6m的加压鼓泡床反应器内采用床层塌落技术测量床层内的大小气泡气含率实验。由于大小气泡上升速度不同,床层塌落曲线存在一水平段,在此基础上,详细考察了表面张力、粘度、系统压力、表观气速对大小气泡气含率的影响,得... 在内径0.3m、高6.6m的加压鼓泡床反应器内采用床层塌落技术测量床层内的大小气泡气含率实验。由于大小气泡上升速度不同,床层塌落曲线存在一水平段,在此基础上,详细考察了表面张力、粘度、系统压力、表观气速对大小气泡气含率的影响,得出大气泡气含率随粘度和表面张力升高而升高,随压力升高而降低;小气泡气含率随粘度和表面张力升高而降低,随压力升高而升高;并根据质量守恒定理,进行了解释。 展开更多
关键词 鼓泡反应器 大小气泡气含率
下载PDF
加温加压下CFD-PBM耦合模型空气-水两相流数值模拟研究 被引量:3
4
作者 张文龙 侯燕 +5 位作者 靳海波 马磊 何广湘 杨索和 郭晓燕 张荣月 《化工学报》 EI CAS CSCD 北大核心 2021年第9期4594-4606,共13页
计算流体力学与群体平衡模型(CFD-PBM)结合可有效地模拟鼓泡塔内流体行为,较准确地预测流场、相含率以及局部气泡尺寸分布。以直径100 mm、高1.3 m的加温加压鼓泡塔为模拟对象,在系统压力为1 MPa、表观气速为0.08-0.24 m/s、温度为30-16... 计算流体力学与群体平衡模型(CFD-PBM)结合可有效地模拟鼓泡塔内流体行为,较准确地预测流场、相含率以及局部气泡尺寸分布。以直径100 mm、高1.3 m的加温加压鼓泡塔为模拟对象,在系统压力为1 MPa、表观气速为0.08-0.24 m/s、温度为30-160℃条件下系统地考察了空气-水体系的表观气速、温度以及固含率对平均气含率、大小气泡气含率、气泡直径和气泡尺寸分布等参数的影响。结果表明,平均气含率的模拟结果和实验值在10%的误差范围内吻合较好;温度的变化主要影响了塔内气泡的聚并和破碎,并用聚并破碎的机理解释了温度对其流体行为的影响。 展开更多
关键词 鼓泡塔 计算流体力学 两相流 气含率 大小气泡 加温加压 固含率
下载PDF
SEBS高黏度溶液气液鼓泡塔的流体力学研究 被引量:1
5
作者 宁尚雷 陶芳芳 +3 位作者 靳海波 何广湘 杨索和 郭晓燕 《过程工程学报》 CAS CSCD 北大核心 2020年第7期779-787,共9页
针对SBS加氢反应器开发与设计,以SEBS-1650己烷溶液为液相,采用差压法和床层塌落法研究了气液鼓泡塔中高黏度溶液的流体力学行为,考察了黏度对低表面张力溶液的气含率、大小气泡气含率、大小气泡上升速度和比表面积等因素的影响。结果表... 针对SBS加氢反应器开发与设计,以SEBS-1650己烷溶液为液相,采用差压法和床层塌落法研究了气液鼓泡塔中高黏度溶液的流体力学行为,考察了黏度对低表面张力溶液的气含率、大小气泡气含率、大小气泡上升速度和比表面积等因素的影响。结果表明,随黏度增加,大气泡增多,气含率明显降低,塔内流型处于湍流区;由床层塌落曲线确定鼓泡塔内存在三种类型的气泡:大气泡、小气泡及细小气泡,随黏度增加,小气泡与细小气泡逐渐减少;黏度对大小气泡的上升速度略有影响,比表面积随黏度增加而明显降低。根据实验结果给出了大小气泡气含率与平均气含率的计算公式。 展开更多
关键词 气含率 大小气泡 鼓泡塔 气泡上升速度 改性热塑性弹性体
原文传递
上一页 1 下一页 到第
使用帮助 返回顶部