For the application of the CCD camera, the most important payload on CBERS-02, the key is to provide long-term stable radiometric calibration coefficients. Although the vicarious calibration had been proved successful...For the application of the CCD camera, the most important payload on CBERS-02, the key is to provide long-term stable radiometric calibration coefficients. Although the vicarious calibration had been proved successful, it had its limitations such as test site requirement and unsuitable for historical data. Cross-calibration is one of the alternative methods, but it needs synchro surface spectrum to achieve spectral band matching factors. Our effort is to probe the influences on these factors. Simulations with a lot of surface spectrum showed that the factors changed with the viewing geometry, atmospheric condition and surface targets. However, simulating with the same viewing geometry and atmospheric condition, the spectral band matching factors of the same or similar surface targets’ spectrum acquired from different dates and different places would like to be consistent to each other within 1%―5%. Thus, the synchro measurement data can be substituted by the same or similar target from other source. Based on this method, using the MODIS as the reference, the cross-calibration was performed for CCD camera. The research demonstrated that the traditional method with single calibration site was inappropriate for CCD camera, since the offsets for its four spectral bands were not zeros. With four calibration sites, these offsets were obtained. And the camera was detected to degrade with dates based on four times of cross-calibrations.展开更多
In order to make quantitative watercolor sensing with China-Brazil Earth Resources Satellite (CBERS-02) CCD camera, the MODIS data with higher accuracy is used to cross-calibrate the CCD camera over water targets. In ...In order to make quantitative watercolor sensing with China-Brazil Earth Resources Satellite (CBERS-02) CCD camera, the MODIS data with higher accuracy is used to cross-calibrate the CCD camera over water targets. In homogeneous clear water area, two pairs of images obtained over the same area on the same day by the two sensors are selected. The top-of-atmosphere (TOA) radiances of the multispectral bands of CCD are calculated with the water and aerosol parameters from MODIS based on a water-atmosphere radiative transfer algorithm. The stripes in CCD image that caused by unequal response of the CCD array detectors are firstly removed before making the cross-calibration. The same part of CCD detectors is selected for the calibrations in the two images to eliminate the residual error of destriping and uniformity correction for the focus plane irradiance. It is shown that the calibration results from two different images are consistent. The error of this method is about 5%.展开更多
In this paper the in-situ experiment data are collected from the Spectral Library to estimate the possible values of the primary structural parameters in each cotton growing season by statistics. Based on these values...In this paper the in-situ experiment data are collected from the Spectral Library to estimate the possible values of the primary structural parameters in each cotton growing season by statistics. Based on these values the spectra of the cotton major growing seasons were simulated and analyzed using the canopy reflectance model, SAILH. In this way we also simulated the cotton pixel spectra corresponding to CBERS-02 CCD and took them as the reference spectra for spectra fitting. Then No.143 Regiment of No.8 Agricultural Division of Xinjiang Production and Construction Corps (XPCC) was chosen as the study area, and two spectra fitting methods, Mahalanobis distance and spectra angle, were used to identify cotton pixel from CBERS-02 CCD image of the study area. At last we analyzed the effect of the calibration coefficients error on cotton identifying. The results showed that within 4% error the spectral angle classifier can still have a good performance.展开更多
Remote sensing techniques is used to quantify the total suspended matter concentration （CTSM）. In this study, we used remotely sensed data to retrieve the CTSM for the Taihu Lake, China, and developed an atmospheric...Remote sensing techniques is used to quantify the total suspended matter concentration （CTSM）. In this study, we used remotely sensed data to retrieve the CTSM for the Taihu Lake, China, and developed an atmospheric correction algorithm especially for CBERS-02B CCD data. We simulated the remote sensing reflectance （Rr~） of CCD bands using in-situ observations made in a cruise over the Taihu Lake in autumn 2004, from which a retrieval model is established with simulated Rrs（830） and measured CTSM. In addition, we applied the atmospheric correction algorithm and retrieval model to process the CCD data over the lake in 2008 and to retrieve the CTSM. The RMS relative error between the CTSM retrieved from MODIS and from the CCD images is about 42.9%, indicating that algorithms described in this paper can be used for the application of CCD data in monitoring the CTSM distribution in the Taihu Lake.展开更多
文摘For the application of the CCD camera, the most important payload on CBERS-02, the key is to provide long-term stable radiometric calibration coefficients. Although the vicarious calibration had been proved successful, it had its limitations such as test site requirement and unsuitable for historical data. Cross-calibration is one of the alternative methods, but it needs synchro surface spectrum to achieve spectral band matching factors. Our effort is to probe the influences on these factors. Simulations with a lot of surface spectrum showed that the factors changed with the viewing geometry, atmospheric condition and surface targets. However, simulating with the same viewing geometry and atmospheric condition, the spectral band matching factors of the same or similar surface targets’ spectrum acquired from different dates and different places would like to be consistent to each other within 1%―5%. Thus, the synchro measurement data can be substituted by the same or similar target from other source. Based on this method, using the MODIS as the reference, the cross-calibration was performed for CCD camera. The research demonstrated that the traditional method with single calibration site was inappropriate for CCD camera, since the offsets for its four spectral bands were not zeros. With four calibration sites, these offsets were obtained. And the camera was detected to degrade with dates based on four times of cross-calibrations.
文摘In order to make quantitative watercolor sensing with China-Brazil Earth Resources Satellite (CBERS-02) CCD camera, the MODIS data with higher accuracy is used to cross-calibrate the CCD camera over water targets. In homogeneous clear water area, two pairs of images obtained over the same area on the same day by the two sensors are selected. The top-of-atmosphere (TOA) radiances of the multispectral bands of CCD are calculated with the water and aerosol parameters from MODIS based on a water-atmosphere radiative transfer algorithm. The stripes in CCD image that caused by unequal response of the CCD array detectors are firstly removed before making the cross-calibration. The same part of CCD detectors is selected for the calibrations in the two images to eliminate the residual error of destriping and uniformity correction for the focus plane irradiance. It is shown that the calibration results from two different images are consistent. The error of this method is about 5%.
文摘In this paper the in-situ experiment data are collected from the Spectral Library to estimate the possible values of the primary structural parameters in each cotton growing season by statistics. Based on these values the spectra of the cotton major growing seasons were simulated and analyzed using the canopy reflectance model, SAILH. In this way we also simulated the cotton pixel spectra corresponding to CBERS-02 CCD and took them as the reference spectra for spectra fitting. Then No.143 Regiment of No.8 Agricultural Division of Xinjiang Production and Construction Corps (XPCC) was chosen as the study area, and two spectra fitting methods, Mahalanobis distance and spectra angle, were used to identify cotton pixel from CBERS-02 CCD image of the study area. At last we analyzed the effect of the calibration coefficients error on cotton identifying. The results showed that within 4% error the spectral angle classifier can still have a good performance.
基金Supported by the National Basic Research Program of China (973 Program) (No. 2009CB723903)
文摘Remote sensing techniques is used to quantify the total suspended matter concentration （CTSM）. In this study, we used remotely sensed data to retrieve the CTSM for the Taihu Lake, China, and developed an atmospheric correction algorithm especially for CBERS-02B CCD data. We simulated the remote sensing reflectance （Rr~） of CCD bands using in-situ observations made in a cruise over the Taihu Lake in autumn 2004, from which a retrieval model is established with simulated Rrs（830） and measured CTSM. In addition, we applied the atmospheric correction algorithm and retrieval model to process the CCD data over the lake in 2008 and to retrieve the CTSM. The RMS relative error between the CTSM retrieved from MODIS and from the CCD images is about 42.9%, indicating that algorithms described in this paper can be used for the application of CCD data in monitoring the CTSM distribution in the Taihu Lake.
