Characteristic Test Study on Bearing Capacity of Suction Caisson Foundation Under Vertical Load

Suction caisson foundations are often subjected to vertical uplift loads,but there are still no wide and spread engineering specifications on design and calculation method for uplift bearing capacity of suction caisson foundation.So it is important to establish an uplift failure criterion.In order to study the uplift bearing mechanism and failure mode of suction caisson foundation,a series of model tests were carried out considering the effects of aspect ratio,soil permeability and loading mode.Test results indicate that the residual negative pressure at the top of caisson is beneficial to enhance uplift bearing capacity.The smaller the permeability coefficient is,the higher the residual negative pressure will be.And the residual negative pressure is approximately equal to the water head that causes seepage in the caisson.When the load reaches the ultimate bearing capacity,both the top and bottom negative pressures are smaller than Su and both the top and bottom reverse bearing capacity factors are smaller than 1.0 in soft clay.Combined the uplift bearing characteristics of caisson in sandy soil and soft clay,the bearing capacity composition and the calculation method are proposed.It can provide a reference for the engineering design of suction caisson foundation under vertical load.

Upper Bound Solutions for Uplift Ultimate Bearing Capacity of Suction Caisson Foundation

Suction caisson foundation derives most of their uplift resistance from passive suction developed during the pullout movement. It was observed that the passive suction generated in soil at the bottom of the caisson and the failure mode of suction caisson foundation subjecting pullout loading behaves as a reverse compression failure mechanism.The upper bound theorems have been proved to be a powerful method to find the critical failure mechanism and critical load associated with foundations, buried caissons and other geotechnical structures. However, limited attempts have been reported to estimate the uplift bearing capacity of the suction caisson foundation using the upper bound solution. In this paper, both reverse failure mechanisms from Prandtl and Hill were adopted as the failure mechanisms for the computation of the uplift bearing capacity of the suction caisson. New equations were proposed based on both failure mechanisms to estimate the pullout capacity of the suction caisson. The proposed equations were verified by the test results and experimental data from published literature. And the two solutions agree reasonably well with the other test results. It can be proved that both failure mechanisms are reasonably and more consistent with the actual force condition.

Numerical analysis on bearing capacity of middle pylon caisson foundation of Taizhou Bridge

Because of the computation difficulty of the beating capacity of large underwater caisson foundation on thick overburden layer ground, the geotechnieal software FLAC3D was utilized in the 3D numerical analysis on the bearing capacity of middle pylon foundation. From the computational results, it is concluded that the caisson foundation has a good bearing capacity on thick overburden layer ground and the beating capacity can be improved assuming that the soil near the area of basal comer is reinforced.

Study on Unloading Creep Characteristics of the Soil and Application of the Stress-Dependent Creep Model in Suction Caisson Foundation

As the anchoring foundation of the tension leg platform(TLP),suction caisson foundation is subjected to the long-term vertical pullout loads.But there are few studies on the mechanism of the unloading creep of soft clay and long-term uplift bearing capacity of suction caisson foundations.To address this problem,unloading creep tests of soft clay were carried out to analyze the strain development with time under different confining pressures.The test results show that the creep curve rapidly develops in the early stage and tends to stabilize in the later stage.The unloading deviator stress is higher,the unloading creep deformation is greater and the soft clay has typical nonlinear creep characteristics.Therefore,by introducing the creep model and considering the influence of the deviator stress,the stress-dependent Merchant model is proposed to describe the unloading creep of soft clay.Then,the stress-dependent Merchant model is extended to a three-dimension constitutive model,and a finite element subroutine is developed to establish a finite element analysis method for analyzing the long-term uplift capacity of suction caisson foundations and validated with the long-term uplift bearing capacity results of caisson model.

Failure envelope of a caisson foundation under combined vertical,horizontal and moment loadings

To investigate the bearing capacity of a caisson foundation under combined vertical,horizontal and moment loadings,the three-dimensional finite element analyses of a circular caisson foundation in homogenous sandy soil subjected to combined loadings are conducted.The caisson model has a depth to breadth ratio equaling one,and a soil-caisson interface friction coefficientμ=0.3.First,the responses of caisson foundations under uniaxial vertical loading V,horizontal loading H and moment loading M are examined.Moreover,the responses of caisson foundations under combined vertical-horizontal V-H,vertical-moment V-M and horizontal-moment H-M load space are studied and presented using normalized failure envelopes generated by the load-controlled method.Subsequently,the bearing behavior of caisson foundations under combined vertical-horizontal-moment V-H-M load space,as well as the kinematic mechanisms accompanying the failure under uniaxial and combined loading,are addressed and presented for different vertical load ratios V/Vu.Finally,three equations that approximate the three-dimensional shape of the failure locus are proposed,which provides a convenient means of calculating the bearing capacity of a caisson foundation subjected to uniaxial and combined vertical,horizontal and moment loadings.

Dynamic behavior of laterally loaded caisson foundations based on different cushion types: an experimental and theoretical study

Bridge foundations located in deep water are usually subjected to horizontal dynamic loads and moments which may be caused by the wind, waves, earthquake, and the possibility of boat crashing or vehicle braking. Caisson foundations based on gravel or sand cushions are a new type of deep-water foundation for bridges, suitable for meizoseismal areas. In this paper, harmonic horizontal excitation tests for the study of the lateral dynamic response of caisson foundations based on cushion layers are described. Different lateral loads and two different cushion types are considered. The results show that the lateral dynamic responses of caisson foundations based on sand and gravel cushions both show strong nonlinear characteristics, and the resonant frequency of the foundation decreases with the increase of the excitation force. The dynamic displacement of a foundation based on a sand cushion is far less than that based on a gravel cushion, and the rate of decrease of the resonant frequency of a foundation based on a gravel cushion is faster than that of a foundation based on a sand cushion under the same conditions. Under dynamic loading the gravel cushion can more effectively dissipate vibration energy and isolate the vibration, than the sand cushion can. A simplified nonlinear analysis method is proposed to simulate the lateral dynamic response of caisson foundations, and the predicted response shows a reasonable match with the results observed in laboratory tests. Scaling laws have also been applied in this small-scale vibration model test to predict the dynamic behavior of the prototype foundation.

Calculation Method of Wave Forces on Large Round-Ended Caisson Foundation

This paper presents an analytical formula for estimating the longitudinal wave forces on a large roundended caisson foundation. The establishment of the formula is based on the superposition of the theoretical formula of wave forces on a large circular cylinder and the empirical formula of wave forces on a large rectangular cylinder. With the formula transformed into an inertial force form, a specific inertia coefficient with an exact expression is extracted from the formula. The numerical calculations of the wave forces on round-ended cylinders are carried out by the boundary-element method. The undetermined coefficients in the expression of the inertial coefficient are determined by the numerical results. It is obvious that the numerical values can be well expressed by the computation values from the established formula. By a model experiment carried out in laboratory wave flume, the correctness of the analytical formula is further verified by the measured wave forces on a test model of a round-ended bridge caisson foundation. The comparison shows that the experimental forces can be approximately estimated by this simple calculation method.

Model testing of tripod caisson foundations in silty clay subjected to eccentric lateral loads

In this study,model tests were conducted to investigate the bearing capacities of tripod caisson foundations subjected to eccentric lateral loads in silty clay.Lateral load–rotation curves of five eccentric-shaped tripod suction foundations were plotted to analyze the bearing capacities at different loading angles.It was observed that the loading angle significantly influenced the bearing capacity of the foundations,particularly for eccentric tripod caisson foundations.Compared with eccentric tripod caisson foundations,the traditional tripod foundation has a relatively high ultimate lateral capacity at the omnidirectional loading angle.By analyzing the displacement of the caissons,a formula for the rotational center of the tripod caisson foundation subjected to an eccentric lateral load was derived.The depth of the rotation center was 0.68–0.92 times the height of the caisson when the bearing capacity reached the limit.Under the undrained condition,suction was generated under the lid of the“up-lift”caisson,which helps resist lateral forces from the wind and waves.

Technical research on control of caisson construction for the middle tower foundation of Taizhou Bridge

The real-time informational monitoring system is adopted in the construction of middle tower foundation of Taizhou Bridge for the first time. The geometric state of the caisson, the stress of upstream and downstream anchorage cables, underwater topography, the drag forces of the caisson cutting edge and frictional resistances of the sidewall and etc. are monitored in real time. According to the synthesized data analysis and decision-making system, the spatial states of the caisson are adjusted in time to locate and embed the deep water caisson precisely. The offset error of the caisson is less than 30 cm and the vertical error is 1/363 at the final stage. The control technology for construction of large caisson under deep water is concluded and would be helpful for the construction of bridge foundation in the future.

Application of bi-directional static loading test to deep foundations

Bi-directional static loading test adopting load cells is widely used around the world at present, with increase in diameter and length of deep foundations. In this paper, a new simple conversion method to predict the equivalent pile head load-settlement curve considering elastic shortening of deep foundation was put forward according to the load transfer mechanism. The proposed conversion method was applied to root caisson foundation in a bridge and to large diameter pipe piles in a sea wind power plant. Some new load cells, test procedure, and construction technology were adopted based on the applications to different deep foundations, which could enlarge the application scopes of bi-directional loading test. A new type of bi-directional loading test for pipe pile was conducted, in which the load cell was installed and loaded after the pipe pile with special connector has been set up. Unlike the conventional bi-directional loading test, the load cell can be reused and shows an evident economic benefit.

Vibration mechanism research of large-scale and deep-water caisson

According to the construction method of Taizhou Bridge, numerical simulation is conducted to analyze the vibration of caisson under wind and water flows to determine the main factors of the caisson vibration. Meanwhile, the localization system of caissons and anchors of Taizhou Bridge is modeled in order to summarize the vibration mechanism of caissons under deep-water and jet-flow condition, and further pertinent vibration-control measures are proposed. The obtained results are well verified in engineering practice, and consequently the safety risk of positioning the caisson is reduced.

Design of bridges against large tectonic deformation

The engineering community has devoted much effort to understanding the response of soil-structure systems to seismic ground motions, but little attention to the effects of an outcropping fault offset. The 1999 earthquakes of Turkey and Taiwan, offering a variety of case histories of structural damage due to faulting, have （re）fueled the interest on the subject. This paper presents a methodology for design of bridges against tectonic deformation. The problem is decoupled in two analysis steps： the first （at the local level） deals with the response of a single pier and its foundation to fault rupture propagating through the soil, and the superstructure is modeled in a simplified manner; and the second （at the global level） investigates detailed models of the superstructure subjected to the support （differential） displacements of Step 1. A parametric study investigates typical models of viaduct and overpass bridges, founded on piles or caissons. Fixed-head piled foundations are shown to be rather vulnerable to faulting-dnduced deformation. End-bearing piles in particular are unable to survive bedrock offsets exceeding 10 cm. Floating piles perform better, and if combined with hinged pile-to-cap connections, they could survive much larger offsets. Soil resilience is beneficial in reducing pile distress. Caisson foundations are almost invariably successful. Statically-indeterminate superstructures are quite vulnerable, while statically-determinate are insensitive （allowing differential displacements and rotations without suffering any distress）. For large-span cantilever-construction bridges, where a statically determinate system is hardly an option, inserting resilient seismic isolation bearings is advantageous as long as ample seating can prevent the deck from falling off the supports. An actual application of the developed method is presented for a major bridge, demonstrating the feasibility of design against tectonic deformation.