Active source monitoring at the Wenchuan fault zone:coseismic velocity change associated with aftershock event and its implication

With the improvement of seismic observation system, more and more observations indicate that earthquakes may cause seismic velocity change. However, the amplitude and spatial distribution of the velocity variation remains a controversial issue. Recent active source monitoring carried out adjacent to Wenchuan Fault Scientific Drilling （WFSD） revealed unambiguous coseismic velocity change associated with a local M8 5.5 earthquake. Here, we carry out forward modeling using two-dimensional spectral element method to further investigate the amplitude and spatial distribution of observed velocity change. The model is well constrained by results from seismic reflection and WFSD coring. Our model strongly suggests that the observed coseismic velocity change is localized within the fault zone with width of ~ 120 m rather than dynamic strong ground shaking. And a velocity decrease of -2.0 % within the fault zone is required to fit the observed travel time delay distribution, which coincides with rock mechanical experiment and theoretical modeling.

Monitoring of velocity changes based on seismic ambient noise: A brief review and perspective

Over the past two decades,the development of the ambient noise cross-correlation technology has spawned the exploration of underground structures.In addition,ambient noise-based monitoring has emerged because of the feasibility of reconstructing the continuous Green’s functions.Investigating the physical properties of a subsurface medium by tracking changes in seismic wave velocity that do not depend on the occurrence of earthquakes or the continuity of artificial sources dramatically increases the possibility of researching the evolution of crustal deformation.In this article,we outline some state-of-the-art techniques for noise-based monitoring,including moving-window cross-spectral analysis,the stretching method,dynamic time wrapping,wavelet cross-spectrum analysis,and a combination of these measurement methods,with either a Bayesian least-squares inversion or the Bayesian Markov chain Monte Carlo method.We briefly state the principles underlying the different methods and their pros and cons.By elaborating on some typical noisebased monitoring applications,we show how this technique can be widely applied in different scenarios and adapted to multiples scales.We list classical applications,such as following earthquake-related co-and postseismic velocity changes,forecasting volcanic eruptions,and tracking external environmental forcing-generated transient changes.By monitoring cases having different targets at different scales,we point out the applicability of this technology for disaster prediction and early warning of small-scale reservoirs,landslides,and so forth.Finally,we conclude with some possible developments of noise-based monitoring at present and summarize some prospective research directions.To improve the temporal and spatial resolution of passive-source noise monitoring,we propose integrating different methods and seismic sources.Further interdisciplinary collaboration is indispensable for comprehensively interpreting the observed changes.

Spatio-temporal variations of shallow seismic velocity changes in Salton Sea Geothermal Field,California in response to large regional earthquakes and long-term geothermal activities

We measure spatio-temporal variations of seismic velocity changes in Salton Sea Geothermal Field,California based on cross correlations of daily seismic traces recorded by a borehole seismic network from December 2007 to January 2014.We find clear co-seismic velocity reductions during the 2010 M 7.2 El Mayor–Cucapah,Mexico earthquake at~100 km further south,followed by long-term recoveries.The co-seismic reductions are larger with longer post-seismic recoveries in higher frequency bands,indicating that material damage and healing process mostly occurred in the shallow depth.In addition,the co-seismic velocity reductions are larger for ray paths outside the active fluid injection/extraction regions.The ray paths inside injection/extraction regions are associated with smaller co-seismic reductions,but subtle long-term velocity increases.We also build 3D transient water flow models based on monthly injection/extraction rates,and find correlations between several water flow parameters and co-seismic velocity reductions.We interpret the relative lack of co-seismic velocity changes within the geothermal region as unclogging of fracture network due to persistent fluid flows of geothermal production.The long-term velocity increase is likely associated with the ground water depletion and subsidence due to net production.

Preliminary results on a near-real-time rock slope damage monitoring system based on relative velocity changes following the September 5,2022 M_(S) 6.8 Luding,China earthquake

Relative seismic velocity change(dv/v)is important for monitoring changes in subsurface material properties and evaluating earthquake-induced rock slope damage in a geological disaster-prone region.In this paper,we present a rapid damage assessment on three slow-moving rock slopes by measuring dv/v decrease caused by the 2022 M_(S) 6.8 Luding earthquake in Southwest China.By applying the stretching method to the cross-correlated seismic wavefields between sensors installed on each slope,we obtain earthquake-induced dv/v decreases of~2.1%,~0.5%,and~0.2%on three slopes at distances ranging from~86 to~370 km to the epicenter,respectively.Moreover,based on seismic data recorded by 16 sensors deployed on the rock slope at a distance of~370 km away from the epicenter,a localized dv/v decease region was observed at the crest of the slope by calculating the spatial dv/v images before and after the earthquake.We also derive an empirical in situ stress sensitivity of -7.29×10^(-8)/Pa by relating the dv/v change to the measured peak dynamic stresses.Our results indicate that a rapid dv/v assessment not only can help facilitate on-site emergency response to earthquakeinduced secondary geological disasters but also can provide a better understanding of the subsurface geological risks under diverse seismic loadings.

Comparative Study on Two Methods for Measuring Wave Velocity Change of Crustal Medium Based on Large Volume Airgun Excitation Data

This paper proposes the application of dynamic programming method to calculate the relative change of wave velocities and compares its similarities and differences with the cross-correlation delay estimation method based on interference.The results show that:①the trend of wave velocities obtained by cross-correlation method and dynamic programming method are consistent.Besides,it is considered that the calculated result using cross-correlation delay method is reliable.②Compared with the cross-correlation delay method,the calculated result of the dynamic programming method has a magnifying effect and is more sensitive to small disturbances.③Under ideal conditions,the wave velocity change trend calculated by P-wave and S-wave phase should be consistent.In addition,the cross-correlation delay method is used to calculate the wave velocity change.Under appropriate conditions,the process of recovering from the suspected wave velocity before the M_L1.1 earthquake near the airgun source can be observed.

Using Ambient Noise to Study the Seismic Velocity Changes Caused by the Rise and Fall of the Water Level in the Zipingpu Reservoir Region

We study the feature of media changes beneath the Zipingpu reservoir and discuss the process of permeation with the water level rise and fall of the reservoir from January 2005 to January 2008 from ambient noise cross correlation by using continuous seismic data recorded by the stations of Zipingpu seismic network and YZP station. A moving-window cross-spectrum technique has been used to calculate the relative seismic velocity changes between station pairs. Results revealed an obvious relationship between relative seismic velocity, and the water level changes with a time delay that may be caused by permeation during three main impoundments and two large scale disemboguements. Impoundment generates a fast and large impact on the superficial layer, and the changes of seismic velocity is the result of increased pressure and permeation during the impoundment. At the first impoundment, the main effect factor is pressure. During the next two process of impoundment, permeation becomes the main effect factor, affecting the fault at a depth of about 8kin.

Multi-decadal variations in glacier flow velocity and the influencing factors of Urumqi Glacier No.1 in Tianshan Mountains, Northwest China

Urumqi Glacier No. 1 is a representative glacier in the inland areas of Central Asia and is the only Chinese reference glacier in the World Glacier Monitoring Service. In this study, we explored multi-decadal variations in the flow velocity of the glacier and the influencing factors based on continuous field observations and path coefficient analysis. Results show that the glacier flow velocity decreased from 5.5 m/a in 1980/1981 to 3.3 m/a in 2010/2011. The annual variation in the direction of glacier flow velocity in the western branch and eastern branch was less than 1°–3°, and the change of glacier flow velocity in the western branch was more dramatic than that in the eastern branch. Glacier flow velocity was influenced by glacier morphology（including glacier area, glacier length, and ice thickness）, glacier mass balance and local climate conditions（air temperature and precipitation）, the glacier morphology being the leading factor. The long-term flow velocity data set of Urumqi Glacier No. 1 contributes to a better understanding of glacier dynamics within the context of climatic warming.

Monitoring seismic velocity changes in the Dongtan Coal Mine using ambient noise correlation

This study analyzed ambient seismic noise using the MSNoise package to monitor temporal changes in the underground seismic wave velocity in Mining Area 6 of the Dongtan Coal Mine in China.The data was recorded continuously over 76 days by 7 three-component stations and 10 single-component microseismic stations deployed in Dongtan Coal Mine,with station spacing ranging from 0.1 km to approximately 3 km.Using the causal and non-causal components of the Z-component cross-correlation function,along with moving-window cross-spectrum analysis and cumulative calculations with a 5-day window overlay,stable seismic velocity changes were obtained in the frequency band of 0.1 to 2 Hz.We found a correlation between the timing of average velocity changes and seismic events caused by underground mining processes.In particular,when the relative seismic velocity increased by 0.23%,larger energy minequakes typically occurred.This study shows that ambient noise correlation has great potential for predicting minequakes,guiding pressure-relief production,and providing warnings about the impact of overburden pressure.

Changes of the acoustic modal phase velocity,group velocity and interference distance in an eddy

Using the modal dispersion equation with the phase-integral approaches, and con-sidering an eddy (or water mass) as a sound channel disturbance, the effects of the undisturbed channel, cold-core eddy and warm-core eddy on the acoustic propagation characteristics are dis-cussed. According to the solutions of the dispersion equation, the relation between the modal Parameters (phase velocity, group velocity and interference distance) and the eddy intensity is obtained. When the plane wave (with an incident angle a) travels toward the center of a warm-core eddy (disturbed intensity BM ) 'double channel phenomenon' will take place in case of sin2 α < BM < 2(1 - cosα), and then the modal phase velocity and interference distance will have anomalous changes which are completely different from the case of the cold-core eddy.