A simple single-stage AC/DC converter circuit with active clamp is presented. The operation theory and state are analyzed. The experimental results show that the voltage across main switch can be clamped to a certain ...A simple single-stage AC/DC converter circuit with active clamp is presented. The operation theory and state are analyzed. The experimental results show that the voltage across main switch can be clamped to a certain value,and zero voltage switching (ZVS) can be achieved. The voltage stress and switching loss are both decreased. In range of the whole load,power factors can be always more than 97%,and the highest efficiency can reach 88%.展开更多
A new family of converters,high-performance AC/DC power factor correction(PFC) switching converters with one-cycle control technology and active floating-charge technology,was derived and experimentally verified.The t...A new family of converters,high-performance AC/DC power factor correction(PFC) switching converters with one-cycle control technology and active floating-charge technology,was derived and experimentally verified.The topology of a single-phase CCM and DCM Boost-PFC switching converter was also analyzed.Its operating prniciples and control methods were expounded.Based on these,a new type of AC/DC switching converter circuits for PFC combined with one-cycle control technology was presented herein.The proposed AC/DC switching converter significantly helps improve the converter efficiency and its power factor value.展开更多
This paper discusses a novel boost single-phase active AC-DC converters, named low-end semi-controlled bridge AC-DC converter. By analysis, its topology and principle can be derived from the conventional single-phase ...This paper discusses a novel boost single-phase active AC-DC converters, named low-end semi-controlled bridge AC-DC converter. By analysis, its topology and principle can be derived from the conventional single-phase power factor corrector （ PFC）. But it has also some differences, such as power device positions, inductor type, input voltage waveform detection and induction current detection, so its design is also different. The converter is implemented by employing two current detection approaches, i.e., current transformer detection and shunt resistor detection. Consequently, it can provide a steady DC output voltage with a low voltage ripple, approximately unitary input power factor and 2.5 kW output power. The experimental results show validity of the theoretical analysis.展开更多
Dimmers are very widely applied in theatres,cinemas,dancing-parties, auditoriums and signal systems.They are usually supplied by single-stage AC/AC converters in the past with voltage regulation technique with the dis...Dimmers are very widely applied in theatres,cinemas,dancing-parties, auditoriums and signal systems.They are usually supplied by single-stage AC/AC converters in the past with voltage regulation technique with the disadvantages of high total harmonic distortion,low power factor and poor power transfer efficiency.This paper introduces a novel method-DC-modulation that implements DC/DC conversion technology into AC/AC converters.The DC-modulated single-stage PFC AC/AC converters effectively improved the power factor up to 0.999 and the power transfer efficiency up to 97.8 %.The experimental results verified our design and calculation.This technique will be widely used in light dimming and other industrial applications.展开更多
A novel topology of Integrated Boost-SEPIC (IBS) AC-DC converter using common part sharing method (CPSM) has been proposed in this paper. Conventional boost converters with bridge rectifier configuration are inefficie...A novel topology of Integrated Boost-SEPIC (IBS) AC-DC converter using common part sharing method (CPSM) has been proposed in this paper. Conventional boost converters with bridge rectifier configuration are inefficient due to limited voltage step-up ratio which may not be applicable for high step-up applications as in the case of micro generators. The proposed IBS topology is based on the common part sharing method capable of operating both for positive and negative half cycle of the input signal. Result and simulation were conducted using PSIM environment. The proposed AC-DC IBS topology eliminates the requirement of bridge rectifier achieving high efficiency (about 99%), improved power factor (0.75, leading) and lower THD (about 38.8%) which is within IEEE standard.展开更多
文中提出一种新型单级式隔离AC-DC变换器及控制方案。所提结构在不改变图腾柱无桥功率因数校正(totem pole bridge-free power factor correction,TP-PFC)和双向全桥(dual active bridge,DAB)两级式AC-DC变换器特性的前提下,将TP-PFC高...文中提出一种新型单级式隔离AC-DC变换器及控制方案。所提结构在不改变图腾柱无桥功率因数校正(totem pole bridge-free power factor correction,TP-PFC)和双向全桥(dual active bridge,DAB)两级式AC-DC变换器特性的前提下,将TP-PFC高频桥臂和DAB原边侧第一个桥臂进行开关复用,减小了开关器件数目。同时,相较于TP-PFC和DAB两级式AC-DC变换器,取消了直流母线电解电容并且抑制了交流电感电流尖峰。利用其拓扑特点及所提出的控制方案,实现了拓扑开关器件的全范围软开关。首先详细分析所提拓扑结构的工作特性,包括工作模态、拓扑优点、功率特性及软开关特性;其次基于对拓扑的分析,提出控制简单的控制策略;最后,对所提拓扑结构及控制方案进行实验验证。展开更多
提出一种适用于V2G(Vehicle tǒgrid,VZG)和电网-蓄电池储能等系统的单级双向隔离AC-DC变换器。该变换器可实现高效率、高功率密度,及能量双向传输。该文介绍该变换器的工作原理、功率传输特性,分析并设计软开关ZVS(zero voltage switch...提出一种适用于V2G(Vehicle tǒgrid,VZG)和电网-蓄电池储能等系统的单级双向隔离AC-DC变换器。该变换器可实现高效率、高功率密度,及能量双向传输。该文介绍该变换器的工作原理、功率传输特性,分析并设计软开关ZVS(zero voltage switching,ZVS)的实现,最终可在宽增益范围和全负载情况下实现软开关,并制作一台500 W的实验样机进行验证。展开更多
文摘A simple single-stage AC/DC converter circuit with active clamp is presented. The operation theory and state are analyzed. The experimental results show that the voltage across main switch can be clamped to a certain value,and zero voltage switching (ZVS) can be achieved. The voltage stress and switching loss are both decreased. In range of the whole load,power factors can be always more than 97%,and the highest efficiency can reach 88%.
文摘A new family of converters,high-performance AC/DC power factor correction(PFC) switching converters with one-cycle control technology and active floating-charge technology,was derived and experimentally verified.The topology of a single-phase CCM and DCM Boost-PFC switching converter was also analyzed.Its operating prniciples and control methods were expounded.Based on these,a new type of AC/DC switching converter circuits for PFC combined with one-cycle control technology was presented herein.The proposed AC/DC switching converter significantly helps improve the converter efficiency and its power factor value.
文摘This paper discusses a novel boost single-phase active AC-DC converters, named low-end semi-controlled bridge AC-DC converter. By analysis, its topology and principle can be derived from the conventional single-phase power factor corrector （ PFC）. But it has also some differences, such as power device positions, inductor type, input voltage waveform detection and induction current detection, so its design is also different. The converter is implemented by employing two current detection approaches, i.e., current transformer detection and shunt resistor detection. Consequently, it can provide a steady DC output voltage with a low voltage ripple, approximately unitary input power factor and 2.5 kW output power. The experimental results show validity of the theoretical analysis.
文摘Dimmers are very widely applied in theatres,cinemas,dancing-parties, auditoriums and signal systems.They are usually supplied by single-stage AC/AC converters in the past with voltage regulation technique with the disadvantages of high total harmonic distortion,low power factor and poor power transfer efficiency.This paper introduces a novel method-DC-modulation that implements DC/DC conversion technology into AC/AC converters.The DC-modulated single-stage PFC AC/AC converters effectively improved the power factor up to 0.999 and the power transfer efficiency up to 97.8 %.The experimental results verified our design and calculation.This technique will be widely used in light dimming and other industrial applications.
文摘A novel topology of Integrated Boost-SEPIC (IBS) AC-DC converter using common part sharing method (CPSM) has been proposed in this paper. Conventional boost converters with bridge rectifier configuration are inefficient due to limited voltage step-up ratio which may not be applicable for high step-up applications as in the case of micro generators. The proposed IBS topology is based on the common part sharing method capable of operating both for positive and negative half cycle of the input signal. Result and simulation were conducted using PSIM environment. The proposed AC-DC IBS topology eliminates the requirement of bridge rectifier achieving high efficiency (about 99%), improved power factor (0.75, leading) and lower THD (about 38.8%) which is within IEEE standard.
文摘文中提出一种新型单级式隔离AC-DC变换器及控制方案。所提结构在不改变图腾柱无桥功率因数校正(totem pole bridge-free power factor correction,TP-PFC)和双向全桥(dual active bridge,DAB)两级式AC-DC变换器特性的前提下,将TP-PFC高频桥臂和DAB原边侧第一个桥臂进行开关复用,减小了开关器件数目。同时,相较于TP-PFC和DAB两级式AC-DC变换器,取消了直流母线电解电容并且抑制了交流电感电流尖峰。利用其拓扑特点及所提出的控制方案,实现了拓扑开关器件的全范围软开关。首先详细分析所提拓扑结构的工作特性,包括工作模态、拓扑优点、功率特性及软开关特性;其次基于对拓扑的分析,提出控制简单的控制策略;最后,对所提拓扑结构及控制方案进行实验验证。
文摘提出一种适用于V2G(Vehicle tǒgrid,VZG)和电网-蓄电池储能等系统的单级双向隔离AC-DC变换器。该变换器可实现高效率、高功率密度,及能量双向传输。该文介绍该变换器的工作原理、功率传输特性,分析并设计软开关ZVS(zero voltage switching,ZVS)的实现,最终可在宽增益范围和全负载情况下实现软开关,并制作一台500 W的实验样机进行验证。
