Development of timer based on liquid level measurement system

This paper describes the design and development of the timer based on liquid level measurement system in which timer 555 is used in astable mode. The capacitor charging time i. e. the ON time pulse width of the timer output waveform which is measured using a digital storage oscillator （DSO）,is linearly proportional to the capacitance of a co-axial cylindrical capacitive transducer, and this capacitance once again linearly varies with the change in liquid level. Hence, we obtain a linear relationship between the liquid level and the capacitor charging time. The main advantages of this developed system are linear input-output relationship, small in size, easily portable, cost effective, and independent on the ambient temperature effect. The system can also be exploited to measure dielectric constant of liquid or solid in various process industries.

Application of Parallel Resonant Circuit in Modulator Charging Power Supply

A novel high voltage switching circuit with parallel resonant topology is analyzed.Without adding other resonant components,this circuit makes full use of the transformer leakage inductance and winding capacitance so as to reduce the influence of the transformer parasitic parameter.Using device CD4046 to realize the switching control of MOS,this circuit can realize the constant-current charging to capacitor by operating the above resonance.The operating process of the circuit is analyzed,and the power calculation and some practical waveforms are given.

A novel CMOS charge-pump circuit with current mode control 110mA at 2.7V for telecommunication systems

This paper presents a novel organization of switch capacitor charge pump circuits based on voltage doubler structures. Each voltage doubler takes a DC input and outputs a doubled DC voltage. By cascading voltage doublers the output voltage increases up to 2 times. A two-phase voltage doubler and a multiphase voltage doubler structures are discussed and design considerations are presented. A simulator working in the Q-V realm was used for simplified circuit level simulation. In order to evaluate the power delivered by a charge pump, a resistive load is attached to the output of the charge pump and an equivalent capacitance is evaluated. To avoid the short circuit during switching, a clock pair generator is used to achieve multi-phase non-overlapping clock pairs. This paper also identifies optimum loading conditions for different configurations of the charge pumps. The proposed charge-pump circuit is designed and simulated by SPICE with TSMC 0.35-μm CMOS technology and operates with a 2.7 to 3.6 V supply voltage. It has an area of 0.4 mm^2; it was designed with a frequency regulation of 1 MHz and internal current mode to reduce power consumption.

A cubic triboelectric generator as a self-powered orientation sensor

Recently, triboelectric generator(TEG) has attracted a lot of attention due to its high output voltage and low-cost fabrication process. Here, a novel cubic TEG box is designed, which has separated electrodes on different surfaces. Thanks to the specially designed structure, it can scavenge vibration energy from all directions. Firstly the device is investigated through finite element method(FEM) simulation. Then the device is evaluated by experiments. The measuremental results show that this device can generate an amount of 25 n C charge during once shake by charging a 10 n F capacitor. Besides, an output voltage about 100 V is obtained, which is able to directly light up several light-emitting diodes(LEDs) simultaneously. At last, the device is utilized as a self-powered orientation sensor, which shows explicit directivity. This work extends the applications of TEG for ambient vibration energy harvesting techniques and the self-powered orientation sensor.