The development of low-temperature solid oxide fuel cells(LT-SOFCs)is of significant importance for realizing the widespread application of SOFCs.This has stimulated a substantial materials research effort in developi...The development of low-temperature solid oxide fuel cells(LT-SOFCs)is of significant importance for realizing the widespread application of SOFCs.This has stimulated a substantial materials research effort in developing high oxide-ion conductivity in the electrolyte layer of SOFCs.In this context,for the first time,a dielectric material,CaCu_(3)Ti_(4)O_(12)(CCTO)is designed for LT-SOFCs electrolyte application in this study.Both individual CCTO and its heterostructure materials with a p-type Ni_(0.8)Co_(0.15)Al_(0.05)LiO_(2−δ)(NCAL)semiconductor are evaluated as alternative electrolytes in LT-SOFC at 450–550℃.The single cell with the individual CCTO electrolyte exhibits a power output of approximately 263 mW cm^(-2) and an open-circuit voltage(OCV)of 0.95 V at 550℃,while the cell with the CCTO–NCAL heterostructure electrolyte capably delivers an improved power output of approximately 605 mW cm^(-2) along with a higher OCV over 1.0 V,which indicates the introduction of high hole-conducting NCAL into the CCTO could enhance the cell performance rather than inducing any potential short-circuiting risk.It is found that these promising outcomes are due to the interplay of the dielectric material,its structure,and overall properties that led to improve electrochemical mechanism in CCTO–NCAL.Furthermore,density functional theory calculations provide the detailed information about the electronic and structural properties of the CCTO and NCAL and their heterostructure CCTO–NCAL.Our study thus provides a new approach for developing new advanced electrolytes for LT-SOFCs.展开更多
The electrochemical hydrogen evolution reaction（HER） on a non-precious electrocatalyst in an alkaline environment is of essential importance for future renewable energy. The design of advanced electrocatalysts for H...The electrochemical hydrogen evolution reaction（HER） on a non-precious electrocatalyst in an alkaline environment is of essential importance for future renewable energy. The design of advanced electrocatalysts for HER is the most important part to reduce the cost and to enhance the efficiency of water splitting. MoSis considered as one of the most promising electrocatalysts to replace the precious Pt catalyst.Herein, for the first time, we have successfully loaded MoSelectrocatalysts onto the CoOnanosheet array to catalyze HER with a low onset potential of6 mV. The high hydrogen evolution activity of MoSsupported on the CoOnanosheet array may be attributed to the increased active sites and the electronic interactions between MoSand CoO.展开更多
CoO/CeOcomposites with high surface areas and ultrafine crystalline sizes for catalytic combustion of methane were firstly prepared by a new sol-gel method which combined ultrasonic impregnation treatment and calcinat...CoO/CeOcomposites with high surface areas and ultrafine crystalline sizes for catalytic combustion of methane were firstly prepared by a new sol-gel method which combined ultrasonic impregnation treatment and calcination in Natmosphere. The samples were characterized by various means such as nitrogen adsorption/desorption, X-ray diffraction(XRD), Htemperature-programmed reduction(H-TPR),X-ray photoelectron spectroscopy(XPS) and transmission electron microscopy(TEM). Results showed that the modified catalyst had the mesoporous structure, comparatively higher amount of surface oxygen and larger oxygen vacancies than others. As a result of the structure and surface composition merits, a high methane combustion conversion(50%) could be obtained at a low temperature of 262 °C for the modified CoO/CeOcomposites catalysts. The experimental results demonstrated that ultrasonic impregnation treatment combined with the Nthermal treatment prior to calcination in air had a promising application for preparation of CoO/CeOcomposites catalysts for low-temperature catalytic combustion of methane.展开更多
Thin PVA/cobalt acetate composite fibers were prepared by using sol-gel processing and electrospinning technique. After calcination of the above precursor fibers, Co3O4 nanofibers with a diameter of 50-150 nm could be...Thin PVA/cobalt acetate composite fibers were prepared by using sol-gel processing and electrospinning technique. After calcination of the above precursor fibers, Co3O4 nanofibers with a diameter of 50-150 nm could be successfully obtained. The fibers were characterized by SEM, FT-IR, WAXD, respectively.展开更多
基金National Natural Science Foundation of China(NSFC)supported this work under Grant No.32250410309,11674086,51736006,and 51772080funding from Science and Technology Department of Jiangsu Province under Grant No.BE2022029Shenzhen University under Grant No.86902/000248 also supported part of this work.
文摘The development of low-temperature solid oxide fuel cells(LT-SOFCs)is of significant importance for realizing the widespread application of SOFCs.This has stimulated a substantial materials research effort in developing high oxide-ion conductivity in the electrolyte layer of SOFCs.In this context,for the first time,a dielectric material,CaCu_(3)Ti_(4)O_(12)(CCTO)is designed for LT-SOFCs electrolyte application in this study.Both individual CCTO and its heterostructure materials with a p-type Ni_(0.8)Co_(0.15)Al_(0.05)LiO_(2−δ)(NCAL)semiconductor are evaluated as alternative electrolytes in LT-SOFC at 450–550℃.The single cell with the individual CCTO electrolyte exhibits a power output of approximately 263 mW cm^(-2) and an open-circuit voltage(OCV)of 0.95 V at 550℃,while the cell with the CCTO–NCAL heterostructure electrolyte capably delivers an improved power output of approximately 605 mW cm^(-2) along with a higher OCV over 1.0 V,which indicates the introduction of high hole-conducting NCAL into the CCTO could enhance the cell performance rather than inducing any potential short-circuiting risk.It is found that these promising outcomes are due to the interplay of the dielectric material,its structure,and overall properties that led to improve electrochemical mechanism in CCTO–NCAL.Furthermore,density functional theory calculations provide the detailed information about the electronic and structural properties of the CCTO and NCAL and their heterostructure CCTO–NCAL.Our study thus provides a new approach for developing new advanced electrolytes for LT-SOFCs.
基金support from the National Natural Science Foundation of China (51402100 and 21573066)the Provincial Natural Science Foundation of Hunan (2016JJ1006 and 2016TP1009)
文摘The electrochemical hydrogen evolution reaction（HER） on a non-precious electrocatalyst in an alkaline environment is of essential importance for future renewable energy. The design of advanced electrocatalysts for HER is the most important part to reduce the cost and to enhance the efficiency of water splitting. MoSis considered as one of the most promising electrocatalysts to replace the precious Pt catalyst.Herein, for the first time, we have successfully loaded MoSelectrocatalysts onto the CoOnanosheet array to catalyze HER with a low onset potential of6 mV. The high hydrogen evolution activity of MoSsupported on the CoOnanosheet array may be attributed to the increased active sites and the electronic interactions between MoSand CoO.
文摘CoO/CeOcomposites with high surface areas and ultrafine crystalline sizes for catalytic combustion of methane were firstly prepared by a new sol-gel method which combined ultrasonic impregnation treatment and calcination in Natmosphere. The samples were characterized by various means such as nitrogen adsorption/desorption, X-ray diffraction(XRD), Htemperature-programmed reduction(H-TPR),X-ray photoelectron spectroscopy(XPS) and transmission electron microscopy(TEM). Results showed that the modified catalyst had the mesoporous structure, comparatively higher amount of surface oxygen and larger oxygen vacancies than others. As a result of the structure and surface composition merits, a high methane combustion conversion(50%) could be obtained at a low temperature of 262 °C for the modified CoO/CeOcomposites catalysts. The experimental results demonstrated that ultrasonic impregnation treatment combined with the Nthermal treatment prior to calcination in air had a promising application for preparation of CoO/CeOcomposites catalysts for low-temperature catalytic combustion of methane.
文摘Thin PVA/cobalt acetate composite fibers were prepared by using sol-gel processing and electrospinning technique. After calcination of the above precursor fibers, Co3O4 nanofibers with a diameter of 50-150 nm could be successfully obtained. The fibers were characterized by SEM, FT-IR, WAXD, respectively.
