Comparing the Effectiveness of Coatings on Carbide andCermet Cutting Tool Inserts

A series of metal cutting experiments was performed on a CNC lathe to evaluate the performance of various coatings on different tool substrates. The workpiece material was plain medium carbon steel and the cutting tool materials were carbide and cermet inserts coated with various single as well as multilayer coatings. Machining was done under various cutting conditions of speed and feed-rate, and for various durations of Cutting. The output parameters studied were the cutting forces (axial, radial and tangential), the surface roughness of the workpiece, as well as the tool wear (crater and flank wear). From these results, the performances of the various cutting inserts are evaluated and compared. Results show that cutting forces are significantly lower when using coated cermets than when using coated carbides although different coatings on the same substrate also result in different cutting forces. However, there is less difference in the surface roughness of the finished workpiece for the various coatings and substrates.

Influence of Machining Parameter on Surface Roughness and Tool Life While Machining EN24 Grade Alloy Steel

The requirements of high quality machined surface as well as demand of enhanced contact time of cutting tools drive towards adopting multilayer coated carbide inserts. The industry requires higher productivity, hence higher machining parameters need to be used in order to meet the industry requirements. The alloy steel material used to fabricate machine parts consists of alloying elements like nickel, chromium and molybdenum difficult to machine, since the cutting tool fails by high tool wear, if we use uncoated carbide inserts to machine alloy steels. Hence in the present research work it is intended to use tungsten carbide inserts coated with different coatings for the experiments. The turning experiments were carried out using different grades of uncoated and coated carbide inserts of identical tool signature. The cutting speed selected for the experiments was 100 to 500 m/min in steps of 100 m/min, and the feed per revolution was 0.1 mm to 0.4 mm in step of 0.1 mm. The experimentation was carried out following ISO3685 standards. The results of the experiments revealed that the surface roughness measured was the least at cutting speed 500 m/min and feed per revolution of 0.1 mm, however the chip breaking found better when the feed used was greater than 0.2 mm/revolution.

Influence of Machining Parameter on Tool Life While Machining Hybrid Metal Matrix Composites

A metal matrix composite constitutes a continuous metallic matrix and a discontinuous phase known as reinforcement. The hybrid metal matrix composites (Hmmcs) have been used to manufacture drive shafts, disc brake rotors, brake drums, connecting rods pistons, engine block cylinder liners for automotive and rail vehicle applications. The Hmmcs castings of diameter 120 mm and length 300 mm were prepared through sand mould technique following stir casting methodology. The cast components further subjected to evaluation of physical properties and machining tests using two grades of coated inserts and PCD inserts. The experiments were carried out following ISO 3685 standards. The coating thickness of the TiN coated and TiAlN coated inserts were measured using Kalo testing method; the results of the test show that the interface of the substrate and coating was free from the porosity, and the coating thickness of TiN coating was 4.84 microns and TiAlN coating was measured 4.6 microns. The results of the experiments show that performance of the PCD insert was better than coated inserts at 0.1 mm/rev feed; however at 0.2 mm/revolution feed PCD insert failed by micro chipping of cutting edge while machining Hmmcs. When TiAlN coated inserts were used to machine Hmmcs the coated inserts failed by gradual wear and BUE formation.