Shifts in soil bacterial communities induced by the controlled-release fertilizer coatings

Coated controlled-release fertilizers （CRFs） have been widely applied in agriculture due to their increased efficiency. However, the widespread and a lot of coated CRFs application may leave undesired coating residues in the soil due to their slow degradation. Limited information is available on the effects of substantial residual coatings on the soil bacterial community. By adding 0, 5, 10, 20, and 50 times quantities of residual coating from conventional application amount of resin and water-soluble coated CRFs, we studied the responses of soil properties and bacterial community composition to these two residual coatings in black soil. The results showed that the resin and water-soluble coatings did not essentially alter the properties of black soil or cause dramatic changes to bacterial diversity within the test concentration range. The residual resin and water-soluble coatings also did not distinctly alter the relative abundance of the top ten bacteria at phylum level. Heatmap results suggested that the treatments were basically clustered into two groups by concentration rather than types of coating material. Pearson correlation analysis showed that the Simpson＇s diversity index of the bacterial community was significantly correlated with microbial biomass carbon （MBC, r=0.394, P〈0.05）, and the richness index abundance-based coverage estimator （ACE） of the bacterial community was significantly correlated with microbial biomass nitrogen （MBN, t=0.407, P〈0.05）. Overall, results of this study suggested that substantial residual resin and water-soluble coatings with 0-50 times quantities of residual coating from conventional application amount of coated CRFs did not generate obviously negative impacts on the bacterial community in black soil.

Structure design of gradient hard coatings on YG8 and their residual stress analysis by ANSYS

A structure of gradient hard coatings( Ti,TiN,TiCN and TiAlN) is designed,and residual stress is simulated by a finite element method with ANSYS. The influence of the realistic situation including load and temperature on the residual stress of the coatings is investigated. Simulated results show that the realistic situation strongly affects the residual stress. To be specific,i) The main residual stress concentrates on the coatings prepared on YG8 substrate,and the residual stress and its gradient of the coatings are bigger than that of the substrate; ii) TiAlN and TiCN coatings have better resistance compression than that of TiN coatings in the same condition; iii) The improved multilayer structure of the gradient hard coatings produces weaker residual stress but higher anti-pressure of the substrate.