In this paper, a design of very compact microstrip bandstop filters based on complementary split ring resonators (CSRRs) is proposed. Two techniques of metamaterial miniaturization are used to optimize the physical an...In this paper, a design of very compact microstrip bandstop filters based on complementary split ring resonators (CSRRs) is proposed. Two techniques of metamaterial miniaturization are used to optimize the physical and electrical size of the CSRR. The bandstop filter is produced by an array of miniaturized loaded CSRRs etched on the center line of a microstrip. The size of the proposed filter, is as small as 0.58 cm2, and its electrical length is very small with only 0.08 λ0), compared to a conventional bandstop filter, a miniaturization of a factor 5 while the bandstop performance is maintained. A very good agreement obtained between the measurement and the simulation results.展开更多
A compact patch antenna is designed, which is with structures of cross-shape slot, Complementary Split Ring Resonator(CSRR), and loaded transmission line. To implement the compactness in size, these structures are etc...A compact patch antenna is designed, which is with structures of cross-shape slot, Complementary Split Ring Resonator(CSRR), and loaded transmission line. To implement the compactness in size, these structures are etched on the ground plane, then the input impedance has been improved. The CSRR is employed to improve impedance matching between the source and radiation patch, and the cross-shape slot on the radiation patch is utilized to increase the bandwidth. The design is validated by comparison of realistic field simulation with measurement results of an antenna prototype. The presented antenna is much smaller in size than conventional antennas with CSRR, showing good performances at the resonant frequency. The experimental results accord well with simulated results.展开更多
文摘In this paper, a design of very compact microstrip bandstop filters based on complementary split ring resonators (CSRRs) is proposed. Two techniques of metamaterial miniaturization are used to optimize the physical and electrical size of the CSRR. The bandstop filter is produced by an array of miniaturized loaded CSRRs etched on the center line of a microstrip. The size of the proposed filter, is as small as 0.58 cm2, and its electrical length is very small with only 0.08 λ0), compared to a conventional bandstop filter, a miniaturization of a factor 5 while the bandstop performance is maintained. A very good agreement obtained between the measurement and the simulation results.
文摘针对移相器和功分器的功能融合设计,提出了一种基于慢波基片集成波导(Slow-Wave Substrate Integrated Waveguide,SW-SIW)的小型化移相功分器,两个输出分支等长带宽,可实现30°相移量.其中一个输出分支通过基片集成波导(Substrate Integrated Waveguide,SIW)实现,而另一个输出分支将互补开口谐振环(Complementary SplitRing Resonator,CSRR)加载在上层金属表面,代替传统SIW连续的金属表面,该CSRR由经典CSRR结构演变而来,同时为了降低由CSRR加载所造成的相位上的不稳定,在CSRR内部添加金属化通孔,实现SW-SIW,使得截止频率和相速度降低.测试结果表明,移相功分器在9.0~11.8 GHz频带范围内反射系数|S11|小于-10 d B,相对工作带宽为26.9%,插入损耗小于1.3 d B.两个输出端口的相位差稳定在30°±3°,幅度差小于1.4 d B,实现了等功率分配.所设计的移相功分器具有较小的尺寸和低制造成本,适合应用在相控阵天线中.
基金Hebei Provincial Education Department Youth Fund(QN2017114)。
文摘A compact patch antenna is designed, which is with structures of cross-shape slot, Complementary Split Ring Resonator(CSRR), and loaded transmission line. To implement the compactness in size, these structures are etched on the ground plane, then the input impedance has been improved. The CSRR is employed to improve impedance matching between the source and radiation patch, and the cross-shape slot on the radiation patch is utilized to increase the bandwidth. The design is validated by comparison of realistic field simulation with measurement results of an antenna prototype. The presented antenna is much smaller in size than conventional antennas with CSRR, showing good performances at the resonant frequency. The experimental results accord well with simulated results.