The general behavior of micron-particles in the inner domain of porous ceramic vessel was simulated by computational fluid dynamics software in terms of sampling experimental data.The results show that there is an opt...The general behavior of micron-particles in the inner domain of porous ceramic vessel was simulated by computational fluid dynamics software in terms of sampling experimental data.The results show that there is an optimum porosity of 0.32 to get a higher efficiency and lower pressure drop during filtration.According to the results of simulation and experiment,it is evident that lower inlet velocity can maintain lower pressure drop and obtain higher collection efficiency and inlet concentration also has a crucial influence on the collection efficiency.The collection efficiency of equipment increases significantly with the increase of inlet concentration when the inlet concentration is less than 6.3 g/m3,but it gradually tends to be stable in the range of 97.3%-99.7%when the inlet concentration is over this concentration.展开更多
The Experiments, methods and results of obtaining micron beam in the Microbeam Facility of the Institute of Plasma Physics were discussed in this paper. The H+2 beam was accelerated by the Van de GraafF electrostatic ...The Experiments, methods and results of obtaining micron beam in the Microbeam Facility of the Institute of Plasma Physics were discussed in this paper. The H+2 beam was accelerated by the Van de GraafF electrostatic accelerator, and the collimator at the end of the beam line is a 60 μm thick stainless steel chip. And as a result, particle tracks on the solid track probes (CR39 film) etched in the solution of NaOH showed that the beam can go through the collimator with a small aperure (2000, 300, 55, 30, or 10 μm) and 3.5 μm thick vacuum film (Mylar). Besides the CR39 method, the beam was measured by an energy spectrum detector after the 10 μm diameter aperture and the 3.5 μm thick vacuum film too.展开更多
Co3O4 powder has a wide range of applications in the fields of catalysts, magnetic materials and electrochemistry. Especially after the 1990s, the demand for lithium ion battery industry has grown tremendously. The tr...Co3O4 powder has a wide range of applications in the fields of catalysts, magnetic materials and electrochemistry. Especially after the 1990s, the demand for lithium ion battery industry has grown tremendously. The traditional wet preparation of Co3O4 powder cannot meet the requirements of the battery industry. Exploring suitable methods and theories for controlling particle size and morphology is of great significance for the preparation of battery-grade Co3O4 powder. CoCl2 was used as the cobalt source, NH4HCO3 was used as the precipitant, and the precursor was prepared and further calcined to obtain Co3O4 powder. The results show that the molar ratio is the main factor affecting the precursor phase in the preparation of Co3O4 in CoCl2-NH4HCO3 system. The suitable process conditions for the system are a molar ratio of NH4HCO3 to CoCl2 of 4.5:1, a concentration of CoCl2 of 13 g/L, a reaction temperature of 600C, and a reaction time of 10 hours. The median diameter of Co3O4 prepared by the reaction conditions is about 9 μm.展开更多
30%Al2O3p/Al-Cu-2.0Mg composite and Al2O3p/Al-Cu-2.5Mg composite with 0.3μm-Al2O3 particles were fabricated. Age-hardening behaviors of two composites and the related matrix alloys were studied by means of Brinell-ha...30%Al2O3p/Al-Cu-2.0Mg composite and Al2O3p/Al-Cu-2.5Mg composite with 0.3μm-Al2O3 particles were fabricated. Age-hardening behaviors of two composites and the related matrix alloys were studied by means of Brinell-hardness measurement, DSC and TEM. The results show that the hardness of the composite is improved obviously because of the addition of sub-micron Al2O3 particles. But the hardness increment of Al2O3p/Al composite after aging is lower than that of the related matrix alloy. Moreover, the formation of GP region is suppressed by the addition of sub-micron Al2O3 particles, which broadens the exothermic peak of S' phase. The increment of Mg content has a different influence on accelerating the aging processes of aluminum alloys and the composites, and the hardness also increases.展开更多
The feasibility of the rapid degradation of hexachlorobenzene （HCB） by micron-size silver （Ag）/iron （Fe） particles was investigated.Ag/Fe particles with different ratios （0,0.05%,0.09%,0.20%,and 0.45%） were pr...The feasibility of the rapid degradation of hexachlorobenzene （HCB） by micron-size silver （Ag）/iron （Fe） particles was investigated.Ag/Fe particles with different ratios （0,0.05%,0.09%,0.20%,and 0.45%） were prepared by electroless silver plating on 300 mesh Fe powder,and were used to degrade HCB at different pH values and temperatures.The dechlorination ability of Fe greatly increased with small Ag addition,whereas too much added Ag would cover the Fe surface and reduce the effective reaction surface,thereby decreasing the extent of dechlorination.The optimal Ag/Fe ratio was 0.09%.Tafel polarization curves showed that HCB was rapidly degraded at neutral or acidic pH,whereas low pH levels severely intensified H2 production,which consumed the reducing electrons needed for the HCB degradation.HCB degradation was more sensitive to temperature than pH.The rate constant of HCB dechlorination was 0.452 min-1 at 85℃,50 times higher than that at 31℃.HCB was degraded in a successive dechlorination pathway,yielding the main products 1,2,4,5-tetrachlorobenzene and 1,2,4-trichlorobenzene within 2 hr.展开更多
基金Project(50878080)supported by the National Natural Science Foundation of ChinaProject(K0902006-31)supported by the Key Scientific and Technological Special of Changsha City in China
文摘The general behavior of micron-particles in the inner domain of porous ceramic vessel was simulated by computational fluid dynamics software in terms of sampling experimental data.The results show that there is an optimum porosity of 0.32 to get a higher efficiency and lower pressure drop during filtration.According to the results of simulation and experiment,it is evident that lower inlet velocity can maintain lower pressure drop and obtain higher collection efficiency and inlet concentration also has a crucial influence on the collection efficiency.The collection efficiency of equipment increases significantly with the increase of inlet concentration when the inlet concentration is less than 6.3 g/m3,but it gradually tends to be stable in the range of 97.3%-99.7%when the inlet concentration is over this concentration.
基金The project supported by the National Science Foundation of in Anhui Province,China(No.01046201)
文摘The Experiments, methods and results of obtaining micron beam in the Microbeam Facility of the Institute of Plasma Physics were discussed in this paper. The H+2 beam was accelerated by the Van de GraafF electrostatic accelerator, and the collimator at the end of the beam line is a 60 μm thick stainless steel chip. And as a result, particle tracks on the solid track probes (CR39 film) etched in the solution of NaOH showed that the beam can go through the collimator with a small aperure (2000, 300, 55, 30, or 10 μm) and 3.5 μm thick vacuum film (Mylar). Besides the CR39 method, the beam was measured by an energy spectrum detector after the 10 μm diameter aperture and the 3.5 μm thick vacuum film too.
文摘Co3O4 powder has a wide range of applications in the fields of catalysts, magnetic materials and electrochemistry. Especially after the 1990s, the demand for lithium ion battery industry has grown tremendously. The traditional wet preparation of Co3O4 powder cannot meet the requirements of the battery industry. Exploring suitable methods and theories for controlling particle size and morphology is of great significance for the preparation of battery-grade Co3O4 powder. CoCl2 was used as the cobalt source, NH4HCO3 was used as the precipitant, and the precursor was prepared and further calcined to obtain Co3O4 powder. The results show that the molar ratio is the main factor affecting the precursor phase in the preparation of Co3O4 in CoCl2-NH4HCO3 system. The suitable process conditions for the system are a molar ratio of NH4HCO3 to CoCl2 of 4.5:1, a concentration of CoCl2 of 13 g/L, a reaction temperature of 600C, and a reaction time of 10 hours. The median diameter of Co3O4 prepared by the reaction conditions is about 9 μm.
基金Project(50071019) supported by the National Natural Science Foundation of ChinaProject(HIT2002.34) supported by the Science Research Foundation of Harbin Institute of Technology, China
文摘30%Al2O3p/Al-Cu-2.0Mg composite and Al2O3p/Al-Cu-2.5Mg composite with 0.3μm-Al2O3 particles were fabricated. Age-hardening behaviors of two composites and the related matrix alloys were studied by means of Brinell-hardness measurement, DSC and TEM. The results show that the hardness of the composite is improved obviously because of the addition of sub-micron Al2O3 particles. But the hardness increment of Al2O3p/Al composite after aging is lower than that of the related matrix alloy. Moreover, the formation of GP region is suppressed by the addition of sub-micron Al2O3 particles, which broadens the exothermic peak of S' phase. The increment of Mg content has a different influence on accelerating the aging processes of aluminum alloys and the composites, and the hardness also increases.
基金supported by the National High Technology Research and Development Program(863)of China(No.2009AA064001)
文摘The feasibility of the rapid degradation of hexachlorobenzene （HCB） by micron-size silver （Ag）/iron （Fe） particles was investigated.Ag/Fe particles with different ratios （0,0.05%,0.09%,0.20%,and 0.45%） were prepared by electroless silver plating on 300 mesh Fe powder,and were used to degrade HCB at different pH values and temperatures.The dechlorination ability of Fe greatly increased with small Ag addition,whereas too much added Ag would cover the Fe surface and reduce the effective reaction surface,thereby decreasing the extent of dechlorination.The optimal Ag/Fe ratio was 0.09%.Tafel polarization curves showed that HCB was rapidly degraded at neutral or acidic pH,whereas low pH levels severely intensified H2 production,which consumed the reducing electrons needed for the HCB degradation.HCB degradation was more sensitive to temperature than pH.The rate constant of HCB dechlorination was 0.452 min-1 at 85℃,50 times higher than that at 31℃.HCB was degraded in a successive dechlorination pathway,yielding the main products 1,2,4,5-tetrachlorobenzene and 1,2,4-trichlorobenzene within 2 hr.
