为研究PVP含量对CZTS颗粒形貌以及分散性的影响,本文采用溶剂热法,以CuCl2·2H2O、Zn(Ac)2·2H2O、SnCl4·5H2O作金属源,硫脲作硫源,乙二醇为溶剂,在体系中加入不同含量的PVP,成功制备了CZTS微球。通过XRD、Raman、SEM、TEM...为研究PVP含量对CZTS颗粒形貌以及分散性的影响,本文采用溶剂热法,以CuCl2·2H2O、Zn(Ac)2·2H2O、SnCl4·5H2O作金属源,硫脲作硫源,乙二醇为溶剂,在体系中加入不同含量的PVP,成功制备了CZTS微球。通过XRD、Raman、SEM、TEM、UVVis等方法检测分析CZTS纳米微球的物相、结构、形貌以及光学性能。结果表明:所得CZTS纳米颗粒具有锌黄锡矿结构;当体系中PVP含量为0.2 g时,颗粒分散性较好,制备的颗粒形貌为表面嵌有纳米薄片的微球,纳米片较在体系中加入0.1 g PVP更致密;光学带隙约为1.47 eV,与太阳能电池所需的最佳带隙接近。最后,对表面嵌有纳米薄片的CZTS微球可能的形成机理进行了推测。展开更多
Cu2ZnSnS4 (CZTS) thin films were successfully prepared by sulfurization of ion bean sputtered precursors on soda-lime glass substrate. The single phase of stannite-type structure CZTS films were obtained as revealed i...Cu2ZnSnS4 (CZTS) thin films were successfully prepared by sulfurization of ion bean sputtered precursors on soda-lime glass substrate. The single phase of stannite-type structure CZTS films were obtained as revealed in EDS and XRD analysis when the ratios of the constituents of CZTS thin films are close to stoichiometric by optimizing the conditions of precursor preparation and sulfurization. A low sheet resistivity as about 0.156 Ω·cm and a high absorption coefficient as 1×104 cm-1 were achieved in this method by Hall effect measurements and UV-VIS spectrophotometer. The optical band-gap energy of the CZTS sample is about 1.51 eV, which is very close to the optimum value for a solar-cell absorber.展开更多
Cu2ZnSnS（e）4 （CZTS（e）） solar cells have attracted much attention due to the elemental abundance and the non- toxicity. However, the record efficiency of 12.6% for CuzZnSn（S,Se）4 （CZTSSe） solar cells is much ...Cu2ZnSnS（e）4 （CZTS（e）） solar cells have attracted much attention due to the elemental abundance and the non- toxicity. However, the record efficiency of 12.6% for CuzZnSn（S,Se）4 （CZTSSe） solar cells is much lower than that of Cu（In,Ga）See （CIGS） solar cells. One crucial reason is the recombination at interfaces. In recent years, large amount inves- tigations have been done to analyze the interfacial problems and improve the interfacial properties via a variety of methods. This paper gives a review of progresses on interfaces of CZTS（e） solar cells, including： （i） the band alignment optimization at buffer/CZTS（e） interface, （ii） tailoring the thickness of MoS（e）2 interfacial layers between CZTS（e） absorber and Mo back contact, （iii） the passivation of rear interface, （iv） the passivation of front interface, and （v） the etching of secondary phases.展开更多
The Cu2ZnSnS4 thin film was prepared by a facile solution method without vacuum environment and toxic substance. The formation mechanism of the film was studied by transmission electron microscopy (TEM), X-ray diffrac...The Cu2ZnSnS4 thin film was prepared by a facile solution method without vacuum environment and toxic substance. The formation mechanism of the film was studied by transmission electron microscopy (TEM), X-ray diffraction (XRD), scanning electron microscopy (SEM), energy dispersive X-ray spectroscopy (EDS), and Raman scattering measurements. Through cyclic voltammetry and photo-electricity tests, the electrocatalytic activity of the prepared film as the counter electrode of dye-sensitizedsolar cell was also studied. The results show that the mixed precursor solution mainly consists of Cu2SnS3 nanoparticles and Zn ions.After 550 °C annealing process on the precursor film prepared from the mixed solution, Cu2ZnSnS4 thin film is obtained. Besides, itis found that the prepared Cu2ZnSnS4 thin film has the electrocatalytic activity toward the redox reaction of I3?/I? and the dye-sensitized solar cell with the prepared Cu2ZnSnS4 thin film as the counter electrode achieves the efficiency of 1.09%.展开更多
文摘为研究PVP含量对CZTS颗粒形貌以及分散性的影响,本文采用溶剂热法,以CuCl2·2H2O、Zn(Ac)2·2H2O、SnCl4·5H2O作金属源,硫脲作硫源,乙二醇为溶剂,在体系中加入不同含量的PVP,成功制备了CZTS微球。通过XRD、Raman、SEM、TEM、UVVis等方法检测分析CZTS纳米微球的物相、结构、形貌以及光学性能。结果表明:所得CZTS纳米颗粒具有锌黄锡矿结构;当体系中PVP含量为0.2 g时,颗粒分散性较好,制备的颗粒形貌为表面嵌有纳米薄片的微球,纳米片较在体系中加入0.1 g PVP更致密;光学带隙约为1.47 eV,与太阳能电池所需的最佳带隙接近。最后,对表面嵌有纳米薄片的CZTS微球可能的形成机理进行了推测。
基金This work was financially supported by the National Natural Science Foundation (No.10574106), the Science & Technology Plan of Guangdong Province (No.2003C105005) and the Scientific Research Foundation for the Returned Overseas Chinese Scholars of Chinese State Education Ministry (No.(2004)176).
文摘Cu2ZnSnS4 (CZTS) thin films were successfully prepared by sulfurization of ion bean sputtered precursors on soda-lime glass substrate. The single phase of stannite-type structure CZTS films were obtained as revealed in EDS and XRD analysis when the ratios of the constituents of CZTS thin films are close to stoichiometric by optimizing the conditions of precursor preparation and sulfurization. A low sheet resistivity as about 0.156 Ω·cm and a high absorption coefficient as 1×104 cm-1 were achieved in this method by Hall effect measurements and UV-VIS spectrophotometer. The optical band-gap energy of the CZTS sample is about 1.51 eV, which is very close to the optimum value for a solar-cell absorber.
基金Project supported by the National Natural Science Foundation of China(Grant Nos.51572132,51372121,and 61674082)the Natural Science Foundation of Key Project of Tianjin City,China(Grant No.16JCZDJC30700)+1 种基金the Yang Fan Innovative and Entrepreneurial Research Team Project of China(Grant No.2014YT02N037)111 Project,China(Grant No.B16027)
文摘Cu2ZnSnS（e）4 （CZTS（e）） solar cells have attracted much attention due to the elemental abundance and the non- toxicity. However, the record efficiency of 12.6% for CuzZnSn（S,Se）4 （CZTSSe） solar cells is much lower than that of Cu（In,Ga）See （CIGS） solar cells. One crucial reason is the recombination at interfaces. In recent years, large amount inves- tigations have been done to analyze the interfacial problems and improve the interfacial properties via a variety of methods. This paper gives a review of progresses on interfaces of CZTS（e） solar cells, including： （i） the band alignment optimization at buffer/CZTS（e） interface, （ii） tailoring the thickness of MoS（e）2 interfacial layers between CZTS（e） absorber and Mo back contact, （iii） the passivation of rear interface, （iv） the passivation of front interface, and （v） the etching of secondary phases.
文摘利用磁控溅射法将Cu/Sn/Zn S前驱体沉积在钙钠玻璃基片上,再通过硫化该前驱体制备Cu2ZnSnS4薄膜。利用X射线衍射仪、拉曼光谱仪、扫描电子显微镜、能谱仪、霍尔效应测量系统和紫外可见分光光度计研究了Cu2ZnSnS4薄膜的微观结构、表面形貌、化学成分、电学和光学性能。结果表明,CZTS薄膜的微观结构依赖于硫化温度和时间。在480℃硫化3 h的薄膜为沿(112)晶面择优取向生长的纯相CZTS薄膜,该薄膜的禁带宽度是1.51 e V,其电阻率和载流子浓度分别为0.39Ω·cm和4.07×1017cm-3。
基金Projects(51204214,51272292,51222403)supported by the National Natural Science Foundation of China
文摘The Cu2ZnSnS4 thin film was prepared by a facile solution method without vacuum environment and toxic substance. The formation mechanism of the film was studied by transmission electron microscopy (TEM), X-ray diffraction (XRD), scanning electron microscopy (SEM), energy dispersive X-ray spectroscopy (EDS), and Raman scattering measurements. Through cyclic voltammetry and photo-electricity tests, the electrocatalytic activity of the prepared film as the counter electrode of dye-sensitizedsolar cell was also studied. The results show that the mixed precursor solution mainly consists of Cu2SnS3 nanoparticles and Zn ions.After 550 °C annealing process on the precursor film prepared from the mixed solution, Cu2ZnSnS4 thin film is obtained. Besides, itis found that the prepared Cu2ZnSnS4 thin film has the electrocatalytic activity toward the redox reaction of I3?/I? and the dye-sensitized solar cell with the prepared Cu2ZnSnS4 thin film as the counter electrode achieves the efficiency of 1.09%.
