A simplified in situ direct shear test （DST） was developed for measuring the shear strength of soils in fields. In this test, a latticed sheafing frame replaces the upper half of the shear box used in the convention...A simplified in situ direct shear test （DST） was developed for measuring the shear strength of soils in fields. In this test, a latticed sheafing frame replaces the upper half of the shear box used in the conventional direct shear box test. The latticed shearing frame is directly embedded in the ground to be tested after a construction process and is pulled with a flexible chain while a constant dead load is applied to the sample in the sheafing frame. This simplified in situ DST has been validated by comparing its results with those of triaxial tests on samples with parallel gradations under normal stresses less than 100 kPa. In this study, the DST was further validated by carrying out tests on samples with the same gradations, rather than on samples with parallel gradations, under normal stresses up to 880 kPa. In addition, the DST was performed inside fills in two applications.展开更多
Direct shear tests were conducted to obtain both the shear strength ofcompacted clay liners (CCLs) specimens and the interface shear strength between compacted clay linerand base soil. These experiments were conducted...Direct shear tests were conducted to obtain both the shear strength ofcompacted clay liners (CCLs) specimens and the interface shear strength between compacted clay linerand base soil. These experiments were conducted under the conditions of five different watercontents. The experimental results show that shear strength of both CCLs and CCLs/base interfacedecreases with the increase in the water content of CCLs and base soil. In addition, the considerateconcentration of NaCl in leachate has no deteriorating effect on the shear strength of liners.Triaxial shear tests were also conducted on clay liner specimens to obtain total and effective shearstrength under a fast compression. The shear strength parameters with total stress are φ=18. 5°and c=30 kPa for clay-bentonite, and φ=48. 5° and c=90 kPa for sand-bentonite and those witheffective stress are φ'= 27. 2° and c'=25 kPa for clay-bentonite, and φ'=35° and c'=100 kPa forsand-bentonite, respectively. These results indicate that the compacted clay-bentonite shows normalconsolidation, but that the compacted sand-bentonite exhibits over-consolidation.展开更多
In order to study the shear behavior of coarse-grained fillings taken from the subgrade bottom layer of a cold region high-speed railway,large scale direct shear tests were conducted with different normal pressures,wa...In order to study the shear behavior of coarse-grained fillings taken from the subgrade bottom layer of a cold region high-speed railway,large scale direct shear tests were conducted with different normal pressures,water contents and temperatures.The results indicate that the relationship between shear displacement and shear stress changed from strain-softening at lower normal pressures to strain-hardening at higher normal pressures,in both unfrozen and frozen states.This phenomenon was mainly due to the shear dilatation deformation effect.The shear displacement-shear stress curves show similar stages.Besides,the shear stress rapidly increased and there was not an increment in the shear displacement during the initial stage of the shear process in the frozen state.In both the unfrozen or frozen states at the same water contents,the shear strength increased with increasing normal pressure.展开更多
An experimental study was conducted to investigate the effect of waste tire chips on the strength characteristics of two soils. A cohesive clayey silt soil and a cohesionless free sand soil were used. A program of sta...An experimental study was conducted to investigate the effect of waste tire chips on the strength characteristics of two soils. A cohesive clayey silt soil and a cohesionless free sand soil were used. A program of standard Proctor tests, unconfined compression tests and California bearing ratio tests was carried out on specimens of the cohesive soft-tire mixtures, by varying tire chips content from 5% to 20% by weight of the soil. Vibratory compaction tests and direct shear tests were conducted on the cohesioliless soft-tire mixtures by adding tire chips varying from 10% to 50% by weight. The results showed that 13% and 30% chip contents, respectively by weight, were optimum for composite strength of the two reinforced soil mixtttres.展开更多
In order to study the reliability of the empirical estimation of joint shear strength by the JRC（joint roughness coefficient）-JCS（joint compressive strength） model,natural rock joints of dif-ferent lithologic char...In order to study the reliability of the empirical estimation of joint shear strength by the JRC（joint roughness coefficient）-JCS（joint compressive strength） model,natural rock joints of dif-ferent lithologic characteristics and different sizes were selected as samples,and their shear strengths under dry and saturated conditions were measured by direct shear test and compared to those esti-mated by the JRC-JCS model.Comparison results show that for natural rock joints with joint surfaces closely matched,the average relative error of joint shear strength between empirical estimation and direct shear test is 9.9%;the reliability of the empirical estimation of joint shear strength by the JRC-JCS model is good under both dry and saturated conditions if the JRC is determined accounting for directional statistical measurements,scale effect and surface smoothing during shearing.However,for natural rock joints with joint surfaces mismatched,the average relative error of joint shear strength between empirical estimation and direct shear test is 39.9%;the reliability of empirical estimation of joint shear strength by the JRC-JCS model is questionable under both dry and saturated conditions.展开更多
基金supported by the Special Foundation of the State Key Laboratory of Hydrology-Water Resources and Hydraulic Engineering, Hohai University (Grant No. 2009586012)
文摘A simplified in situ direct shear test （DST） was developed for measuring the shear strength of soils in fields. In this test, a latticed sheafing frame replaces the upper half of the shear box used in the conventional direct shear box test. The latticed shearing frame is directly embedded in the ground to be tested after a construction process and is pulled with a flexible chain while a constant dead load is applied to the sample in the sheafing frame. This simplified in situ DST has been validated by comparing its results with those of triaxial tests on samples with parallel gradations under normal stresses less than 100 kPa. In this study, the DST was further validated by carrying out tests on samples with the same gradations, rather than on samples with parallel gradations, under normal stresses up to 880 kPa. In addition, the DST was performed inside fills in two applications.
文摘Direct shear tests were conducted to obtain both the shear strength ofcompacted clay liners (CCLs) specimens and the interface shear strength between compacted clay linerand base soil. These experiments were conducted under the conditions of five different watercontents. The experimental results show that shear strength of both CCLs and CCLs/base interfacedecreases with the increase in the water content of CCLs and base soil. In addition, the considerateconcentration of NaCl in leachate has no deteriorating effect on the shear strength of liners.Triaxial shear tests were also conducted on clay liner specimens to obtain total and effective shearstrength under a fast compression. The shear strength parameters with total stress are φ=18. 5°and c=30 kPa for clay-bentonite, and φ=48. 5° and c=90 kPa for sand-bentonite and those witheffective stress are φ'= 27. 2° and c'=25 kPa for clay-bentonite, and φ'=35° and c'=100 kPa forsand-bentonite, respectively. These results indicate that the compacted clay-bentonite shows normalconsolidation, but that the compacted sand-bentonite exhibits over-consolidation.
基金supported by the National Natural Science Foundation of China (No. 51378057)
文摘In order to study the shear behavior of coarse-grained fillings taken from the subgrade bottom layer of a cold region high-speed railway,large scale direct shear tests were conducted with different normal pressures,water contents and temperatures.The results indicate that the relationship between shear displacement and shear stress changed from strain-softening at lower normal pressures to strain-hardening at higher normal pressures,in both unfrozen and frozen states.This phenomenon was mainly due to the shear dilatation deformation effect.The shear displacement-shear stress curves show similar stages.Besides,the shear stress rapidly increased and there was not an increment in the shear displacement during the initial stage of the shear process in the frozen state.In both the unfrozen or frozen states at the same water contents,the shear strength increased with increasing normal pressure.
文摘An experimental study was conducted to investigate the effect of waste tire chips on the strength characteristics of two soils. A cohesive clayey silt soil and a cohesionless free sand soil were used. A program of standard Proctor tests, unconfined compression tests and California bearing ratio tests was carried out on specimens of the cohesive soft-tire mixtures, by varying tire chips content from 5% to 20% by weight of the soil. Vibratory compaction tests and direct shear tests were conducted on the cohesioliless soft-tire mixtures by adding tire chips varying from 10% to 50% by weight. The results showed that 13% and 30% chip contents, respectively by weight, were optimum for composite strength of the two reinforced soil mixtttres.
基金supported by the National Natural Science Foundation of China (Nos. 40672186, 50809059)the Natural Science Foundation of Zhejiang Province (No. Y505008), China
文摘In order to study the reliability of the empirical estimation of joint shear strength by the JRC（joint roughness coefficient）-JCS（joint compressive strength） model,natural rock joints of dif-ferent lithologic characteristics and different sizes were selected as samples,and their shear strengths under dry and saturated conditions were measured by direct shear test and compared to those esti-mated by the JRC-JCS model.Comparison results show that for natural rock joints with joint surfaces closely matched,the average relative error of joint shear strength between empirical estimation and direct shear test is 9.9%;the reliability of the empirical estimation of joint shear strength by the JRC-JCS model is good under both dry and saturated conditions if the JRC is determined accounting for directional statistical measurements,scale effect and surface smoothing during shearing.However,for natural rock joints with joint surfaces mismatched,the average relative error of joint shear strength between empirical estimation and direct shear test is 39.9%;the reliability of empirical estimation of joint shear strength by the JRC-JCS model is questionable under both dry and saturated conditions.
