Influence of the Gas Mixture Ratio on the Correlations Between the Excimer XeCl Emission and the Sealed Gas Temperature in Dielectric Barrier Discharge Lamps

For dielectric barrier discharge lamps filled with various gas mixture ratios, the correlations between the excimer XeCl* emission and the sealed gas temperature have been founded, and a qualitative explication is presented. For gas mixture with chlorine larger than 3%, the emission intensity increases with the sealed gas temperature, while with chlorine about 2%, the emission intensity decreases with the increase in the gas temperature, and could be improved by cooling water. However, if chlorine is less than 1.5%, the discharge appears to be a mixture mode with filaments distributed in a diffused glow-like discharge, and the UV emission is independent on the gas temperature.

The roles of active species in photo-decomposition of organic compounds by microwave powered electrodeless discharge lamps

Knowledge of the effective radiation spectrum irradiating substrates from microwave powered electrodeless discharge lamps（MEDLs）, and the active species that directly oxidize substrates in the photolytic process, is fragmentary and unclear. In this work, we conducted a comparative study using MEDLs made with quartz envelopes（MEDL-quartz） and with borosilicate Pyrex envelopes（MEDL-Pyrex） targeting the degradation of Rhodamine B（Rh B）via radical-extinguishing tests. We found that UVC/UVB radiation is essential to generate·OH and H2O2 in the MEDL-quartz system. The degradation of Rh B mostly originates from·OH species, which account for a contribution of 53.8%, while the remaining contribution is attributed to oxidation by H2O2 and direct photolysis. This degradation is influenced by several parameters. Acidic and neutral p Hs, but not extreme alkaline p H, benefit the degradation. To ensure a high intensity of UVC/UVB, the optimum ratio of the MEDL volume to the aqueous solution volume（VL/VS） is 0.4. Concentrations of 0.15-0.20 mmol/L of Rh B are suitable to obtain an effective quantum absorbance in the MEDL-quartz system,showing a high decomposition rate of 5.6 × 10^-3（mmol/L）min-1. Moreover, two other substrates, Reactive Brilliant Red X-3B and Safranine T, were tested and found to be efficiently degraded in the MEDL-quartz system.

Photolysis of H_2S with interior microwave discharge electrodeless lamps

The luminescent properties of microwave discharge electrodeless mercury lamp（MDEL-Hg） which was ignited within the resonant cavity and photolysis of hydrogen sulfide with low concentration were studied in this paper.Experiment results indicated that the Interior MDEL-Hg could be made the best of energy utihzation and the efficiency of photolysis of H2S was very significant under the experimental conditions with the initial H2S concentration of 7.9 mg m^-1.With residence time of 1.5 s,the removal efficiency of hydrogen sulfide was 91%,the absolute removal amount（ARA） was 3.24μg s^-1 and the energy consumption was 58.23 mg（kWh）^-1.

The near-infrared spectra and distribution of excited states of electrodeless discharge rubidium vapour lamps

The population ratio between the excited states of rubidium in the electrodeless discharge rubidium vapour lamp is calculated according to the near-infrared spectra in the region of 780-1550 nm. By using a 1529 nm laser, we measure the density of natural rubidium atoms at the 5P3/2 level. The populations of different excited states are then clarified.

Novel Automotive High Intensity Discharge(HID) Lamps with Electronic Ballasts

A new scheme of automotive high intensity discharge(HID) lamps with electronic ballasts is proposed. The design of the proposed ballast and some experimental results are presented. The proposed scheme is consisted of the high frequency DC-DC converter and the low frequency DC-AC inverter. This system separates the input voltage of the ignitor from DC link voltage using auxiliary winding, then it could use the lower voltage rating power devices for HID lamp ballast system and reduce the size of HID lamp ballast. The proposed ballast controller using micro-controller unit(MCU) controls the frequency to operate the DC-DC converter in critical conduction mode, which reduces the noise of the circuit and improves the efficiency by 2%~4%.

Treatment of simulated wastewater containing Reactive Red 195 by zero-valent iron/activated carbon combined with microwave discharge electrodeless lamp/sodium hypochlorite

A comparative study of treatment of simulated wastewater containing Reactive Red 195 using zero-valent iron/activated carbon （ZVI/AC）, microwave discharge electrodeless lamp/sodium hypochlorite （MDEL/NaCIO） and the combination of ZVI/AC- MDEL/NaCIO was conducted. The preliminary results showed the two steps method of ZVI/AC-MDEL/NaCIO had much higher degradation efficiency than both single steps. The final color removal percentage was nearly up to 100% and the chemical oxygen demand reduction percentage was up to approximately 82%. The effects of operational parameters, including initial pH value of simulated wastewater, ZVI/AC ratio and particle size of ZVI were also investigated. In addition, from the discussion of synergistic effect between ZVI/AC and MEDL/NaCIO, we found that in the ZVI/AC-MEDL/NaCIO process, ZVI/AC could break the azo bond firstly and then MEDLfNaCIO degraded the aromatic amine products effectively. Reversing the order would reduce the degradation efficiency.

Population Distribution of Excited States in Cs Electrodeless Discharge Lamp

We measure the intensity of fluorescence spectral lines of Cs atoms in an electrodeless discharge lamp from visible light to the near-infrared region of 400-100Ohm. To build an excited state Faraday anomalous dispersion optical filter, the population ratios between the excited states are calculated by rate equations and the spontaneous transition probabilities. The electrodeless discharge lamp with populations in the excited states can be used to realize the frequency stabilization reference for lasers at multiwavelength and the excited state Faraday anomalous dispersion optical filter for submarine communication applications in blue-green wavelengths to simplify the system.

Comparison Between X-rays Absorption and Emission Spectroscopy Measurements on a Ceramic Envelop Lamp

Burners of metal halide lamps used for illumination are generally made of polycrystalline alumina ceramic （PCA） which is translucent to visible light. We show that the difficulty of selecting a line of sight through the lamp prevents the use of optical emission diagnostic. X-rays photons are mainly absorbed and not scattered by PCA. Absorption by mercury atoms contributing to the discharge allowed us to determine the density of mercury in the lamp. By comparing diagnostic methods, we put in evidence the difficulty of taking into account the scattering of light mathematically.

Low pressure mercury–argon electrodeless fluorescent lamp simulation using the finite volume method

A finite volume model of a low pressure Ar-Hg electrodeless lamp with external coils is established. The physical configuration is similar to the OSRAM/ENDURA 70 W lamp. A Maxwellian energy distribution is assumed. Two dimensional behaviors of the most important plasma parameters such as the electron density, the electron temperature and the most important mercury states are discussed. Results are in good agreement with former studies and the general understanding in this area. Also, the influence of the argon pressure is studied. Based on the simulation, the population of the main resonance state, Hg （63p1） depends on the argon pressure and the optimized value is about 300 mTorr.

Atomic population distribution of excited states in He electrodeless discharge lamp

Population ratios between excited states are measured to build the excited state Faraday anomalous dispersion optical filter(ESFADOF). We calculate these values between the excited states according to the spontaneous transition probabilities using rate equations and the measured intensities of fluorescence spectral lines of He atoms in an electrodeless discharge lamp in the visible spectral region from 350 to 730 nm. The electrodeless discharge lamp with populations in excited states can be used to realize the frequency stabilization reference of the laser frequency standard. This lamp can also build ESFADOFs for submarine communication application in the blue-green wavelength to simplify the system without the use of a pump laser.

Intelligent Controller of Digital High Intensity Discharge Lamp

High-intensity discharge (HID) lamps include these types of electrical lamps: mercury vapor, metal halide (also HQI), high-pressure sodium, low-pressure sodium and less commonly, xenon short-arc lamps. The light-producing element of these lamp types is a well-stabilized arc discharge contained within a refractory envelope (arc tube) with wall loading in excess of 3 W/cm (19.4 W/in.). Compared to fluorescent and incandescent lamps, HID lamps produce a much larger quantity of light in a relatively small package. With tests made by the National Quality Supervision

Intelligent Controller of Digital High Intensity Discharge Lamp

High intensity discharge (HID) lamps include these types of electrical lamps: mercury vapor, metal halide (also hydraulic quantity indicator),