Drilling Force and Temperature of Bone under Dry and Physiological Drilling Conditions

Many researches on drilling force and temperature have been done with the aim to reduce the labour intensiveness of surgery, avoid unnecessary damage and improve drilling quality. However, there has not been a systematic study of mid- and high-speed drilling under dry and physiological conditions（injection of saline）. Furthermore, there is no consensus on optimal drilling parameters. To study these parameters under dry and physiological drilling conditions, pig humerus bones are drilled with medical twist drills operated using a wide range of drilling speeds and feed rates. Drilling force and temperature are measured using a YDZ-II01W dynamometer and a NEC TVS-500EX thermal infrared imager, respectively, to evaluate internal bone damage. To evaluate drilling quality, bone debris and hole morphology are observed by SEM（scanning electron microscopy）. Changes in drilling force and temperature give similar results during drilling such that the value of each parameter peaks just before the drill penetrates through the osteon of the compact bone into the trabeculae of the spongy bone. Drilling temperatures under physiological conditions are much lower than those observed under dry conditions, while a larger drilling force occurs under physiological conditions than dry conditions. Drilling speed and feed rate have a significant influence on drilling force, temperature, bone debris and hole morphology. The investigation of the effect of drilling force and temperature on internal bone damage reveals that a drilling speed of 4500 r/min and a feed rate of 50 mm/min are recommended for bone drilling under physiological conditions. Drilling quality peaks under these optimal parameter conditions. This paper proposes the optimal drilling parameters under mid- and high-speed surgical drilling, considering internal bone damage and drilling quality, which can be looked as a reference for surgeons performing orthopedic operations.

Effect on the Performance of Drilling Fluids at Downhole Rock Surfaces at Low Temperatures

To maintain gas hydrate stability, low-temperature drilling fluids and high drilling speeds should be used while drilling in gas hydrate-bearing sediments. The effect of the drilling fluid on downhole rock surfaces at low temperatures is very important to increase the drilling rate. This paper analyzed the action mechanism of the drilling fluid on downhole rock surfaces and established a corresponding evaluation method. The softening effect of six simulated drilling fluids with 0.1 wt.% of four common surfactants and two common organic salts on the downhole rock surface strength was evaluated experimentally using the established method at low temperature. The experimental results showed that the surfactants and organic salts used in the drilling fluids aided in the reduction of the strength of the downhole rock surface, and the established evaluation method was able to quantitatively reveal the difference in the softening effect of the different drilling fluids through comparison with water. In particular, the most common surfactant that is used in drilling fluids, sodium dodecyl sulfate（SDS）, had a very good softening effect while drilling under low-temperature conditions, which can be widely applied during drilling in low-temperature formations, such as natural gas hydrate-bearing sediments, the deep seafloor and permafrost.