Health Monitoring of Long-Haul Fiber Communication System Using Chaotic OTDR

A novel chaotic optical time-domain reflectometry(OTDR)-based approach was proposed for monitoring long-haul fiber communication systems with multiple fiber segments. The self-phase modulation and group velocity dispersion effects of the optical cable was considered in demonstrating the proof-of-concept experiment and simulation. In experiments, the correlation peaks are clearly obtained from the correlation trace between the reference and reflected(or scattered) light signals propagating in three optical-fiber segments. The technique affords a high spatial resolution of 2 m, and further long-haul fiber simulations indicate that the sensing distance can be more than 3300 km. Thus, the new proposed technique can be effectively applied for health monitoring of long-haul fiber communication systems.

Transmission Restriction and Suppression of Radio over Fiber Communication System

This article puts forward long-reach and high-performance Radio over Fiber (RoF) Communication Systems.Two schemes are proposed for solving the transmission restriction factors of the RoF system and verifies the system through experiments.One scheme is 40GHz RoF system based on external modulation with odd-order sideband-suppressed.The other one is 40GHz Optical Frequency Division Multiplexing (OFDM) system based on Optical Carrier-Suppression (OCS),external modulation.Both theory and experiment prove that the two systems allow not only low chromatic dispersion,but also long-distance transmission.

Optimization of Spectral Inverters in Optical Fiber Communication Systems with Mid-Span Spectrum Inversion

In this paper, signal distortions caused by spectral inverters which are used in 10Gb/s optical fiber communication systems with mid span spectrum inversion in terms of dispersion shift fibers are analyed numerically. It is shown that there exist the optimal input signal power, fiber length and fiblter bandwidth for the spectral in verters. System transmission penalty can be minimized by optimizing these parameters.

Toward Low-Cost Flexible Intelligent OAM in Optical Fiber Communication Networks

Low-cost,flexible and intelligent optical performance monitoring and management is a key enabling technology for network quality guarantee,especially in the era of explosive growth of communication capacity and network scale.However,to the best of our knowledge,it is extremely challenging to implement real-time performance monitoring and operations,administration and maintenance(OAM) in a highly complex dynamic network.In this paper,we propose an innovative optical identification(OID) scheme that can realize both performance monitoring and some advanced OAM sub-functions.The basic concepts,applications,challenges and evolution directions of this OID tool are also discussed.

Density-matrix-formalism based scheme for polarization mode dispersion monitoring and compensation in optical fiber communication systems

We propose a density-matrix-formalism based scheme to study polarization mode dispersion(PMD)monitoring and compensation in optical fiber communication systems.Compared to traditional monitoring and compensation schemes based on the PMD vector in the Stokes space,the scheme we proposed requires no auxiliary matrices and can be handily extended to any higher-dimensional modal space,which is advantageous in mode-division multiplexing(MDM)systems.A 28 GBaud polarization division multiplexing quadrature phase-shift keying(PDM-QPSK)coherent simulation system is built to demonstrate that our scheme can implement the monitoring and compensation of 170 ps large differential-group-delay(DGD)that far exceeds the typical DGDs in practical optical communication systems.The results verify the effectiveness of the density-matrix-formalism based scheme in PMD monitoring and compensation,thus pave the way for further applications of the scheme in more general MDM optical communication systems.

Review of In‑Vehicle Optical Fiber Communication Technology

With the continuous development of automotive intelligent networking and autonomous driving technologies,the number of in-vehicle electronic systems and applications is increasing rapidly.This change increases the amount of data to be transmitted in the vehicle and puts forward further requirements of higher speed and safety for in-vehicle communication.Traditional vehicle bus technologies are no longer sufficient to meet today’s high-speed transmission requirements,in which copper cables are used extensively,resulting in serious electromagnetic interference(EMI).Vehicle optical fiber communication technology,besides greatly improving the data transmission rate,has the advantages of anti-EMI,reducing cable space and vehicle mass.This paper first presents the motivation of applying vehicle optical fiber communication technology and reviews the development history of vehicle optical fiber communication technology.Then,the paper researches the devel-opment trend of automotive electrical and electronic architecture(EEA),from distributed EEA to domain centralized EEA and zone-oriented EEA.Based on the discussion of the development trend of automotive EEA,an EEA based on vehicle optical fiber communication technology is proposed.Finally,the key points and future directions of vehicle optical fiber communication technology research are highlighted,including vehicle multi-mode optical fiber technology,vehicle optical fiber network protocol,and topology.

Robustness estimation of software-synchronized all-optical sampling for fiber communication systems

The robustness of the software-synchronized all-optical sampling for optical performance monitoring is estimated for 10-Gb/s fiber communication systems. It reveals that the software-synchronized algorithm is sensitive to the signal degradation caused by chromatic dispersion and nonlinearity in optical fibers. The influence of timing jitter and amplitude fluctuation of the sampling pulses is also investigated. It is found that stringent requirements are imposed on the quality of the sampling pulse and the tolerance of 1-dB Q penalty is measured. Considering the practically available optical sampling pulse sources, the results indicate that the amplitude fluctuation of the sampling pulses has the dominant impacts on the software-synchronized method.

Numerical analysis of intermodal delay in few-mode fibers for mode division multiplexing in optical fiber communication systems

In order to achieve higher spectral efficiency, mode division multiplexing (MDM) in few-mode fibers is a new research area. The idea faces lots of technical issues including intermodal delay and mode coupling which limit the achievable length of the system. This paper is designated to complete the analysis of intermodal delay in step-index few-mode fibers. We analyze numerically all the parameters of fiber, which could impact intermodal delay in few-mode fibers and identify the conditions which can increase the number of multiplex modes without significant increase in maximum intermodal delay.

Influence of the nonlinear propagation effect on the optical signal-to-noise ratio of 400G optical fiber communication systems

The influence of the nonlinear propagation effect on three 400 Gb/s/ch （400G） optical fiber communication systems with typical modulation formats, dual-carrier 16-quadrature amplitude modulation （16QAM）, single-carrier 16QAM （single-16QAM）, and four-carrier quadrature phase-shift keying, are investigated. The received optical signal-to-noise ratio （OSNR）, affected by the nonlinear interference noise together with the amplified spontaneous emission noise, are compared with three 400G systems and a standard 100 Gb/s/ch system by numerical simulations. Both single channel and multichannel cases are considered. Single-16QAM is found to have the best OSNR among those modulation formats.

Pilot-added carrier-phase recovery scheme for Nyquist M-ary quadrature amplitude modulation optical fiber communication system

A new two-stage carrier-phase recovery scheme using a combination of an optical pilot-aided algorithm with the crossed constellation transformation algorithm for either square-framed or non-square-framed M-level- quadrature amplitude modulation （QAM） Nyquist systems is proposed. It is verified in 32- and 128-QAM systems that it can provide high linewidth tolerance with little complexity.

High order modulation format identification based on compressed sensing in optical fiber communication system

We propose a method of modulation format identification based on compressed sensing using a high-order cyclic cumulant combined with a binary tree classifier.Through computing the fourth-order cyclic cumulant of the pretreated band signal,which is obtained by compressed sensing with the sampling rate much less than the Nyquist sampling value,the feature vector for classification is extracted.Simulations are carried out in the optical coherent fiber communication system with different modulation formats of multiple phase-shift keying and multiple quadrature amplitude modulation.The results indicate that this method can identify these modulation formats correctly and efficiently.Meanwhile,the proposed method is insensitive to laser phase noise and signal noise.

352-Gbit/s single line rate THz wired transmission based on PS-4096QAM employing hollow-core fiber

We successfully demonstrate 32-Gbaud Probabilistically Shaped 4096-ary Quadrature Amplitude Modulation(PS-4096QAM)TeraHertz(THz)signal wired transmission at 325 GHz over the 1-m Hollow-Core Fiber(HCF)in a photon-assisted THz-wave communication system.By employing advanced Digital Signal Processing(DSP)and the PS technique,the 352-Gbit/s line rate(288-Gbit/s net rate)delivery with a net Spectral Efficiency(SE)of 9 bit/s/Hz is realized in the experiment,satisfying the 0.86-Normalized Generalized Mutual Information(NGMI)Low-Density Parity-Check(LDPC)threshold.

Equivalent Noise Models in Fiber Optical Communication Systems

An equivalent noise model of optical receiver amplifiers as shown in Fig.1 has been given in many fiber optical communication literatures. It is proved in this paper that this equivalent noise model is neither equivalent to the original one nor measurable. The main reason is that the position of the input impedance in this noise model is not the same with its in the typical noise model,but the same S vn , S in with the typical noise model are used. So the equivalent noise model above is wrong and is not fit to be taken into application.

Influence of the nonlinear phase and ASE noise on DPSK balanced optical receiver in optical fiber communication system

The analytical expression of bit error probability in a balanced differential phase-shift keying(DPSK) optical receiver considering nonlinear phase noise and EDFA ASE noise is given,which is very useful to estimate the performance of DPSK balanced and unbalanced receiver in optical communication system.Through analysis,if only nonlinear phase noise is considered,both the balance and unbalanced receivers have the same performances.But if adding the ASE noise of EDFA,the balanced receiver is better.

Polarization Jitters Caused by Fiber Nonlinearity in PM Optical Communication System

The phenomenon of polarization jitters caused by fiber nonlinearity is investigated. A general formula about the polarization jitter is concluded in polarization multiplexing (PM) system based on two orthogonal linear polarization states when the best polarization correction is used. A 100 Gb/s PM system based on NRZ code is investigated by simulation, and the Stocks parameter about polarization jitter and Poincare sphere diagrams are got for different power and phase difference of two orthogonal polarized light. The results show that the polarization jitters will be suppressed when the combined PM signal is the linear or circular polarization state.

Fiber Grating Ring Laser in All Optical Communication System

Erbium fiber grating ring laser (EFRL) witn an integrated travelling wave and low polarization mode noise is reported. Through modulated experiment of a successful 2.488 Gb/s RZ data, it is shown that the EFRL is a promising alternative to DFB lasers for high-speed transmission applications.

Detecting Threats of Acoustic Information Leakage Through Fiber Optic Communications

Information leaks through regular fiber optic communications is possible in the form of eavesdropping on conversations, using standard fiber optic communications as illegal measuring network. The threat of leakage of audio information can create any kind of irregular light emission, as well as regular light beams modulated at acoustic frequencies. For information protection can be used a means of sound insulation, filtration and noising. This paper discusses the technical possibilities of countering threats by monitoring the optical radiation to detect eavesdropping.

2.5 Gbit/s monolithic ICs for optical fiber transmitter and receiver in 0.35 μm CMOS process

2.5 Gbit/s monolithic integrated circuits （ICs） for optical fiber transmitter and receiver in 0.35 μm CMOS （complementary metal-oxide-semiconductor transistor） process are presented. The transmitter, which includes a 4： 1 multiplexer and a laser diode driver （LDD）, has four 622 Mbit/s random signals as its inputs and gets a 2.5 Gbit/s driving signal as its output; the receiver detects a 2.5 Gbit/s random signal and gets four 622 Mbit/s signals at the output. The main circuits include a trans-impedance amplifier （TIA）, a limiting amplifier, a clock and data recovery （CDR） unit, and a 1： 4 demultiplexer （DEMUX）. Test results prove the logic functions of the transmitter to be right, and the 10% to 90% rise and fall times of transmitter＇s output data eye diagram are 211.1 ps and 200 ps, respectively. The sensitivity of the receiver is measured to be better than 20 mV. The root mean square jitter of the DEMUX＇s output data is 15.6 ps and that of the clock after 1： 4 frequency dividing is 1.9 ps. Two chips are both applicable to 2.5 Gbit/s optical fiber communication systems.

Optimization of Apodized Chirped Fiber BraggGrating for Dispersion Compensation

Multiwavelength chirped fiber Bragg grating (MCFBG) is a more valuable approach to chromatic dispersion compensation. And adjusting the structure of FBG will optimize the performance of dispersion compensator in 8×10 Gb/s DWDM network, which is proved by simulating calculation.