Numerical and experimental study on the falling film flow characteristics with the effect of co-current gas flow in hydrogen liquefaction process

Liquid hydrogen storage and transportation is an effective method for large-scale transportation and utilization of hydrogen energy. Revealing the flow mechanism of cryogenic working fluid is the key to optimize heat exchanger structure and hydrogen liquefaction process(LH2). The methods of cryogenic visualization experiment, theoretical analysis and numerical simulation are conducted to study the falling film flow characteristics with the effect of co-current gas flow in LH2spiral wound heat exchanger.The results show that the flow rate of mixed refrigerant has a great influence on liquid film spreading process, falling film flow pattern and heat transfer performance. The liquid film of LH2mixed refrigerant with column flow pattern can not uniformly and completely cover the tube wall surface. As liquid flow rate increases, the falling film flow pattern evolves into sheet-column flow and sheet flow, and liquid film completely covers the surface of tube wall. With the increase of shear effect of gas-phase mixed refrigerant in the same direction, the liquid film gradually becomes unstable, and the flow pattern eventually evolves into a mist flow.

Numerical simulation study on multiphase flow pattern of hydrate slurry

The research on the multiphase flow characteristics of hydrate slurry is the key to implementing the risk prevention and control technology of hydrate slurry in deep-water oil and gas mixed transportation system.This paper established a geometric model based on the high-pressure hydrate slurry experimental loop.The model was used to carry out simulation research on the flow characteristics of gas-liquid-solid three-phase flow.The specific research is as follows:Firstly,the effects of factors such as slurry flow velocity,hydrate particle density,hydrate particle size,and hydrate volume fraction on the stratified smooth flow were specifically studied.Orthogonal test obtained particle size has the most influence on the particle concentration distribution.The slurry flow velocity is gradually increased based on stratified smooth flow.Various flow patterns were observed and their characteristics were analyzed.Secondly,increasing the slurry velocity to 2 m/s could achieve the slurry flow pattern of partial hydrate in the pipeline transition from stratified smooth flow to wavy flow.When the flow rate increases to 3 m/s,a violent wave forms throughout the entire loop.Based on wave flow,as the velocity increased to 4 m/s,and the flow pattern changed to slug flow.When the particle concentration was below 10%,the increase of the concentration would aggravate the slug flow trend;if the particle concentration was above 10%,the increase of the concentration would weaken the slug flow trend,the increase of particle density and liquid viscosity would weaken the tendency of slug flow.The relationship between the pressure drop gradients of several different flow patterns is:slug flow>wave flow>stratified smooth flow.

A new method for identifying flow pattern of spouted fluidized bed by coupling Hilbert-Huang transform characteristics of differential pressure signals in different zones

On a cold spouted fluidized bed,this study compares the characteristic differences in intrinsic mode function(IMF)energy and Hilbert–Huang spectrum between the spout zone and annulus zone under different combinations of spouted gas and fluidized gas flow rates for five typical flow patterns.The energy distribution characteristics under different flow patterns are also analyzed.The Hilbert–Huang spectrum and IMF energy of pressure difference signals exhibit distinct variations in different zones as the flow pattern changes.Moreover,there exists a correlation between the energy in the middle-frequency range and the flow pattern.Leveraging the K-means algorithm,the middle-frequency range energy of IMFs in the spout zone and annulus zone is subjected to clustering analysis,leading to the identification of partition boundaries for each flow pattern.Based on this,a flow pattern identification method of spouted fluidized bed coupled with middle-frequency range energy in spout zone and annulus zone is proposed,which has very high identification accuracy.

Flow excitation mechanisms of unbalanced impeller forces after pump power-trip of ultra-high head pump-turbines

To elucidate the dynamic mechanisms of unbalanced impellers in ultra-high head pump-turbines(PTs),this study employed a one-and three-dimensional coupled method to simulate the pump power-trip(PPT)process of an ultra-high head PT.The investigation revealed two novel pulsation frequency components,denoted as fDVand fINFT,associated with impeller forces.The pulsation intensities of these components were markedly higher than those of rotor-stator interaction frequency components in ultra-high head PTs.Notably,the fDVcomponents exhibited pulsations at 1–2 times the rated rotation frequency of the impeller,spanning the entire transition period.Meanwhile,the fINFTcomponents constituted a complex frequency band with various frequency values,primarily occurring near conditions(Q=0,n=0,M=0,and d M/dt=0).These two pulsation frequency components were predominantly linked to the unsteady evolution of dean vortices inside the volute and complex transitions of the flow pattern within the impeller,respectively.It is crucial to note that these unbalanced flow-induced impeller axial forces can elevate the risk of accidents where the rotor is subjected to significant upwind axial forces.These findings offer valuable insights into mitigating the risk of rotor lifting due to axial forces during PT events in ultra-high head PTs.

Numerical Study of Void Fraction Distribution Propagation in Gas-Liquid Two-Phase Flow

A dynamic propagation model was developed for waves in two-phase flows by assuming that continuity waves and dynamic waves interact nonlinearly for certain flow conditions. The drift-flux model is solved with the one-dimensional continuity equation for gas-liquid two-phase flows as an initial-boundary value problem solved using the characteristic-curve method. The numerical results give the void fraction dis- tribution propagation in a gas-liquid two-phase flow which shows how the flow pattern transition occurs. The numerical simulations of different flow patterns show that the void fraction distribution propagation is deter- mined by the characteristics of the drift-flux between the liquid and gas flows and the void fraction range. Flow pattern transitions begin around a void fraction of 0.27 and end around 0.58. Flow pattern transitions do not occur for very high void concentrations.