In this paper,a kind of lateral stability control strategy is put forward about the four wheel independent drive electric vehicle.The design of control system adopts hierarchical structure.Unlike the previous control ...In this paper,a kind of lateral stability control strategy is put forward about the four wheel independent drive electric vehicle.The design of control system adopts hierarchical structure.Unlike the previous control strategy,this paper introduces a method which is the combination of sliding mode control and optimal allocation algorithm.According to the driver’s operation commands(steering angle and speed),the steady state responses of the sideslip angle and yaw rate are obtained.Based on this,the reference model is built.Upper controller adopts the sliding mode control principle to obtain the desired yawing moment demand.Lower controller is designed to satisfy the desired yawing moment demand by optimal allocation of the tire longitudinal forces.Firstly,the optimization goal is built to minimize the actuator cost.Secondly,the weighted least-square method is used to design the tire longitudinal forces optimization distribution strategy under the constraint conditions of actuator and the friction oval.Beyond that,when the optimal allocation algorithm is not applied,a method of axial load ratio distribution is adopted.Finally,Car Sim associated with Simulink simulation experiments are designed under the conditions of different velocities and different pavements.The simulation results show that the control strategy designed in this paper has a good following effect comparing with the reference model and the sideslip angle is controlled within a small rang at the same time.Beyond that,based on the optimal distribution mode,the electromagnetic torque phase of each wheel can follow the trend of the vertical force of the tire,which shows the effectiveness of the optimal distribution algorithm.展开更多
Three major methods currently in the use of determining vehicle speed based on wheel speeds, the minimum wheel speed, minimum wheel speed corrected by slope method and the Kalman filter method, are analyzed, with meri...Three major methods currently in the use of determining vehicle speed based on wheel speeds, the minimum wheel speed, minimum wheel speed corrected by slope method and the Kalman filter method, are analyzed, with merits and defects of each approach stated. Through simulations, the Kalman filter method based on minimum wheel speed shows improved accuracy, in addition to better adaptivity to vehicle reference speed. It also can be used to acceleration ship regulation （ASR） in part-time four-wheel drive vehicles.展开更多
The distribution of track tension on track link is complex when the tracked vehicles run at a high speed.A multi-drive track link structure,which changes the traditional induction wheel into the driving wheel was prop...The distribution of track tension on track link is complex when the tracked vehicles run at a high speed.A multi-drive track link structure,which changes the traditional induction wheel into the driving wheel was proposed.The mathematical model of the system was established and the distribution of track tension was studied.The combined simulation model of RecurDyn and Simulink of the structure with multi-drive track was established.The simulation results show that our proposed structure has more uniform tension distribution than traditional structures,especially under the high speed condition.The maximum tension can be reduced by 28 kN-36 kN and the transmission efficiency can be improved by10%-16% under high speed condition with this new structure.展开更多
为进一步提高制动能量回收率,考虑不同工况下驾驶员不同制动意图所需的制动效果,提出了一种四驱电动汽车制动控制策略。首先,针对常规制动工况,基于常规制动意图识别,从制动能量回收率、稳定性和安全性角度分别设计控制策略;其次,针对...为进一步提高制动能量回收率,考虑不同工况下驾驶员不同制动意图所需的制动效果,提出了一种四驱电动汽车制动控制策略。首先,针对常规制动工况,基于常规制动意图识别,从制动能量回收率、稳定性和安全性角度分别设计控制策略;其次,针对滑行工况下的不同滑行制动意图,判断电机制动力是否介入及何时介入,并根据驾驶员所需的滑行距离计算电机制动力的大小;然后,由台架试验获得前后电机外特性并建立前后电机最优利用效率模型;最后,利用Carsim和Simulink进行了联合仿真分析。仿真结果表明,在新欧洲驾驶循环(New European Driving Cycle,NEDC)工况下,与并联控制策略相比,能量回收率提升了13.64百分点;在滑行工况下可有效识别驾驶员需求滑行距离,提升了整车滑行经济性。展开更多
基金supported by the National Nature Science Foundation(U1664263)National Key R&D Program of China(2016YFB0101102)。
文摘In this paper,a kind of lateral stability control strategy is put forward about the four wheel independent drive electric vehicle.The design of control system adopts hierarchical structure.Unlike the previous control strategy,this paper introduces a method which is the combination of sliding mode control and optimal allocation algorithm.According to the driver’s operation commands(steering angle and speed),the steady state responses of the sideslip angle and yaw rate are obtained.Based on this,the reference model is built.Upper controller adopts the sliding mode control principle to obtain the desired yawing moment demand.Lower controller is designed to satisfy the desired yawing moment demand by optimal allocation of the tire longitudinal forces.Firstly,the optimization goal is built to minimize the actuator cost.Secondly,the weighted least-square method is used to design the tire longitudinal forces optimization distribution strategy under the constraint conditions of actuator and the friction oval.Beyond that,when the optimal allocation algorithm is not applied,a method of axial load ratio distribution is adopted.Finally,Car Sim associated with Simulink simulation experiments are designed under the conditions of different velocities and different pavements.The simulation results show that the control strategy designed in this paper has a good following effect comparing with the reference model and the sideslip angle is controlled within a small rang at the same time.Beyond that,based on the optimal distribution mode,the electromagnetic torque phase of each wheel can follow the trend of the vertical force of the tire,which shows the effectiveness of the optimal distribution algorithm.
文摘Three major methods currently in the use of determining vehicle speed based on wheel speeds, the minimum wheel speed, minimum wheel speed corrected by slope method and the Kalman filter method, are analyzed, with merits and defects of each approach stated. Through simulations, the Kalman filter method based on minimum wheel speed shows improved accuracy, in addition to better adaptivity to vehicle reference speed. It also can be used to acceleration ship regulation （ASR） in part-time four-wheel drive vehicles.
基金Supported by the National Natural Science Foundation of China(51475045)
文摘The distribution of track tension on track link is complex when the tracked vehicles run at a high speed.A multi-drive track link structure,which changes the traditional induction wheel into the driving wheel was proposed.The mathematical model of the system was established and the distribution of track tension was studied.The combined simulation model of RecurDyn and Simulink of the structure with multi-drive track was established.The simulation results show that our proposed structure has more uniform tension distribution than traditional structures,especially under the high speed condition.The maximum tension can be reduced by 28 kN-36 kN and the transmission efficiency can be improved by10%-16% under high speed condition with this new structure.
文摘为进一步提高制动能量回收率,考虑不同工况下驾驶员不同制动意图所需的制动效果,提出了一种四驱电动汽车制动控制策略。首先,针对常规制动工况,基于常规制动意图识别,从制动能量回收率、稳定性和安全性角度分别设计控制策略;其次,针对滑行工况下的不同滑行制动意图,判断电机制动力是否介入及何时介入,并根据驾驶员所需的滑行距离计算电机制动力的大小;然后,由台架试验获得前后电机外特性并建立前后电机最优利用效率模型;最后,利用Carsim和Simulink进行了联合仿真分析。仿真结果表明,在新欧洲驾驶循环(New European Driving Cycle,NEDC)工况下,与并联控制策略相比,能量回收率提升了13.64百分点;在滑行工况下可有效识别驾驶员需求滑行距离,提升了整车滑行经济性。
