The ocean thermal energy conversion (OTEC) system is a promising solution to provide stable electricity supply. Although the available temperature difference in OTEC systems is small, an ammonia/water mixture as worki...The ocean thermal energy conversion (OTEC) system is a promising solution to provide stable electricity supply. Although the available temperature difference in OTEC systems is small, an ammonia/water mixture as working fluid is expected to decrease irreversible losses in the heat exchangers and to improve system performance. However, in actual heat exchangers, an adequate temperature crossing does not occur in the condenser but in the evaporator. Therefore, clarification of this characteristic is important. To date, the logarithmic temperature difference (LMTD) method is used in performance evaluations of OTEC heat exchangers. This method is of limited use if physical properties of fluids vary. A generalized mean temperature difference (GMTD) method is introduced to perform this evaluation. As changes in fluid property values can be considered in the GMTD method, method dependencies on heat exchanger characteristics, effectiveness, and system characteristics can be studied. In particular, GMTD and LMTD using a pure substance were found to be almost equal. Mean temperature differences using mixtures as working fluid were higher in the evaporator, but lower in the condenser, from the GMTD method than from the LMTD method. For higher ammonia concentrations in ammonia/water mixtures, the mean temperature differences from both methods are different.展开更多
The frequency modulated continuous wave(FMCW)radar has the characteristics of low probability of interception,good hidden property and the ability to counter anti-radiation missiles.This paper proposes a new method fo...The frequency modulated continuous wave(FMCW)radar has the characteristics of low probability of interception,good hidden property and the ability to counter anti-radiation missiles.This paper proposes a new method for high-speed ground moving target detection(GMTD)using triangular modulation FMCW.According to the characteristic of the opposite range shift induced by the upslope and downslope modulation FMCW,the upslope and downslope are imaged,respectively.After compensation of continuous motion of the platform and time difference between upslope and downslope signals for imaging,the moving target can be detected through displaced phase center antenna(DPCA)technology.When the moving target is detected,the moving target image is extracted,and correlation processing is used to obtain the range shift,which can be used to estimate the target radial velocity,and further to find the real position of the target.The effectiveness of this method is verified by the result of computer simulation.展开更多
In the new century, energy and environmental problems are becoming more critical, and the development of natural energy is desired. Low-grade Thermal Energy Conversion(LTEC) is refocused as one of the renewable energy...In the new century, energy and environmental problems are becoming more critical, and the development of natural energy is desired. Low-grade Thermal Energy Conversion(LTEC) is refocused as one of the renewable energy methods. The usefulness of LTEC is expected using hot springs and waste heat. In the case of the Rankine cycle using ammonia as the working fluid, the thermal properties of the working fluid changes in the evaporator. The traditional evaluation method of heat exchanger performance is the LMTD(Logarithmic Mean Temperature Difference) method. On the other hand, the GMTD(Generalized Mean Temperature Difference) method allows the variation of thermal properties in the heat exchanger. The aim of this study is to compare the two methods for the calculation of temperature differences and the corresponding influence on the total performance of the Rankine cycle that is operated using ammonia as a working fluid. As a result, the thermal efficiency of the Rankine cycle is greater than that of the LMTD method. Moreover, the computable range of the GMTD calculation method is less than that of the LMTD calculation method.展开更多
文摘The ocean thermal energy conversion (OTEC) system is a promising solution to provide stable electricity supply. Although the available temperature difference in OTEC systems is small, an ammonia/water mixture as working fluid is expected to decrease irreversible losses in the heat exchangers and to improve system performance. However, in actual heat exchangers, an adequate temperature crossing does not occur in the condenser but in the evaporator. Therefore, clarification of this characteristic is important. To date, the logarithmic temperature difference (LMTD) method is used in performance evaluations of OTEC heat exchangers. This method is of limited use if physical properties of fluids vary. A generalized mean temperature difference (GMTD) method is introduced to perform this evaluation. As changes in fluid property values can be considered in the GMTD method, method dependencies on heat exchanger characteristics, effectiveness, and system characteristics can be studied. In particular, GMTD and LMTD using a pure substance were found to be almost equal. Mean temperature differences using mixtures as working fluid were higher in the evaporator, but lower in the condenser, from the GMTD method than from the LMTD method. For higher ammonia concentrations in ammonia/water mixtures, the mean temperature differences from both methods are different.
基金supported by the National Natural Science Foundation of China (Grant No.60502044).
文摘The frequency modulated continuous wave(FMCW)radar has the characteristics of low probability of interception,good hidden property and the ability to counter anti-radiation missiles.This paper proposes a new method for high-speed ground moving target detection(GMTD)using triangular modulation FMCW.According to the characteristic of the opposite range shift induced by the upslope and downslope modulation FMCW,the upslope and downslope are imaged,respectively.After compensation of continuous motion of the platform and time difference between upslope and downslope signals for imaging,the moving target can be detected through displaced phase center antenna(DPCA)technology.When the moving target is detected,the moving target image is extracted,and correlation processing is used to obtain the range shift,which can be used to estimate the target radial velocity,and further to find the real position of the target.The effectiveness of this method is verified by the result of computer simulation.
文摘In the new century, energy and environmental problems are becoming more critical, and the development of natural energy is desired. Low-grade Thermal Energy Conversion(LTEC) is refocused as one of the renewable energy methods. The usefulness of LTEC is expected using hot springs and waste heat. In the case of the Rankine cycle using ammonia as the working fluid, the thermal properties of the working fluid changes in the evaporator. The traditional evaluation method of heat exchanger performance is the LMTD(Logarithmic Mean Temperature Difference) method. On the other hand, the GMTD(Generalized Mean Temperature Difference) method allows the variation of thermal properties in the heat exchanger. The aim of this study is to compare the two methods for the calculation of temperature differences and the corresponding influence on the total performance of the Rankine cycle that is operated using ammonia as a working fluid. As a result, the thermal efficiency of the Rankine cycle is greater than that of the LMTD method. Moreover, the computable range of the GMTD calculation method is less than that of the LMTD calculation method.
