Xinjiang to Become China's Largest Natural Gas Producer

With the opening of the Kela No. 2 gas field in the Tarim basin in China’s northwest Xinjiang Uygur Autonomous Region on Dec. 1, Xinjiang will produce 10 billion cubic meters of natural gas next year, becoming the country’s largest gas producer, according to an official with the China National Petroleum Corporation.

Conversion of producer gas using NiO/SBA-15 obtained with different synthesis methods

In this study,NiO/SBA-15 was prepared by both direct and post synthesis methods.TEM images revealed that NiO particles aggregated in NiO/SBA-15 obtained with post synthesis method,regardless of NiO loading.However,NiO particles were monodispersed in NiO/SBA-15 with a NiO loading of less than 15 wt%by using the direct synthesis method.In this case,NiO particles aggregated when NiO loading was over 20 wt%.TPR analysis verified that with direct synthesis method the location boundary of NiO particles on outer and pore surface could be observed clearly,whereas that could not observed in the case of post synthesis method.This indicates that the type of synthesis method displays significant effect on the location of NiO particles dispersed into the SBA-15.Producer gas conversion was carried out using NiO/SBA-15 as catalysts,which were synthesized with different synthesis methods.The gas conversion including methanation occurred at low temperature(i.e.,300-400℃)and the reverse water gas shift(RWGS)reaction at hightemperature(i.e.,400-900℃).High temperatures facilitated CO conversion to CO with CO selectivity close to 100%,regardless of the synthesis method of the used catalyst.At low temperatures the dispersion type of NiO particles affectedthe CO,conversion reaction,i.e.,monodispersed Ni0 particles gave a CO selectivity of close to 100%,similar to thatobtained at high temperature.The aggregated NiO particles resuled in a CO selectivity of less than 100%owing to CH,formation,regardless of synthesis method of catalyst.Therefore,NiO/SBA-15 obtained with direct synthesis methodfavored RWGS reaction because of high CO selectivity.NiOSBA-15 obtained with post synthesis method is suited formethanation because of high CH selectivity,and the conversion of CO,to CHa through methanation increased withincreasing NiO loading.

Performance evaluation of a diesel engine by using producer gas from some under-utilized biomass on dual-fuel mode of diesel cum producer gas

Producer gas through gasification of biomass can be used as an alternate fuel in rural areas due to high potential of biomass resources in India.Experiments were conducted to study the performance of a diesel engine(four stroke,single cylinder,5.25 kW) with respect to its thermal efficiency,specific fuel consumption and diesel substitution by use of diesel alone and producer gas-cum-diesel(dual fuel mode).Three types of biomass,i.e.wood chips,pigeon pea stalks and corn cobs were used for generation of producer gas.A producer gas system consisting of a downdraft gasifier,a cooling cum cleaning unit,a filtering unit and a gas air mixing device was designed,fabricated and used to power a 5.25 kW diesel engine on dual fuel mode.Performance of the engine was reported by keeping biomass moisture contents as 8%,12%,16%,and 21%,engine speed as 1 600 r/min and with variable engine loads.The average value of thermal efficiency on dual fuel mode was found slightly lower than that of diesel mode.The specific diesel consumption was found to be 60%-64% less in dual fuel mode than that in diesel mode for the same amount of energy output.The average diesel substitution of 74% was observed with wood chips followed by corn cobs(78%) and pigeon pea stalks(82%).Based on the performance studied,the producer gas may be used as a substitute or as supplementary fuel for diesel conservation,particularly for stationary engines in agricultural operations in the farm.

Enhancing recovery and sensitivity studies in an unconventional tight gas condensate reservoir

The recovery factor from tight gas reservoirs is typically less than 15%, even with multistage hydrauhc tractunng stimulation. Such low recovery is exacerbated in tight gas condensate reservoirs, where the depletion of gas leaves the valuable condensate behind. In this paper, three enhanced gas recovery （EGR） methods including produced gas injection, CO2 injection and water injection are investigated to increase the well productivity for a tight gas condensate reservoir in the Montney Formation, Canada. The production performance of the three EGR methods is compared and their economic feasibility is evaluated. Sensitivity analysis of the key factors such as primary production duration, bottom-hole pressures, and fracture conductivity is conducted and their effects on the well production performance are analyzed. Results show that, compared with the simple depletion method, both the cumulative gas and condensate production increase with fluids injected. Produced gas injection leads to both a higher gas and condensate production compared with those of the CO2 injection, while waterflooding suffers from injection difficulty and the corresponding low sweep efficiency. Meanwhile, the injection cost is lower for the produced gas injection due to the on-site available gas source and minimal transport costs, gaining more economic benefits than the other EGR methods.

Electromotive Force for Solid Oxide Fuel Cells Using Biomass Produced Gas as Fuel

The electromotive force （e.m.f.） of solid oxide fuel cells using biomass produced gas （BPG） as the fuels is calculated at 700-1,200 K using an in-house computer program, based on thermodynamic equilibrium analysis. Tour program also predicts the concentration of oxygen in the fuel chamber as well as the concentration of equilibrium species such as H2, CO, CO2 and CH4. Compared with using hydrogen as a fuel, the e.m.f. for cells using BPG as the fuels is relative low and strongly influenced by carbon deposition. To remove carbon deposition, the optimum amount of H2O to add is determined at various operating temperatures. Further the e.m.f, for cells based on yttria stabilized zirconia and doped ceria as electrolytes are compared. The study reveals that when using BPG as fuel, the depression of e.m.f, for a SOFC using doped ceria as electrolyte is relatively small when compared with that using Yttria stabilized zirconia.

Performance and Economic Analysis of Mulberry Paper Handmade Dryer by Using Downdraft Gasifier

The mulberry paper handmade dryer uses downdraft gasifier, which is a continuous hot air dryer. The downdraft gasifier uses charcoal or wood chip as fuel to produce the producer gas for a dryer heat source. Two steps operation of a dryer as follows： The frst was to reduce mulberry paper pulp moisture by an air vacuum pump; the second was a continuous hot air drying process. The optimum condition drying, the capacity of dryer, the fuel consumption, the drying constant （k） and economics analysis were investigated. It was found that the first step could be to reduce mulberry paper pulp moisture content about 25% and the suitable condition drying was 80 ~C drying temperature, 0.04 kg/s air mass flow rate and 0.29 m/min chain conveyor speed, respectively. The capacity of this dryer was 20 sheets per hour. The quality of mulberry paper product was very good （based on the standard of mulberry paper community 41/2546） and the fuel consumption rate was 5 kg/h （charcoal）. The drying constant was about 0.532933-0.541367 min~ and the drying constant was a function of drying temperature （T）, air mass flow rate （F） and conveyor speed （10 as equation of k（T, F, V） = 0.567494 ＋ 0.000422T- 1.40588F- 0.000205 V （R2 = 0.9254） and the breakeven point of dryer was 0.79 years.

Geochemical characteristics of produced fluids from CBM wells and their indicative significance for gas accumulation in Daning-Jixian block,Ordos Basin

The Daning-Jixian block,the eastern edge of the Ordos Basin,is one of the most potential areas for CO_(2)geological storage,enhanced coalbed methane recovery(ECBM)exploration and production in China in recent decades.The ionic composition and total dissolved solids(TDS)of the produced water,coal organic matter maturity,molecular composition and carbon isotope characteristics of the produced gas were utilized to analyze the hydrogeological condition,CBM generation and migration characteristics in this area.The CBM enrichment patterns and the geological impacts on gas well production characteristics were revealed.The optimal area for CBM development and CO_(2)geological storage in the study area were also proposed.Dominated by the Xueguan reverse fault zone,the hydraulic unit in this area can be divided into two parts(i.e.,the recharge-runoff zone in the east and the weak runoff-stagnation zone in the west).The thermogenic gas is dominating CBM genesis in this area.Secondary biogenic gas replenishment is only distributed in the eastern margin area,where theδ13C1 value is less than the thermal simulation results as an influence of hydrodynamic fractionation.Finally,two models of CBM formation and accumulation were proposed,1)thermogenic CBM migrated by hydrodynamic and resorbed for preservation at impermeable fault boundaries;2)thermogenic CBM trapped by fault and accumulated by hydrodynamic in slope zone.The gas production performance,generally increased from east to west,is mainly dominated by hydrogeological conditions.Generally,the west side of the fault zone is the enrichment and high-yield area for ECBM development and CO_(2)geological storage in the study area.

Experimental evaluation of a 35 kVA downdraft gasifier

Energy conversion systems based on biomass are particularly interesting because biomass utilization effectively closes the carbon cycle besides achieving selfsustainability. Biomass is particularly useful for highly populated and agriculture dependent economic nations like China and India. A compact and cost effective downdrafl gasifcation system was developed. The present paper describes an experimental investigation on a biomass based gasifier engine system with a capacity of 35 kVA for power generation application. The problem of cooling and cleaning the hot and dirty gas from the gasifier has been satisfactorily solved by the effective cooling and filtration system. The gasifier developed is observed to be operation friendly. The quality of gas was evaluated in terms of its composition, conversion efficiency and total particulate matter. The maximum output of the power plant was obtained at the combustion zone temperature of 850~C. The experimental investigations showed that the percen- tage reduction in total particulate matter is 89.32%. The conversion efficiency of the biomass gasifier is found to be dependent on the operation conditions and fuel properties of the gasifier. The optimum value of equivalence ratio was observed to be 0.3134 for achieving the maximum gas conversion efficiency of the present gasifier configuration.