Fabrication and gas sensing property of honeycomb-like ZnO

We report the structural characterization and proposed formation mechanism of honeycomb-like ZnO conglomerations fabricated by direct precipitation method. X-ray diffraction （XRD）, energy-disperse X-ray spectrometry （EDS）, scanning electron microscopy （SEM） showed that the as-prepared ZnO calcined at 700 ℃ were micron sphere particles with honeycomb-like structure. In the UV-vis absorbing spectrum, it was observed that there is a new additional absorption band at 260 nm, and it was speculated that the absorption may be caused by defects on the surface and interface of honeycomb-like ZnO. The as-products showed high sensitivity and short response time to sulfured hydrogen gas. These results demonstrate that honeycomb-like ZnO conglomerations are very promising materials for fabricating H2S gas sensors.

Synthesis of Tin Oxide Through Thermal Decomposition of Sn_2(NH_4)_2(C_2O_4)_3 and Its Gas Sensing Property

Nanocrystalline tin oxide samples were prepared by using Sn2 （NH4 ）2 （C2O4）3 as the precursor. The thermal decompositions were respectively conducted at 250,450 and 650 ℃. TG-DTA, XRD, TEM, FTIR were used to characterize the samples. The indirect heating sensors by using these materials as sensitive bodies were fabricated on an alumina tube with Au electrodes and platinum wires. Sensing properties of these sensors were investigated. It was found that the tin oxide sample obtained by thermal decomposition at 450 ℃ has a higher sensitivity to C2H5OH and a higher selectivity to hexane and ammonia than those obtained via the conventional precipitate method and the working temperatures needed were greatly decreased.

Preparation of polythiophene/WO_3 organic-inorganic hybrids and their gas sensing properties for NO_2 detection at low temperature

Polythiophene/WO3（PTP/WO3）organic-inorganic hybrids were synthesized by an in situ chemical oxidative polymerization method,and char- acterized by X-ray diffraction（XRD）,transmission electron microscopy（TEM）and thermo-gravimetric analysis（TGA）.The Polythiophene/ WO3 hybrids have higher thermal stability than pure polythiophene,which is beneficial to potential application as chemical sensors.Gas sensing measurements demonstrate that the gas sensor based on the Polythiophene/WO3 hybrids has high response and good selectivity for de- tecting NO2 of ppm level at low temperature.Both the operating temperature and PTP contents have an influence on the response of PTP/WO3 hybrids to NO2.The 10 wt%PTP/WO3 hybrid showed the highest response at low operating temperature of 70-C.It is expected that the PTP/WO3 hybrids can be potentially used as gas sensor material for detecting the low concentration of NO2 at low temperature.

Gas-sensing Properties of Bismuth Iron Molybdate Thin Films

The thin film gas sensors of bismuth iron molybdate were prepared by ion beam sputtering technique. The prototype gas sensors studied have high sensitivity and selectivity to reducing gases, such as ethanol vapor, show a long term stability of response under most operating conditions and insensitivity to atmospheric humidity, and respond quickly comparing to traditional sintered gas sensors. The crystallographic structure and phase composition of these thin films were investigated with XRD, XPS and SEM techniques.

Soft template synthesis of high selectivity mesoporous SnO_2 gas sensors

Mesoporous SnO2 was synthesized using cetyltrimethyl ammonium bromide （CTAB） as supermolecule-template by hydrothermal method followed by calcining under different temperature in air. X-ray diffraction analysis （XRD） and transmission electron microscopy （TEM） techniques were used to characterize the structure of mesoporous SnO2. The results indicated that the gas sensors prepared by using mesoporous SnO2 after calcination at 400 ℃ showed quick response and recovery to ethanol at 200 ℃. It was also found that the mesostructure SnO2 with small particle size had higher sensitivity and selectivity to C2HhOH than the SnO2 nanoparticles the particle size of which is 20 nm synthesized by sol-gel method.

Photoinduced Enhancement of Gas Response Behavior of Tetra(heptyloxy)phthalocyanine Thin Film

The response of a spin coated phthalocyanine film to 1ppm NO2 can be increased significantly by light. This may be ascribed to the irritation of phthalocyanine molecules. This irritation decreased the energy changes of the electron transfer between NO2 and phthalocyanine.

Filter paper-templated preparation of ZnO thin films and examination of their gas-sensing properties

ZnO thin films prepared by using quantitative filter paper as a template and Zn（CH3CO2）2.2H2O ethanol precursor solution were characterized by scanning electron microscopy （SEM） and X-ray diffraction （XRD）. The effects of sample calcination temperature, precursor concentration and filter paper types were studied, and the growth process was investigated by infra-red （IR） spectroscopy and thermogravimettic analysis/differential thermal analysis （TGA/DTA）. The results show that samples soaked in a 1.5 mol/L Zn（CH3 CO2）2.2H2O ethanol solution and calcined at 600 ℃ yield ZnO films of uniform particle size, approximately 30, 40 and 50 nm. for fast-, medium- and slow-speed filter papers, respectively. The formaldehyde gas sensing properties of the ZnO nanoparticles were tested, showing that the material prepared from fast-speed filter paper has a higher response to 120-205 ppm formaldehyde at 400 ℃ than that prepared from medium- or slow-sneed paper, which depends on the narticle size.

Nano-WO_3 film modified macro-porous silicon(MPS) gas sensor

We prepared macro-porous silicon（MPS） by electrochemical corrosion in a double-tank cell on the surface of single-crystalline P-type silicon.Then,nano-WO_3 films were deposited on MPS layers by DC facing target reactive magnetron sputtering.The morphologies of the MPS and WO_3/MPS samples were investigated by using a field emission scanning electron microscope.The crystallization of WO_3 and the valence of the W in the WO_3/MPS sample were characterized by X-ray diffraction and X-ray photoelectron spectroscopy,respectively. The gas sensing properties of MPS and WO_3/MPS gas sensors were thoroughly measured at room temperature. It can be concluded that：the WO_3/MPS gas sensor shows the gas sensing properties of a P-type semiconductor gas sensor.The WO_3/MPS gas sensor exhibits good recovery characteristics and repeatability to 1 ppm NO_2.The addition of WO_3 can enhance the sensitivity of MPS to NO_2.The long-term stability of a WO_3/MPS gas sensor is better than that of an MPS gas sensor.The sensitivity of the WO_3/MPS gas sensor to NO_2 is higher than that to NH_3 and C_2H_5OH.The selectivity of the MPS to NO_2 is modified by deposited nano-WO_3 film.