Reconnaissance Geophysical Study on the Southeastern Part of Al-Qashah Aera, KSA

The investigated study area locates about 72 km from Jeddah City, Makkah District, Kingdom of Saudi Arabia. The study mainly aimed to define the most significant zones of possible mineralization and outline their subsurface parameters (location and strike) in the southeast of Jabal Al-Qashah. Several geophysical methods have been conducted to carry out the goal, including ground magnetic, self-potential (SP), and induced polarization (IP) methods. Integrating these methods aims to help delineate the possible mineralization in the study area. The magnetic survey was conducted along 17 profiles where these profiles were chosen to be perpendicular to the strike of the quartz shear zone. Self-potential was applied along with five profiles covering the study area. At the same time, induced polarization was used along with one profile located at the western side of the study area corresponding to some magnetic and SP profiles. The most interesting zones of mineralization were successfully determined by comparing the results of residual magnetic profile (3), SP profile (1), and IP profile, where geological structures control some mineralization.

Application of Geophysical and Remote Sensing Methods to Predict for Potash Resource

1 Introduction Potassium is listed as one of the shortage of mineral resources in china.Geophysical and remote sensing technology plays an important role in prospecting for potash ressources.

Identification methods of coal-bearing source rocks for Yacheng Formation in the western deepwater area of South China Sea

Owing to the fact that the coal-beds are with the characteristics of multi-beds, thin single-bed, rapid lateral changes and deep burial, coal-bearing source rocks are difficult to be identified and predicted, especially in the lower exploration deepwater area. In this paper, a new integrative process utilizing geology and geophysics is proposed for better predicting the distribution of coal-bearing source rocks. Coal-beds were identified by the logging responses of“three higher, three lower, and one expand”and carbargilite were recognized by the characteristics of“four higher and one lower”. Based on the above logical decision, coal-beds and carbargilite can be distinguished automatically by cluster analysis of logging curves in verticality. Within the constraints of well-seismic calibration, the coal-beds group also can be detected in horizontality by the integrated representation of“negative phase, higher Q, lower impedance and lower frequency”within the seismic data. However, the distribution of coal-bearing source rocks utilizing geophysical methodology may do not conform to the geological rules of coal accumulation. And then the main geological controlling factors of coal accumulation are comprehensively analyzed as follows：（1） Paleotopography and tectonic subsidence determine the planar range of terrestrial-marine transitional facies markedly;（2） The relative sea level changes affect the accommodation space and shoreline migration, and limit the vertical range of coal-beds. More specifically, the relationship between the accommodation creation rate and the peat accumulation rate is a fundamental control on coal accumulation. The thickest and most widespread coals form where those two factors reached a state of balance;（3） The supply of autochthonous clasts and the distance between deposition places and paleovegetation accumulated area are the critical factor to form abundant coal, which means that if deposition area is close to paleouplift, there would be sufficient organic matters to form abundant source rocks. The results show that the integrated methods can significantly improve prediction accuracy of coal-bearing source rocks, which is suitable for early exploration of western deepwater area of South China Sea.

Review:Progress in SQUID⁃Based Geophysical Precision Measurement Technology

Superconducting quantum interference device(SQUID),with the advantages of ultra⁃high sensitivity,low noise,broad frequency bandwidth,and excellent low⁃frequency response,is widely used in several geophysical methods,such as vector magnetic survey,electromagnetic method,gravity and gravity gradient measurement.In this paper,the latest technological progress of SQUID and SQUID⁃based geophysical precision measurement technology are described.In addition,the advantages,characteristics,and existing problems of each measurement technology are analyzed.Combined with the requirements of current geophysical technology,the future application prospect is discussed and development suggestions are given.

Application of Environmental Geophysical Prospecting in Environmental Quality Investigation of Reclaimed Land

Traditional geophysical prospecting methods( electromagnetic induction method,high-density resistivity method and ground penetrating radar method) were applied to the environmental quality detection of reclaimed land in the "198" area of Shanghai. According to the results of drilling sampling and laboratory analysis,the accuracy,suitability and consistency of theses geophysical prospecting methods were evaluated.

Integrating Geochemical and Geophysical Method in Coexistence of Oil and Potassium to Identify K-rich Brine:Research and Application in Southwestern Sichuan

Lithology of Triassic in southwestern Sichuan is consistent with the whole basin,and there is no discussion about stratum division,the difference is stratum denudation which is made by the uplifting of Luzhou uplift,especially

Classification and assessment of rock mass parameters in Choghart iron mine using P-wave velocity

Engineering rock mass classification,based on empirical relations between rock mass parameters and engineering applications,is commonly used in rock engineering and forms the basis for designing rock structures.The basic data required may be obtained from visual observation and laboratory or field tests.However,owing to the discontinuous and variable nature of rock masses,it is difficult for rock engineers to directly obtain the specific design parameters needed.As an alternative,the use of geophysical methods in geomechanics such as seismography may largely address this problem.In this study,25 seismic profiles with the total length of 543 m have been scanned to determine the geomechanical properties of the rock mass in blocks Ⅰ,Ⅲ and Ⅳ-2 of the Choghart iron mine.Moreover,rock joint measurements and sampling for laboratory tests were conducted.The results show that the rock mass rating（RMR） and Q values have a close relation with P-wave velocity parameters,including P-wave velocity in field(V;).P-wave velocity in the laboratory(V;) and the ratio of V;V;(i.e.K;= V;/V;.However,Q value,totally,has greater correlation coefficient and less error than the RMR,In addition,rock mass parameters including rock quality designation（RQD）,uniaxial compressive strength（UCS）,joint roughness coefficient（JRC） and Schmidt number（RN） show close relationship with P-wave velocity.An equation based on these parameters was obtained to estimate the P-wave velocity in the rock mass with a correlation coefficient of 91%.The velocities in two orthogonal directions and the results of joint study show that the wave velocity anisotropy in rock mass may be used as an efficient tool to assess the strong and weak directions in rock mass.

Applications of hydrogeophysics in characterization of subsurface architecture and contaminant plumes

Geophysical methods have been applied to a wide range of hydrogeological problems. With improvement in geophysical inversion algorithms and measurement tools, significant achievements have been made in the characterization of subsurface architecture, time-lapse monitoring of hydrogeological process and contaminant plumes delineation. In this paper, we summarize the geophysical methods that are most widely used in hydrogeology including Electrical Resistivity Tomography(ERT), Induced Polarization(IP), Ground Penetrating Radar(GPR) and Electromagnetic Induction(EMI). Three examples including lab and field works are used to demonstrate current application of geophysical methods for characterizing subsurface architecture and contaminant plumes. Though great progress has been made in hydrogeohysics over the last few decades at home and abroad, challenges still remain in practical applications. More recently, hydrogeophysics continues to develop in the areas of establishment of hydrogeophysical models, large-scale architecture characterization, uncertainty analysis, biogeochemical process monitoring and ecosystem science.

Mapping Subsurface Seepage Flow Patterns in Proximity to a Coal Combustion Residual Landfill Using Electrical Resistivity Tomography

Electrical resistivity tomography data were acquired in proximity to the coal combustion residual landfill in an effort to image and analyze seepage pathways through the shallow residual soil and underlying karsted limestone bedrock. The water table is at a depth of more than 45 m. The most prominent subsurface seepage pathways identified on the acquired electrical resistivity tomography data are located immediately adjacent to the toe of the landfill and are attributed to stormwater run-off. The moisture content of the limestone appears to decrease gradually with increasing distance from the toe of the landfill, suggesting there is also a horizontal component of moisture flow in the subsurface. Shallow limestone with higher moisture content generally underlies or is in close proximity to anthropogenic features such as drainage ditches and clay berms that are designed to channel run-off. At one location, electrical resistivity tomography data were acquired along essentially the same traverse at different times of the year, and the resistivity of shallow limestone overall was lower on the data acquired after heavy rains.

Trends in gravity changes from 2009 to 2013 derived from ground-based gravimetry and GRACE data in North China

North China is a key region for studying geophysical progress. In this study, ground-based and Gravity Recovery and Climate Experiment（GRACE） gravity data from 2009 to 2013 are used to calculate the gravity change rate（GCR） using the polynomial fitting method. In general, the study area was divided into the Shanxi rift, Jing-Jin-Ji（Beijing-Tianjin-Hebei Province）, and Bohai Bay Basin（BBB） regions. Results of the distribution of the GCR determined from ground-based gravimetry show that the GCR appears to be ＂negativepositive-negative＂ from west to east, which indicates that different geophysical mechanisms are involved in the tectonic activities of these regions. However, GRACE solutions are conducted over a larger spatial scale and are able to show a difference between southern and northern areas and a mass redistribution of land water storage.