Heavy Metal Assessment among Chinese Nonferrous Metal-exposed Workers from the Jinchang Cohort Study

Environmental exposure to heavy metals has been linked to a wide range of human health hazards. We detected the levels of 15 metals in urine samples from 500 representative sub-samples in an ongoing occupational cohort study （Jinchang Cohort） to directly evaluate metal exposure levels. Fifteen metals, namely As, Ba, Be, Cd, Cs, Cr, Co, Cu, Pb, Mn, Ni, Se, TI, U, and Zn, were detected by inductively coupled plasma quadruple mass spectrometry. The results showed that median creatinine adjustment and geometric mean urinary metal levels were higher in the heavy metal-exposed group, except Se and Zn, than other reported general or occupational populations. Further studies should address the effects of heavy metals on human health.

Ecological risk assessment of heavy metals in surface seawater and sediment near the outlet of a zinc factory in Huludao City, Liaoning Province, China

At present, the methods widely applied to assess ecological risk of heavy metals are essentially single-point estimates in which exposure and toxicity data cannot be fully used and probabilities of adverse biological effects cannot be achieved. In this study, based on investigation of concentrations of six heavy metals(As, Hg, Pb, Cd, Cu, and Zn) in the surface seawater and sediment near the outlet of a zinc factory, located in Huludao City, Liaoning Province, China, a tiered approach consisting of several probabilistic options was used to refi ne ecological risk assessment for the individuals. A mixture of various heavy metals was detected in the surface seawater, and potential ecological risk index(PERI) was adopted to assess the potential ecological risk of heavy metals in the surface sediment. The results from all levels of aquatic ecological risk assessment in the tiered framework, ranging from comparison of single effects and exposure values to the use of distribution-based Hazard Quotient obtained through Monte Carlo simulation, are consistent with each other. Briefl y, aquatic Zn and Cu posed a clear ecological risk, while Cd, Pb, Hg, and As in the water column posed potential risk. As expected, combined ecological risk of heavy metal mixture in the surface seawater was proved signifi cantly higher than the risk caused by any individual heavy metal, calculated using the concept of total equivalent concentration. According to PERI, the severity of pollution by the six heavy metals in the surface sediment decreased in the following sequence: Cd>Hg>As>Pb>Cu>Zn, and the total heavy metals in the sediment posed a very high risk to the marine environment. This study provides a useful mathematical framework for ecological risk assessment of heavy metals.

PM_(2.5), PM_(10) and health risk assessment of heavy metals in a typical printed circuit noards manufacturing workshop

A typical Printed Circuit Board（PCB） manufacturer was chosen as the object of this study.During PCB processing, fine particulate matter and heavy metals（Cu, Zn, Pb, Cr, Cd and Ni）will be released into the air and dust, which then impact workers＇ health and the environment. The concentrations of total suspended particle（TSP）, PM10 and PM2.5in the off-site were 106.3, 90.0 and 50.2 μg/m3, respectively, while the concentrations of TSP, PM10 and PM2.5in the workshops ranged from 36.1 to 365.3, from 27.1 to 289.8 and from 22.1 to212.3 μg/m3, respectively. Almost all six of the heavy metals were detected in all of the particle samples except Cd. For each workshop, it was obvious that Zn was the most enriched metal in TSP, followed by Cu 〉 Pb（Cr） 〉 Ni 〉 Cd, and the same trend was found for PM10 and PM2.5. In the dust samples, Cu（which ranged from 4.02 to 56.31 mg/g） was the most enriched metal, followed by Zn, Cr, Pb, Ni and Cd, and the corresponding concentrations ranged from 0.77 to 4.47, 0.37 to 1.59, 0.26 to 0.84, 0.13 to 0.44 and nd to0.078 mg/g, respectively. The health risk assessment showed that noncancerous effects are unlikely for Zn, Pb, Cr, Cu, Cd and Ni. The carcinogenic risks for Cd and Ni were all lower than 10-6, except for Cr. This result indicates that carcinogenic risks for workers are relatively possible in the workshops. These findings suggest that this technology is advanced from the perspective of environmental protection in the waste PCB＇s recycling industry.

Particle size distribution and characteristics of heavy metals in road-deposited sediments from Beijing Olympic Park

Due to rapid urbanization and industrialization, heavy metals in road-deposited sediments（RDSs） of parks are emitted into the terrestrial, atmospheric, and water environment, and have a severe impact on residents＇ and tourists＇ health. To identify the distribution and characteristic of heavy metals in RDS and to assess the road environmental quality in Chinese parks, samples were collected from Beijing Olympic Park in the present study. The results indicated that particles with small grain size（〈150 μm） were the dominant fraction. The length of dry period was one of the main factors affecting the particle size distribution, as indicated by the variation of size fraction with the increase of dry days. The amount of heavy metal（i.e., Cu, Zn, Pb and Cd） content was the largest in particles with small size（〈150 μm） among all samples. Specifically, the percentage of Cu, Zn, Pb and Cd in these particles was 74.7%, 55.5%, 56.6% and 71.3%, respectively.Heavy metals adsorbed in sediments may mainly be contributed by road traffic emissions. The contamination levels of Pb and Cd were higher than Cu and Zn on the basis of the mean heavy metal contents. Specifically, the geoaccumulation index（I geo） decreased in the order：Cd〉Pb〉Cu〉Zn. This study analyzed the mobility of heavy metals in sediments using partial sequential extraction with the Tessier procedure. The results revealed that the apparent mobility and potential metal bioavailability of heavy metals in the sediments, based on the exchangeable and carbonate fractions, decreased in the order： Cd〉Zn≈Pb〉Cu.