HIGH TEMPERATURE MATERIALS AND STRENGTH STUDY IN CHINA

In the past half century China has developed and formed her own system ofhigh temperature materials for power, automobile and aero-engine industries in the temperature rangefrom 550 deg C to 1100 deg C. These high temperature materials include heat-resisting steels,iron-base, nickel-iron-base and nickel-base superalloys. Some achievements - in high temperaturestrength study, new technologies and new alloy development are also discussed.

Mechanical Properties with High Temperature and the Microstructure of Carbon/Phenolic Ablative Composites

Carbon fiber reinforced phenolic based composites were prepared by laminating molding. The variation in mechanical characteristics of composites was evaluated with heating temperature and procedure. The microstructures of composites at different temperatures were observed by optical microscope and scanning electron microscope, respectively. The results showed that the main weight loss range of carbon/phenolic is from 300 to 800 ℃, before 700 ℃ the weight loss was resulted from pyrolysis and after that the weight loss was mainly by oxidation in the fiber phase; with the heat treatment temperature rising, the bonding at the interface of carbon fibers and resin matrix weakened; in the pyrolysis temperature range, the interlaminar shear strength（ILSS） of carbon/phenolic showed a rapid drop with temperature rising, and then decrease in the rate of ILSS became relatively slower; the fiber oxidation had little influence on the ILSS.

Refractory Raw Materials

Products： tabular alumina, sintered mullite, rare earth corundum, active alumina, 99 alumina ceramic ball, ceramic lining and Zirconia ring series.

Performance of Nonwoven Filter Materials Based on the Operating Condition

The practical condition of needle-punched filters applied in coal-fired power plants is investigated. According to the actual operating conditions, two common filters (glass fiber filter and polyphenylene sulfide (PPS) filter) are selected for experiment. The performance of these two kinds of filter is compared based on a series of tests such as resistance to the acid and alkali, oxidation resistance,hydrolysis resistance,and wear resistance. Experimental results show that PPS filter materials have better properties than those of glass filter material except oxidation resistance. Composite filter mixed glass fiber and PPS is recommended for polluters because of its good properties in all aspects.

R&D STATUS ON INTERMETALLICS IN CHINA

This paper briefiy introduces the R&D of intermetallics in China. R&D on intermetallics in a national scale in China began near ten years ago. The investigation in past years focused on the fundamental research and materials development. A significant progress has been made. Various components that made of Ti3Al Ni3Al, TiAl and Fe3Al have been successfully manufactured Some of them have been evaluted. It is expected that some intermetallic alloys will be produced in an industrial scale in the near future.

Nanotwinning induced decreased lattice thermal conductivity of high temperature thermoelectric boron subphosphide (B12P2) from deep learning potential simulations

Boron subphosphide(B_(12)P_(2))is a promising high temperature thermoelectric material due to its good thermal stability,and chemical inertness.However,the thermal properties of B_(12)P_(2) have not been well revealed so far.Here,we first develop a deep learning potential for B_(12)P_(2) based on quantum mechanical calculations.Then the isotropic lattice thermal conductivity(LTC)of crystalline B_(12)P_(2) is predicted to be 39.70±4.38 W/m⋅K from molecular dynamics simulations using this deep learning potential.The LTC exhibits the relationship ofκL~1/T in the temperature range of 300~1500 K.More important,a twin boundary strategy is proposed to reduce the LTC of B_(12)P_(2).In nanotwinned B_(12)P_(2),the phonon transport in all directions is significantly suppressed by twin boundaries(TBs)with the isotropic LTC of 15.85±2.70 W/m⋅K,especially in the direction normal to the TB plane.The decrease of vibrational density of states and phonon participation ratio due to TBs’phonon scattering is the main reason of the low LTC in nanotwinned B_(12)P_(2).In addition,the elastic moduli(B and G)of B_(12)P_(2) crystal decrease by less than 7%after inducing TBs,which suggests that the mechanical properties are not significantly affected by TBs.Overall,this work enriches our understanding of the thermal properties of B_(12)P_(2) and offers a promising approach,i.e.,introducing TBs,to design high-performance thermoelectric materials.