Application of carbon composite iron ore hot briquette to innovative ironmaking process

As a new type of ironmaking raw materials,carbon composite iron ore hot briquette(CCB) is the product of fine iron ore and fine coal by hot briquetting process.On basis of experimental research on the manufacturing and metallurgical properties of CCB,this study focused on the application of CCB to blast furnace ironmaking and newly-developed shaft furnace smelting reduction processes.Firstly,the metallurgical properties of CCB are experimentally tested and compared with the common iron-bearing burdens.Then,the effects of charging CCB on blast furnace operation are numerically analyzed by means of multi-fluid blast furnace model,and the flowchart and pilot test of CCB-Shaft furnace smelting reduction process are briefly introduced.

Gas release characteristics during carbonization of iron coke hot briquette and influence of heating rate

The release characteristics of CH_(4),H_(2),CO and CO_(2) from iron coke hot briquette(ICHB)during carbonization were studied.The results show that compared with briquette without iron ore,Fe_(3)O_(4) can inhibit the release rate of H2 and promote the production of CO and CO_(2).In addition,when the heating rate increases from 3 to 7℃/min,the release rates of CH4 and H2 increase,while the release rates of CO and CO_(2) first increase and then decrease.The carbonization process of ICHB was segmented,and corresponding kinetic analysis was carried out.The results show that the activation energy of StageⅡand StageⅣis higher in the carbonization process of ICHB,and the active pyrolysis of coal and the reduction of iron ore occur in these two stages.In addition,the effect of heating rate on the kinetic parameters of ICHB carbonization process was investigated.It was found that when the heating rate increased,the reaction activation energy of StageⅣdecreased first and then increased,which was consistent with the release law of CO and CO_(2).The analysis showed that the increase in heating rate leads to more reactions at higher temperatures,resulting in an increase in the release rate of some gases.In addition,thermal hysteresis can also cause some processes to fail to fully react at the end of heating.It is also found that the apparent activation energy and preexponential factor have kinetic compensation effect during the car-bonization of ICHB.

Non-isothermal reduction process analysis of iron-bearing burden with charging iron coke hot briquette under simulated blast furnace conditions

Highly reactive iron coke hot briquette(ICHB)prepared by carbonizing the agglomerate of iron-bearing substance and blended coals is regarded as an alternative fuel to mitigate carbon emission and energy consumption of blast furnace.Simultaneously,the reduction process of iron-bearing burden is extremely crucial for blast furnace smelting.The effects of ICHB on the non-isothermal reduction process of iron-bearing burden with different reduction properties were thus experimentally studied under the conditions of simulated blast furnace lump zone(below 1100°C),and the related mechanism was discussed and analyzed.The results showed that the non-isothermal reduction process of iron-bearing burden is promoted by adding ICHB.As the charging ratio of ICHB is increased from 0%to 30%,the reduction degree of pellet is increased from 22.91%to 36.62%,but the increased amplitude is leveled off.Furthermore,the reduction degree of sinter is raised from 35.10%to 93.33%.It is also indicated that the promotion effect of ICHB on the non-isothermal reduction of iron-bearing burden depends on the reduction property of burden.Compared with the burden with poor reduction performance(such as pellet 1),the promotion is more significant for the burden with good reduction property(such as sinter 1)since the reduction reaction of iron oxide in iron-bearing burden and the gasification of carbon in ICHB are remarkably reinforced each other.The practical application of ICHB in blast furnace should be utilized with highly reductive iron-bearing burden.