Study on optical constants inversion and infrared transmission characteristics of aerosol particles

Based on the experimental infrared spectral transmittances,an inverse model has been developed to determine the optical constants of the aerosol particles (SiO2 and Al2O3).Combined with the Mie theory and Kramers-Kronig (K-K) relations,the complex refractive indices of the SiO2 and Al2O3 particles are retrieved.The effects of the measurement errors on the inverse results are also investigated.With the optical constants inversed from the experiment,the discrete ordinate method (DOM) is used to calculate the infrared transmission characteristics of the aerosol particle cloud.Considering the multi-scattering and self-emission of the particles,the equivalent transmittance ratio (ETR) is suggested to evaluate the infrared transmission characteristics of the aerosol particles.Particular attention is given to analyze the effects of the volume fraction and diameters on infrared transmission characteristics.When the volume fraction is larger than 0.001,the particle diameter has little effect on the infrared transmission characteristics.For the uniform monodisperse particles in the detection waveband range of 3-5 μm and 8-12 μm,there exists a critical diameter where the ETR reaches the minimum value.In addition,the ETR of 3-5 μm is smaller than that of 8-12 μm with the same volume fraction and particle diameter.

Structural properties of a-SiO_x:H films studied by an improved infrared-transmission analysis method

An improved method of fitting point-by-point is proposed to determine the absorption coefficient from infrared （IR） transmittance. With no necessity of empirical correction factors, the absorption coefficient can be accurately determined for the films with thin thicknesses. Based on this method, the structural properties of the hydrogenated amorphous silicon oxide materials （a-SiOx：H） are investigated. The oxygen-concentration-dependent variation of the Si-O-Si and the Si-H related modes in a-SiOx：H materials is discussed in detail.

N-type GaSb single crystals with high below-band gap transmission

Te-doped GaSb single crystals are studied by measuring Hall effect, infrared （IR） transmission and photoluminescence （PL） spectra. It is found that the n-type GaSb with IR transmittance can be obtained as high as 60% by the critical control of the Te-doping concentration and electrical compensation. The concentration of the native acceptor-associated defects is apparently low in the Te-doped GaSb compared with those in undoped and heavily Te-doped GaSb. The mechanism for the high IR transmittance is analyzed by considering the defect-involved optical absorption process.

Transmission Properties of a New Glass Ceramic and Doped with Co^(2+) as Saturable Absorber for 1.54 μm Er Glass Short Pulse Laser

The preparation and characteristics of a new transparent glass ceramic were described. Crystal phase particles with nanometer size were successfully precipitated in glass matrix, which was confirmed to be one of indium aluminum zinc oxide compounds （InxAlrZn2O）. The presence of aluminum （A1） and indium （In） impurities in the zinc oxides （ZnO） crystal lattice leads to some changes of the carrier concentration in the material and then promote the sharply changes of transmission spectra in IR range wavelength. And subsequently, the IR cut-off edge blue shifted from 5.5 pm in base glass to 3 μm in transparent glass ceramic sample. Furthermore, passive Q switched 1.54 ktm Er glass laser pulses with pulse energy of 10 mJ and pulse width of 800 ns were successfully obtained by using the cobalt doped transparent glass ceramic as a saturable absorber.

Fibrinogen Adsorption on Biomaterials as Characterized by Transmission FTIR Spectroscopy

The adsorption of plasma proteins onto biomaterials can be characterized by either the amount of adsorbed protein or the conformation of the adsorbed proteins. The adsorption characteristics of biomaterials are important for hemocompatibility evaluation. In this investigation, the amount of adsorbed human fibrinogen (HFG) and the conformation of the adsorbed HFG on different surfaces were measured simultaneously using transmission FTIR. The surface materials included CaF 2, polymethyl methacrylate (PMMA), type II polyurethane made by Chengdu University of Science & Technology, pellethane 2363 55D and pellethane 2363 80A. The results indicate that both the amount of adsorbed protein and the conformation of the adsorbed protein can be measured simultaneously using a single transmission FTIR technique. The result also suggests that a single parameter, either the adsorbed amount or the conformation of the adsorbed HFG, can not provide complete information about the hemocompatibility of the biomaterials.

Properties of Gallium Phosphide Thick Films Prepared on Zinc Sulfide Substrates by Radio-Frequency Magnetron Sputtering

Radio-frequency （RF） magnetron sputtering was employed to prepare gallium phosphide （GAP） thick films on zinc sulfide （ZnS） substrates by sputtering a single crystalline GaP target in an Ar atmosphere. The infrared （IR） transmission properties, structure, morphology, composition and hardness of the film were studied. Results show that both amorphous and zinc-blende crystalline phases existed in the GaP film in almost stoichiometric amounts. The GaP film exhibited good IR transmission properties, though the relatively rough surface and loose microstructure caused a small loss of IR transmission due to scattering. The GaP film also showed a much higher haraness than the ZnS substrate, thereby providing good protection to ZnS.

Capuli cherry-mediated green synthesis of silver nanoparticles under white solar and blue LED light

In this article, the Capuli （Prunus serotina Ehrh. var. Capuli） cherry extract was used for the synthesis of silver nanoparticles （AgNPs） in the presence of white/visible solar and blue light-emitting diode （LED） light. For the characterization of the extract and the AgNPs, Fourier transform infrared spectroscopy and ultraviolet-visible spectroscopy were employed, along with hydrodynamic particle size analysis, trans- mission electron microscopy and X-ray diffraction. The Ag nanospheres obtained using white light were 40-100 nm in diameter and exhibited an absorption peak at λmax= 445 nm, whereas those obtained using blue LED light were 20-80 nm in diameter with an absorption peak at λmax= 425 nm. Thermal analysis revealed that the content of biomolecules surrounding the AgNPs was about 55-65%, and it was also found that blue LED light AgNPs （56.28%, 0.05 mM） had a higher antioxidant efficacy than the white solar light AgNPs （33.42%, 0.05 mM） against l,l-diphenyl-2-picrylhydrazyl. The results indicate that obtaining AgNPs using a blue LED light may prove to be a simple, cost-effective and easily reproducible method for creating future nanopharmaceuticals.

Systematic study of Ce^(3+) on the structural and magnetic properties of Cu nanosized ferrites for potential applications

Ce^（3＋） substituted Cu-spinel nanoferrites CuCe_xFe_（2-x）O_4（x=0.00, 0.02, 0.04, 0.06, 0.08 and 0.10） were synthesized via sol-gel self-combustion hybrid route. Single phase spinel ferrite of Cu nanoferrites were examined using X-ray diffraction（XRD） analysis whereas the multiphase structure was observed as Ce contents increased from x=0.06. Field emission scanning electron microscopy（FESEM）, Thermogravimetric and differential thermal analysis（TGA and DTA） and Fourier transform infrared spectroscopy（FTIR） were used to find out the morphology phase and metal stretching vibrations of Ce^（3＋） substituted nanocrystalline ferrites. The crystallite size was increased and found in the range of 25-91 nm. The agglomerations in Cu ferrite samples increase as the Ce^（3＋） concentration increases. The magnetic properties such as remanence, saturation magnetization, coercivity, Bohr magneton and magnetocrystalline anisotropy constant（K） were determined using M-H loops recorded from a vibrating sample magnetometer（VSM）. Saturation magnetization, remanence and coercivity are increased as the Ce^（3＋）contents increase in Cu nanocrystalline samples. Moreover, law of approach to saturation（LoA） was used to calculate the maximum value of saturation for Ce-doped Cu nanoferrites. The soft magnetic behaviour of the Cu nanoferrite is observed as compared to the samples substituted with the increased Ce contents in Cu nanocrystalline ferrite. Bohr magneton and magnetocrystalline anisotropy are found to increase with the substitution of rare earth Ce^（3＋） contents in Cu spinel nanocrystalline ferrite. Cedoped Cu nanocrystalline ferrites with excellent properties may be suitable for potential applications in sensing, security, switching, core, multilayer chip inductor, biomedical and microwave absorption applications.