In co-ionic conducting solid oxide fuel cell （SOFC）, both oxygen ion （O2） and proton （H＋） can transport through the electrolyte, generating steam in both the an-ode and cathode. Thus the mass transport phenomen...In co-ionic conducting solid oxide fuel cell （SOFC）, both oxygen ion （O2） and proton （H＋） can transport through the electrolyte, generating steam in both the an-ode and cathode. Thus the mass transport phenomenon in the electrodes is quite different from that in conventional SOFC with oxygen ion conducting electrolyte （O-SOFC） or with proton conducting electrolyte （H-SOFC）. The generation of steam in both electrodes also affects the concentration over-potential loss and further the SOFC performance. However, no detailed modeling study on SOFCs with co-ionic electrolyte has been reported yet. In this paper, a new mathematical model for SOFC based on co-ionic electrolyte was developed to predict its actual performance considering three major kinds of overpotentials. Ohm＇s law and the Butler-Volmer formula were used to model the ion conduction and electrochemical reactions, respectively. The dusty gas model （DGM） was employed to simulate the mass transport processes in the porous electrodes. Parametric simulations were performed to investigate the effects of proton transfer number （tH） and current density （jtotal） on the cell performance. It is interesting to find that the co-ionic conducting SOFC could perform better than O-SOFC and H-SOFC by choosing an appropriate proton transfer number. In addition, the co-ionic SOFC shows smaller difference between the anode and cathode concentration overpotentials than O-SOFC and H-SOFC at certain t H values. The results could help material selection for enhancing SOFC performance.展开更多
Ce0.85Sm0.15O1.925 （SDC） and La0.9Sr0.1Ga0.5Mg0.2O2.85 （LSGM） were synthesized using Glycine-Nitrate Process （GNP）, and the composite electrolytes were prepared by mixing SDC and LSGM. An X-ray diffraction patte...Ce0.85Sm0.15O1.925 （SDC） and La0.9Sr0.1Ga0.5Mg0.2O2.85 （LSGM） were synthesized using Glycine-Nitrate Process （GNP）, and the composite electrolytes were prepared by mixing SDC and LSGM. An X-ray diffraction pattern indicated that the mixture of SDC and LSGM consisted of their original phases after heating at 1450 ℃ for 10 h. The electronic conductivity of SDC-LSGM composite electrolytes were measured by direct current polarization method using Hebb-Wagner ion blocking cell at 700-800 ℃ in the oxygen partial pressure range of 104-10-20 MPa and compared with the results of SDC. Typical polarization curves, which were theoretically predicted, were observed on all the samples. The slopes of lgσe-lgPo2 plot for all the composite electrolytes agreed with the theoretically predicted value of-1/4 at some intermediate oxygen partial pressures and -1/6 at low oxygen partial pressure. The electronic conductivity of SDC-LSGM composite electrolytes decreased with the increase in LSGM content, whereas the ionic transport number ti of all the samples increased with the increase in LSGM content.展开更多
Dense sintered bodies of proton conducting BaZrO3 (BZ) and Y-doped BaZrO3 (BZ-Y) were obtained at 1600℃ for a short sintering time of 5 hours, by the addition of NiO as a sintering promotion agent. The relative densi...Dense sintered bodies of proton conducting BaZrO3 (BZ) and Y-doped BaZrO3 (BZ-Y) were obtained at 1600℃ for a short sintering time of 5 hours, by the addition of NiO as a sintering promotion agent. The relative density and grain growth of samples, Ni-doped BaZrO3 (BZ-N) and Ni, Y co-doped BaZrO3 (BZ-NY), were increased with increasing Ni addition. The sinterability of BZ-NY was greatly improved just to add only 0.6 mol% Ni and the relative density of this sample was more than 98%, in contrast to that of 60% at most for BZ-Y without Ni addition. Electrical conductivity of BZ-NY added Ni 1.0 mol%, BaZr0.91Ni0.01Y0.08O3-α, was more than 10-3 S.cm-2 at 900℃?in a wet 1% hydrogen atmosphere, which value was 10 times higher than that of BZ-Y. In addition, the kind of electrical conduction carrier and an ionic transport number were also examined by employing various concentration cells. It was found that the proton conduction was dominant for both BZ-N and BZ-NY samples, although BZ-NY showed scarcely oxygenion conduction approximately 10% in a high temperature range higher than 800℃. From these results, as mall amount of Ni addition found to be effective for improvement of both the sinterability and the electrical conductivity.展开更多
A series of solid electrolytes (Ce0.8RE0.2)1 xMxO2-δ(RE: Rare earth, M: Alkali earth) were prepared by sol-gel methods. XRD indicated that a pure fluorite phase was formed at 800°C. The synthesis temperature by ...A series of solid electrolytes (Ce0.8RE0.2)1 xMxO2-δ(RE: Rare earth, M: Alkali earth) were prepared by sol-gel methods. XRD indicated that a pure fluorite phase was formed at 800°C. The synthesis temperature by the sol-gel methods was about 700°C lower than by the traditional ceramic method. The electrical conductivity and impedance spectra were measured. XPS showed that the oxygen vacancy increased obviously by doping MO, thus, resulting in the increase of the oxygen ionic transport number and conductivity. The performance of ceria-based solid electrolyle was improved. The effects of RE2O3 and MO on the electrical properties were discussed. The conductivity and the oxygen ionie transport number of (Ce0.8Sm0.2)1 0.05Ca0.05O2-δ is 0.126 S·cm-1 and 0.99 at 800°C, respectively.展开更多
基金supported by Research Grant Council (RGC) of Hong Kong (PolyU 5238/11E)
文摘In co-ionic conducting solid oxide fuel cell （SOFC）, both oxygen ion （O2） and proton （H＋） can transport through the electrolyte, generating steam in both the an-ode and cathode. Thus the mass transport phenomenon in the electrodes is quite different from that in conventional SOFC with oxygen ion conducting electrolyte （O-SOFC） or with proton conducting electrolyte （H-SOFC）. The generation of steam in both electrodes also affects the concentration over-potential loss and further the SOFC performance. However, no detailed modeling study on SOFCs with co-ionic electrolyte has been reported yet. In this paper, a new mathematical model for SOFC based on co-ionic electrolyte was developed to predict its actual performance considering three major kinds of overpotentials. Ohm＇s law and the Butler-Volmer formula were used to model the ion conduction and electrochemical reactions, respectively. The dusty gas model （DGM） was employed to simulate the mass transport processes in the porous electrodes. Parametric simulations were performed to investigate the effects of proton transfer number （tH） and current density （jtotal） on the cell performance. It is interesting to find that the co-ionic conducting SOFC could perform better than O-SOFC and H-SOFC by choosing an appropriate proton transfer number. In addition, the co-ionic SOFC shows smaller difference between the anode and cathode concentration overpotentials than O-SOFC and H-SOFC at certain t H values. The results could help material selection for enhancing SOFC performance.
基金the National Natural Science Foundation of China (10674034)
文摘Ce0.85Sm0.15O1.925 （SDC） and La0.9Sr0.1Ga0.5Mg0.2O2.85 （LSGM） were synthesized using Glycine-Nitrate Process （GNP）, and the composite electrolytes were prepared by mixing SDC and LSGM. An X-ray diffraction pattern indicated that the mixture of SDC and LSGM consisted of their original phases after heating at 1450 ℃ for 10 h. The electronic conductivity of SDC-LSGM composite electrolytes were measured by direct current polarization method using Hebb-Wagner ion blocking cell at 700-800 ℃ in the oxygen partial pressure range of 104-10-20 MPa and compared with the results of SDC. Typical polarization curves, which were theoretically predicted, were observed on all the samples. The slopes of lgσe-lgPo2 plot for all the composite electrolytes agreed with the theoretically predicted value of-1/4 at some intermediate oxygen partial pressures and -1/6 at low oxygen partial pressure. The electronic conductivity of SDC-LSGM composite electrolytes decreased with the increase in LSGM content, whereas the ionic transport number ti of all the samples increased with the increase in LSGM content.
文摘Dense sintered bodies of proton conducting BaZrO3 (BZ) and Y-doped BaZrO3 (BZ-Y) were obtained at 1600℃ for a short sintering time of 5 hours, by the addition of NiO as a sintering promotion agent. The relative density and grain growth of samples, Ni-doped BaZrO3 (BZ-N) and Ni, Y co-doped BaZrO3 (BZ-NY), were increased with increasing Ni addition. The sinterability of BZ-NY was greatly improved just to add only 0.6 mol% Ni and the relative density of this sample was more than 98%, in contrast to that of 60% at most for BZ-Y without Ni addition. Electrical conductivity of BZ-NY added Ni 1.0 mol%, BaZr0.91Ni0.01Y0.08O3-α, was more than 10-3 S.cm-2 at 900℃?in a wet 1% hydrogen atmosphere, which value was 10 times higher than that of BZ-Y. In addition, the kind of electrical conduction carrier and an ionic transport number were also examined by employing various concentration cells. It was found that the proton conduction was dominant for both BZ-N and BZ-NY samples, although BZ-NY showed scarcely oxygenion conduction approximately 10% in a high temperature range higher than 800℃. From these results, as mall amount of Ni addition found to be effective for improvement of both the sinterability and the electrical conductivity.
基金Project supported by the National Key Project for Fundamental Researchthe National Natural Science Foundation of China (Grant No. 29741002)
文摘A series of solid electrolytes (Ce0.8RE0.2)1 xMxO2-δ(RE: Rare earth, M: Alkali earth) were prepared by sol-gel methods. XRD indicated that a pure fluorite phase was formed at 800°C. The synthesis temperature by the sol-gel methods was about 700°C lower than by the traditional ceramic method. The electrical conductivity and impedance spectra were measured. XPS showed that the oxygen vacancy increased obviously by doping MO, thus, resulting in the increase of the oxygen ionic transport number and conductivity. The performance of ceria-based solid electrolyle was improved. The effects of RE2O3 and MO on the electrical properties were discussed. The conductivity and the oxygen ionie transport number of (Ce0.8Sm0.2)1 0.05Ca0.05O2-δ is 0.126 S·cm-1 and 0.99 at 800°C, respectively.
