GPS buoy methodology is one of the main calibration methodologies for altimeter sea surface height calibration. This study introduces the results of the Qinglan calibration campaign for the HY-2A and Jason-2 altimeter...GPS buoy methodology is one of the main calibration methodologies for altimeter sea surface height calibration. This study introduces the results of the Qinglan calibration campaign for the HY-2A and Jason-2 altimeters. It took place in two time slices;one was from August to September 2014, and the other was in July 2015. One GPS buoy and two GPS reference stations were used in this campaign. The GPS data were processed using the real-time kinematic (RTK) technique. The fi nal error budget estimate when measuring the sea surface height (SSH) with a GPS buoy was better than 3.5 cm. Using the GPS buoy, the altimeter bias estimate was about -2.3 cm for the Jason-2 Geophysical Data Record (GDR) Version ‘D' and from -53.5 cm to -75.6 cm for the HY-2A Interim Geophysical Data Record (IGDR). The bias estimates for Jason-2 GDR-D are similar to the estimates from dedicated calibration sites such as the Harvest Platform, the Crete Site and the Bass Strait site. The bias estimates for HY-2A IGDR agree well with the results from the Crete calibration site. The results for the HY-2A altimeter bias estimated by the GPS buoy were verifi ed by cross-calibration, and they agreed well with the results from the global analysis method.展开更多
The impact of ERS-1 altimeter significant wave height on analysis of wave field and wave pre- dictions is tested through analysis of selected cases. Application of the altimeter data may modifg initial tield and thus ...The impact of ERS-1 altimeter significant wave height on analysis of wave field and wave pre- dictions is tested through analysis of selected cases. Application of the altimeter data may modifg initial tield and thus 24-hour prediction of significant wave height. However the variations in initial wave field almost make no effect on 48-hour predictions.展开更多
During the satellite pulse propagation and reception, the altimeter waveform is inevitably affected by noise. To reduce the noise level in Jason altimeter waveforms, we used singular spectrum analysis(SSA),empirical m...During the satellite pulse propagation and reception, the altimeter waveform is inevitably affected by noise. To reduce the noise level in Jason altimeter waveforms, we used singular spectrum analysis(SSA),empirical mode decomposition(EMD), and the combination of SSA and EMD to obtain the denoised waveforms. The advantages of the combined method were verified and the accuracy of the mean sea surface height(MSSH) model was improved. Comparing the denoising effect of the three methods, the results show that the signal-to-noise ratio(SNR), correlation coefficient and root-mean-square error are effectively improved by the combination of SSA and EMD. The sea surface heights(SSHs) were remeasured with a 50% threshold retracker of denoised waveforms, and the MSSH model of the Caspian Sea with a grid of 1’× 1’was established from the retracked SSHs of Jason-1/2/3. Taking the mean value of the four models as a control, it is found that the model calculated by the combined denoising method has the highest accuracy. This indicates that using the combined denoising method to reduce the noise level is beneficial to improve the accuracy of the MSSH model.展开更多
More than 3 million range measurements from the Chang’E-1 Laser Altimeter have been used to produce a global topographic model of the Moon with improved accuracy. Our topographic model, a 360th degree and order spher...More than 3 million range measurements from the Chang’E-1 Laser Altimeter have been used to produce a global topographic model of the Moon with improved accuracy. Our topographic model, a 360th degree and order spherical harmonic expansion of the lunar radii, is designated as Chang’E-1 Lunar Topography Model s01 (CLTM-s01). This topographic field, referenced to a mean radius of 1738 km, has an absolute vertical accuracy of approximately 31 m and a spatial resolution of 0.25° (~7.5 km). This new lunar topographic model has greatly improved previous models in spatial coverage, accuracy and spatial resolution, and also shows the polar regions with the altimeter results for the first time. From CLTM-s01, the mean, equatorial, and polar radii of the Moon are 1737103, 1737646, and 1735843 m, respectively. In the lunar-fixed coordinate system, this model shows a COM/COF offset to be (?1.777, ?0.730, 0.237) km along the x, y, and z directions, respectively. All the basic lunar shape parameters derived from CLTM-s01 are in agreement with the results of Clementine GLTM2, but CLTM-s01 offers higher accuracy and reliability due to its better global samplings.展开更多
The design and operation of the Laser Altimeter of CE-1 Payloads System are presented in this paper.The paper includes the design of the system and spacecraft-level laser,the description of the emitting-system and rec...The design and operation of the Laser Altimeter of CE-1 Payloads System are presented in this paper.The paper includes the design of the system and spacecraft-level laser,the description of the emitting-system and receiving system,and the testing of the laser altimeter.The CE-1 laser altimeter is the first Chinese deep-space probe using a laser.It has one beam and operates at 1 Hz,with a nominal accuracy of 5 m.The laser altimeter has operated successfully in lunar orbit since November 28,2007.It has obtained 9120 thousand data values about the lunar altitude.展开更多
在流体静力平衡状态下,海洋Coriolis力和压力梯度平衡就形成地转流,世界上大多数海流都近似为地转流.本文利用卫星测高交叉点方法计算海洋表面地转流速度,分析了利用测高交叉点计算地转流速度的不确定性,上升和下降弧段的海面倾斜在分辨...在流体静力平衡状态下,海洋Coriolis力和压力梯度平衡就形成地转流,世界上大多数海流都近似为地转流.本文利用卫星测高交叉点方法计算海洋表面地转流速度,分析了利用测高交叉点计算地转流速度的不确定性,上升和下降弧段的海面倾斜在分辨率50km上可以达到10^(-7)量级,才可能获得优于10cm/s的地转流速度.在低纬度或者纬度接近卫星轨道倾角的地区,由交叉点方法计算的地转流速度精度低于中纬度地区.以中国台湾东部黑潮为试验区,利用最新的中国台湾周边海域大地水准面模型参考场计算高精度的大地水准面高,利用TOPEX/Poseidon和Jason-1的GDR数据(2002~2005年)计算海面高,然后计算交叉点的动力高,确定交叉点的地转流速度,结果与中国台湾NCOR(National Center for Ocean Research)的流速基本一致.展开更多
基金Supported by the National Key R&D Program of China(No.2016YFC1401003)the National Natural Science Foundation of China(Nos.41406204,41501417)the Marine Public Welfare Project of China(No.201305032-3)
文摘GPS buoy methodology is one of the main calibration methodologies for altimeter sea surface height calibration. This study introduces the results of the Qinglan calibration campaign for the HY-2A and Jason-2 altimeters. It took place in two time slices;one was from August to September 2014, and the other was in July 2015. One GPS buoy and two GPS reference stations were used in this campaign. The GPS data were processed using the real-time kinematic (RTK) technique. The fi nal error budget estimate when measuring the sea surface height (SSH) with a GPS buoy was better than 3.5 cm. Using the GPS buoy, the altimeter bias estimate was about -2.3 cm for the Jason-2 Geophysical Data Record (GDR) Version ‘D' and from -53.5 cm to -75.6 cm for the HY-2A Interim Geophysical Data Record (IGDR). The bias estimates for Jason-2 GDR-D are similar to the estimates from dedicated calibration sites such as the Harvest Platform, the Crete Site and the Bass Strait site. The bias estimates for HY-2A IGDR agree well with the results from the Crete calibration site. The results for the HY-2A altimeter bias estimated by the GPS buoy were verifi ed by cross-calibration, and they agreed well with the results from the global analysis method.
文摘The impact of ERS-1 altimeter significant wave height on analysis of wave field and wave pre- dictions is tested through analysis of selected cases. Application of the altimeter data may modifg initial tield and thus 24-hour prediction of significant wave height. However the variations in initial wave field almost make no effect on 48-hour predictions.
基金We acknowledge the National Natural Science Foundation of China(grant number 41974013)for financial support.
文摘During the satellite pulse propagation and reception, the altimeter waveform is inevitably affected by noise. To reduce the noise level in Jason altimeter waveforms, we used singular spectrum analysis(SSA),empirical mode decomposition(EMD), and the combination of SSA and EMD to obtain the denoised waveforms. The advantages of the combined method were verified and the accuracy of the mean sea surface height(MSSH) model was improved. Comparing the denoising effect of the three methods, the results show that the signal-to-noise ratio(SNR), correlation coefficient and root-mean-square error are effectively improved by the combination of SSA and EMD. The sea surface heights(SSHs) were remeasured with a 50% threshold retracker of denoised waveforms, and the MSSH model of the Caspian Sea with a grid of 1’× 1’was established from the retracked SSHs of Jason-1/2/3. Taking the mean value of the four models as a control, it is found that the model calculated by the combined denoising method has the highest accuracy. This indicates that using the combined denoising method to reduce the noise level is beneficial to improve the accuracy of the MSSH model.
基金Supported by the National Natural Science Foundation of China (Grant Nos 2008AA12A209 and 2008AA12A210)supported by Chang'E-1 monitoring and control systems, scientific applications system and the satellite systemssupported by the knowledge innovation project the "Hun-dred Excellent Project" of Chinese Academy of Sciences
文摘More than 3 million range measurements from the Chang’E-1 Laser Altimeter have been used to produce a global topographic model of the Moon with improved accuracy. Our topographic model, a 360th degree and order spherical harmonic expansion of the lunar radii, is designated as Chang’E-1 Lunar Topography Model s01 (CLTM-s01). This topographic field, referenced to a mean radius of 1738 km, has an absolute vertical accuracy of approximately 31 m and a spatial resolution of 0.25° (~7.5 km). This new lunar topographic model has greatly improved previous models in spatial coverage, accuracy and spatial resolution, and also shows the polar regions with the altimeter results for the first time. From CLTM-s01, the mean, equatorial, and polar radii of the Moon are 1737103, 1737646, and 1735843 m, respectively. In the lunar-fixed coordinate system, this model shows a COM/COF offset to be (?1.777, ?0.730, 0.237) km along the x, y, and z directions, respectively. All the basic lunar shape parameters derived from CLTM-s01 are in agreement with the results of Clementine GLTM2, but CLTM-s01 offers higher accuracy and reliability due to its better global samplings.
文摘The design and operation of the Laser Altimeter of CE-1 Payloads System are presented in this paper.The paper includes the design of the system and spacecraft-level laser,the description of the emitting-system and receiving system,and the testing of the laser altimeter.The CE-1 laser altimeter is the first Chinese deep-space probe using a laser.It has one beam and operates at 1 Hz,with a nominal accuracy of 5 m.The laser altimeter has operated successfully in lunar orbit since November 28,2007.It has obtained 9120 thousand data values about the lunar altitude.
文摘在流体静力平衡状态下,海洋Coriolis力和压力梯度平衡就形成地转流,世界上大多数海流都近似为地转流.本文利用卫星测高交叉点方法计算海洋表面地转流速度,分析了利用测高交叉点计算地转流速度的不确定性,上升和下降弧段的海面倾斜在分辨率50km上可以达到10^(-7)量级,才可能获得优于10cm/s的地转流速度.在低纬度或者纬度接近卫星轨道倾角的地区,由交叉点方法计算的地转流速度精度低于中纬度地区.以中国台湾东部黑潮为试验区,利用最新的中国台湾周边海域大地水准面模型参考场计算高精度的大地水准面高,利用TOPEX/Poseidon和Jason-1的GDR数据(2002~2005年)计算海面高,然后计算交叉点的动力高,确定交叉点的地转流速度,结果与中国台湾NCOR(National Center for Ocean Research)的流速基本一致.