Nd:NaBi(WO_4)_2 crystals (Nd:NBW) were grown by Czochralski method. The pulling rate is 0.3 mm·h (-1),and the rotational speed of Nd:NBW crystal is 2 r·min (-1). The components of this single crystal were de...Nd:NaBi(WO_4)_2 crystals (Nd:NBW) were grown by Czochralski method. The pulling rate is 0.3 mm·h (-1),and the rotational speed of Nd:NBW crystal is 2 r·min (-1). The components of this single crystal were determined by X-ray diffractions,and its corresponding properties were described from thermal gravity and differential thermal analysis experiments. The absorption cross-sections were calculated. The emission band of Nd:NBW crystal was obtained from its luminous spectrum.展开更多
Magnetic susceptibility,specific heat,and neutron powder diffraction measurements have been performed on polycrystalline Li_(2)Co(WO_4)_(2)samples.Under zero magnetic field,two successive magnetic transitions at T_(N1...Magnetic susceptibility,specific heat,and neutron powder diffraction measurements have been performed on polycrystalline Li_(2)Co(WO_4)_(2)samples.Under zero magnetic field,two successive magnetic transitions at T_(N1)~9.4 K and T_(N2)~7.4 K are observed.The magnetic ordering temperatures gradually decrease as the magnetic field increases.Neutron diffraction reveals that Li_(2)Co(WO_4)_(2)enters an incommensurate magnetic state with a temperature dependent k between T_(N1)and T_(N2).The magnetic propagation vector locks-in to a commensurate value k=(1/2,1/4,1/4)below T_(N2).The antiferromagnetic structure is refined at 1.7 K with Co2+magnetic moment 2.8(1),μ_B,consistent with our first-principles calculations.展开更多
A series of tungstate red phosphors K_(1-x)Li_(x)Eu(WO_(4))_(2-y)(SO_(4))_(y)were successfully prepared by sol-gel method,and the effects of the introduction of Li^(+)and SO_(4)^(2-)on the fluorescence intensity and t...A series of tungstate red phosphors K_(1-x)Li_(x)Eu(WO_(4))_(2-y)(SO_(4))_(y)were successfully prepared by sol-gel method,and the effects of the introduction of Li^(+)and SO_(4)^(2-)on the fluorescence intensity and thermal quenching properties of the prepared K_(1-x)Li_(x)Eu(WO_(4))_(2-y)(SO_(4))_(y)phosphors were investigated.The X-ray diffraction data show that the prepared(Li^(+)and SO_(4)^(2-))-doped KEu(WO_(4))_(2)phosphors have a monoclinic tetragonal structure.In addition,the emission intensities of all the observed emission peaks change significantly with the increase of Li~+doping concentration,especially the intensity of the emission peaks at 615 nm fluctuated significantly and reached the maximum at x=0.3 and y=0.2.The K_(1-x)Li_(x)Eu(WO_(4))_(2-y)(SO_(4))_(y)phosphors are found to have the highest fluorescence intensity at x=0.3 and y=0.2.Moreover,the K_(0.7)Li_(0.3)Eu(WO_(4))_(1.8)(SO_(4))_(0.2)phosphor has better thermal quenching properties and luminescence efficiency,and the experimental results indicates that the fluorescence intensity and thermal burst performance of KEu(WO_(4))_(2)red phosphor could be effectively improved by using low-cost bionic doping of Li^(+)and SO_(4)^(2-).展开更多
Kesterite Cu_(2)ZnSn(S,Se)_(4)(CZTSSe)has attracted considerable attention as a non-toxic and earthabundant solar cell material.During selenization of CZTSSe film at high temperature,the reaction between CZTSSe and Mo...Kesterite Cu_(2)ZnSn(S,Se)_(4)(CZTSSe)has attracted considerable attention as a non-toxic and earthabundant solar cell material.During selenization of CZTSSe film at high temperature,the reaction between CZTSSe and Mo is one of the main reasons that result in unfavorable absorber and interface quality,which leads to large open circuit voltage deficit(VOC-def)and low fill factor(FF).Herein,a WO_(3)intermediate layer introduced at the back interface can effectually inhibit the unfavorable interface reaction between absorber and back electrode in the preliminary selenization progress;thus high-quality crystals are obtained.Through this back interface engineering,the traditional problems of phase segregation,voids in the absorber and over thick Mo(S,Se)_(2)at the back interface can be well solved,which greatly lessens the recombination in the bulk and at the interface.The increased minority carrier diffusion length,decreased barrier height at back interface contact and reduced deep acceptor defects give rise to systematic improvement in VOCand FF,finally a 12.66%conversion efficiency for CZTSSe solar cell has been achieved.This work provides a simple way to fabricate highly efficient solar cells and promotes a deeper understanding of the function of intermediate layer at back interface in kesterite-based solar cells.展开更多
文摘Nd:NaBi(WO_4)_2 crystals (Nd:NBW) were grown by Czochralski method. The pulling rate is 0.3 mm·h (-1),and the rotational speed of Nd:NBW crystal is 2 r·min (-1). The components of this single crystal were determined by X-ray diffractions,and its corresponding properties were described from thermal gravity and differential thermal analysis experiments. The absorption cross-sections were calculated. The emission band of Nd:NBW crystal was obtained from its luminous spectrum.
基金Project supported by the National Natural Science Foundation of China(Grant Nos.11834002,12074111,and 11704109)the National Key R&D Project of China(Grant No.2016YFA0300101)。
文摘Magnetic susceptibility,specific heat,and neutron powder diffraction measurements have been performed on polycrystalline Li_(2)Co(WO_4)_(2)samples.Under zero magnetic field,two successive magnetic transitions at T_(N1)~9.4 K and T_(N2)~7.4 K are observed.The magnetic ordering temperatures gradually decrease as the magnetic field increases.Neutron diffraction reveals that Li_(2)Co(WO_4)_(2)enters an incommensurate magnetic state with a temperature dependent k between T_(N1)and T_(N2).The magnetic propagation vector locks-in to a commensurate value k=(1/2,1/4,1/4)below T_(N2).The antiferromagnetic structure is refined at 1.7 K with Co2+magnetic moment 2.8(1),μ_B,consistent with our first-principles calculations.
基金Funded by the Science and Technology Bureau of Chengdu City(No.2022-YF05-02119-SN)。
文摘A series of tungstate red phosphors K_(1-x)Li_(x)Eu(WO_(4))_(2-y)(SO_(4))_(y)were successfully prepared by sol-gel method,and the effects of the introduction of Li^(+)and SO_(4)^(2-)on the fluorescence intensity and thermal quenching properties of the prepared K_(1-x)Li_(x)Eu(WO_(4))_(2-y)(SO_(4))_(y)phosphors were investigated.The X-ray diffraction data show that the prepared(Li^(+)and SO_(4)^(2-))-doped KEu(WO_(4))_(2)phosphors have a monoclinic tetragonal structure.In addition,the emission intensities of all the observed emission peaks change significantly with the increase of Li~+doping concentration,especially the intensity of the emission peaks at 615 nm fluctuated significantly and reached the maximum at x=0.3 and y=0.2.The K_(1-x)Li_(x)Eu(WO_(4))_(2-y)(SO_(4))_(y)phosphors are found to have the highest fluorescence intensity at x=0.3 and y=0.2.Moreover,the K_(0.7)Li_(0.3)Eu(WO_(4))_(1.8)(SO_(4))_(0.2)phosphor has better thermal quenching properties and luminescence efficiency,and the experimental results indicates that the fluorescence intensity and thermal burst performance of KEu(WO_(4))_(2)red phosphor could be effectively improved by using low-cost bionic doping of Li^(+)and SO_(4)^(2-).
基金supported by the National Key R&D Program of China(no.2018YFE0203400)the National Natural Science Foundation of China(no.62074102)+1 种基金the Guangdong Basic and Applied Basic Research Foundation(no.2022A1515010979)the Science and Technology plan project of Shenzhen(nos.JCYJ20190808120001755 and 20220808165025003)。
文摘Kesterite Cu_(2)ZnSn(S,Se)_(4)(CZTSSe)has attracted considerable attention as a non-toxic and earthabundant solar cell material.During selenization of CZTSSe film at high temperature,the reaction between CZTSSe and Mo is one of the main reasons that result in unfavorable absorber and interface quality,which leads to large open circuit voltage deficit(VOC-def)and low fill factor(FF).Herein,a WO_(3)intermediate layer introduced at the back interface can effectually inhibit the unfavorable interface reaction between absorber and back electrode in the preliminary selenization progress;thus high-quality crystals are obtained.Through this back interface engineering,the traditional problems of phase segregation,voids in the absorber and over thick Mo(S,Se)_(2)at the back interface can be well solved,which greatly lessens the recombination in the bulk and at the interface.The increased minority carrier diffusion length,decreased barrier height at back interface contact and reduced deep acceptor defects give rise to systematic improvement in VOCand FF,finally a 12.66%conversion efficiency for CZTSSe solar cell has been achieved.This work provides a simple way to fabricate highly efficient solar cells and promotes a deeper understanding of the function of intermediate layer at back interface in kesterite-based solar cells.
