Structural Changes of Y Zeolites with Different Initial SiO_2/Al_2O_3 Ratios during Hydrothermal Treatment

The effects of the initial framework SiO2/Al2O3 ratio and temperature on the structural changes of NaY zeolites during hydrothermal treatments are studied. Two samples with different framework SiO2/Al2O3 ratios are subjected to hydrothermal treatment at four different temperatures. For zeolite with a lower initial SiO2/Al2O3 ratio of 4.2, mesopores are easily formed because more framework aluminum is detached. Moreover, two kinds of mesopores are produced at a higher temperature due to the interconnection of vacancies and smaller mesopores. For zeolite with a higher initial SiO2/Al2O3 ratio of 6.0, there are less mesopores formed as compared with the lower initial SiO2/Al2O3 ratio sample, but there are some macropores formed. This may be attributed to the isolation of vacancies and the different distributions of aluminum in the crystal lattice of the zeolite. The experiment data show that NaY with the SiO2/Al2O3 ratio of 6.0 retains a high relative crystallinity during the hydrothermal treatment. This proves that a high framework SiO2/Al2O3 ratio benefits the stability of zeolite.

Investigation of Self-Diffusion and Structure in Calcium Aluminosilicate Slags by Molecular Dynamics Simulation

Molecular dynamics simulation is applied to investigate the mechanism and variation of self-diffusion in calcium aluminosilicate slags. The self-diffusion coefficients are calculated for eleven slag compositions with varying Al2O3/SiO2 ratios at a fixed CaO content. In practice, the results of the study are relevant to the significant changes in transport phenomenon caused by the changes in chemical composition during continuous casting of steels containing high amounts of dissolved aluminum. The cooperative movement between O atoms and network formers is discussed since [AlO4] and [SiO4] tetrahedra are the elementary structural units in the CaO-Al2O3-SiO2 (CAS) slag system. The diffusivities for four atomic types are affected by the degree of polymerization (DOP) of slag network characterized by the proportions of non-bridging oxygen (NBO) and Qn species in the system. On the other hand, a sudden increase in 5-coordinated Al as network modifiers in high alumina regions slightly increases the self-diffusion coefficient for Al. As another structural defect, oxygen tricluster plays an important role in the behavior of self-diffusion for O atoms, while the diffusivity for Ca is deeply influenced by its bonding and coordinating conditions.

Study on Bifunctionality of Mo/HZSM-5 Catalysts for Methane Dehydro-Aromatization under Non-oxidative Condition

The optimum Mo/[H^+] ratio per unit cell of the active precursors in Mo/HZSM-5 catalysts for methane dehydro-aromatization, measured by1H MAS NMR, was found to be about 1 when adjusting the acid sites by altering either the SiO2/Al2O3 ratios or the Mo loading. This implies that a concerted interaction between the Mo species and the Bronsted acid sites probably features the bifunctionality of the Mo/HZSM-5 catalyst. On the other hand, it was found that the driving force for Mo species to move into the HSZM-5 zeolite channels and the interaction between the Mo species and the Bronsted acid sites are closely and proportionably related with the amount of Bronsted acid sites per unit cell.

Effect of alumina content and heat treatment on microstructure and upconversion emission of Er^(3+)ions in oxyfluoride glass-ceramics

The effect of alumina content and heat treatment temperature and time, on microstructure and Er3＋ （0.5 mol.%） emission of oxyfluoride glass-ceramics were investigated in this research. Two values of 1.8 （SA1.8Er0.5） and 2.18 （SA2.18Er0.5） were selected in this research for SiO2/Al2O3 ratio. According to DTA results, precursor glasses were heat treated at 630, 660 and 690 ℃ for 4 h and some glasses were also heat treated at 630 ℃ for 48 and 72 h. The results indicated that alumina content had significant effect on phase separation and viscosity of the glasses. Therefore the size, size distribution, and volume concentration of nano CaF2 crystals which precipitated during the heat treatment depended on alumina content of the glass. Due to the much smaller size of the precipitated CaF2 crystals in the glasses of low alumina content, these samples maintained excellent transparency and had narrower crystal size distribution than the high alumina glasses. The crystal size was increased markedly with the temperature increasing from 630 to 690 ℃. On the other hand a slight increase was observed in the crystal size by raising the heat treatment time in both glasses. Results indicated that in low alumina content glass （SA2.18Er0.5） the size of CaF2 nanocrystals was controlled in one order of magnitude. The increase of heat treatment time and temperature led to the incorporation of Er3＋ ions into CaF2 crystalline phase, increasing significantly the upconversion intensity. After heat treatment at 690 ℃for 4 h, atomic force microscope （AFM） revealed the development of small crystals with an average size of 80 and 30 nm in SA1.8Er0.5 and SA2.18Er0.5 samples, respectively.

低硅铝比ZSM-5分子筛上C_4烃的催化裂解反应

以低硅铝比(n(SiO2)/n(Al2O3)=20-45)的ZSM-5分子筛为催化剂,研究了混合C4烃的催化裂解反应,并对不同硅铝比的ZSM-5分子筛进行了酸性表征.混合C4烃的催化裂解反应结果表明,低硅铝比的ZSM-5分子筛具有较高的低温催化活性,高硅铝比ZSM-5分子筛催化剂上乙烯和丙烯的收率高于低硅铝比ZSM-5分子筛催化剂,低硅铝比ZSM-5分子筛上苯和甲苯的收率高于高硅铝比ZSM-5分子筛催化剂.在反应温度为625℃时,硅铝比为20的ZSM-5分子筛催化剂上乙烯、丙烯、苯和甲苯的总收率可达79.42%.酸性表征结果表明,硅铝比低的ZSM-5分子筛具有更多的Br觟nsted(B)酸酸量、Lewis(L)酸酸量及总酸酸量,这是低硅铝比ZSM-5分子筛具有低温高活性及高的苯和甲苯收率的原因.

Geochemical indicator of original eolian grain size and implications on winter monsoon evolution

Grain size of eolian deposits from the Loess Plateau in China has been widely used to reconstruct the history of the East Asian winter monsoon. However, the grain size of bulk samples is only partially indicative to the strength of the winter monsoon because post-depositional weathering processes have significantly changed the grain size of original eolian particles. Here, non-weathered loess samples were separated into eight different particle fractions, and major chemical elements were determined in order to establish a geochemical indicator of original eolian grain size. The results show that SiO2and AI2O3contents and the SiO2/AI203 ratio in different fractions vary regularly with grain size, and that a good linear relation exists between the SiO2/AI2O3 ratio and grain size for the fractions【50μm. Because Al and Si are among the most stable elements and pedogenic processes in the Loess Plateau cannot affect the SiO2/AI2O3 ratio, this index can be used to reflect the grain size of original eolian

Characteristics of Heat Flux Through Slag Film of Mold Slag Used for High Al-TRIP Steel Casting

Due to the high content of the Al-TRIP steel, Al reacts with SiO2 in the mold slag during the casting process, which results in the increase of ωAl2O3 /ωSiO2 ratio and the Al2O3 content, respectively; the characteristic of heat transfer through the slag film is then changed, which influences the smooth operation of the continuous casting process. The heat flux simulator of mold slag film was used to study the change tendency of the heat flux density through slag film and the results were discussed; at the same time, the characteristics of the crystals in the No. 15 mold slag were determined by BSE and XRD. The results obtained show that heat flux density decreases with the increase of ωAl2O3 /ωSiO2 ratio. Heat flux density increases with the increase of Li2O and/or B2O3 content in the mold slag which contains 30 % of Al2 O3. Compared with the heat flux density of common slag of peritectic steel, a suitable mold slag containing 4% of B2O3 and 4% of Li2O is designed. The heat flux density is 0. 645 MW/m^2 when ωAl2O3 /ωSiO2 = 1. 46. Under this experimental condition, the CaF2 crystals precipitate in the mold slag used for Al-TRIP steel.