Hydrological models are very useful tools for evaluating water resources, and the hydroclimatic hazards associated with the water cycle. However, their calibration and validation require the use of performance criteri...Hydrological models are very useful tools for evaluating water resources, and the hydroclimatic hazards associated with the water cycle. However, their calibration and validation require the use of performance criteria which choice is not straightforward. This paper aims to evaluate the influence of the performance criteria on water balance components and water extremes using two global rainfall-runoff models (HBV and GR4J) over the Ouémé watershed at the Bonou and Savè outlets. Three (3) Efficacy criteria (Nash, coefficient of determination, and KGE) were considered for calibration and validation. The results show that the Nash criterion provides a good assessment of the simulation of the different parts of the hydrograph. KGE is better for simulating peak flows and water balance elements than other efficiency criteria. This study could serve as a basis for the choice of performance criteria in hydrological modelling.展开更多
The fabrication of high volume fraction (HVF) M7C3 (M=Cr, Fe) reinforced Fe-based composite coating on ASTM A36 steel plate using plasma transferred arc (PTA) welding was studied. The results showed that the vol...The fabrication of high volume fraction (HVF) M7C3 (M=Cr, Fe) reinforced Fe-based composite coating on ASTM A36 steel plate using plasma transferred arc (PTA) welding was studied. The results showed that the volume fraction of carbide M7C3 was more than sixty percent, and the relative wear resistance of the coating tested on a block-on-ring dry sliding tester at constant load (100 N) and variable loads (from 100 to 300 N) respectively was about 9 and 14 times higher than that of non-reinforced a-Fe coating. In addition, under constant load condition the friction coefficients (FCs) of two coatings increased first and then decreased with increasing sliding distance. However, under variable loads condition the FCs of non-reinforced a-Fe based coating increased gradually, while that of HVF MTC3 reinforced coating decreased as the load exceeded 220 N. The worn surface of non-reinforced a-Fe based coating was easily deformed and grooved, while that of the HVF M7C3 reinforced coating was difficult to be deformed and grooved.展开更多
To mitigate the deleterious effects of clutter and jammer, modern radars have adopted adaptive processing techniques such as constant false alarm rate(CFAR) detectors which are widely used to prevent clutter and noise...To mitigate the deleterious effects of clutter and jammer, modern radars have adopted adaptive processing techniques such as constant false alarm rate(CFAR) detectors which are widely used to prevent clutter and noise interference from saturating the radar’s display and preventing targets from being obscured.This paper concerns with the detection analysis of the novel version of CFAR schemes(cell-averaging generalized trimmed-mean,CATM) in the presence of additional outlying targets other than the target under research. The spurious targets as well as the tested one are assumed to be fluctuating in accordance with the χ~2-model with two-degrees of freedom. In this situation, the processor performance is enclosed by the swerling models(SWI and SWII). Between these bounds, there is an important class of target fluctuation which is known as moderately fluctuating targets. The detection of this class has many practical applications. Structure of the CATM detector is described briefly. Detection performances for optimal, CAM, CA, trimmed-mean(TM) and ordered-statistic(OS) CFAR strategies have been analyzed and compared for desired probability of false alarm and determined size of the reference window. False alarm rate performance of these processors has been evaluated for different strengths of interfering signal and the effect of correlation among the target returns on the detection and false alarm performances has also been studied. Our numerical results show that, with a proper choice of trimming parameters,the novel model CAM presents an ideal detection performance outweighing that of the Neyman-Pearson detector on condition that the tested target obeys the SWII model in its fluctuation. Although the new models CAS and CAM can be treated as special cases of the CATM algorithm, their multi-target performance is modest even it has an enhancement relative to that of the classical CAcheme. Additionally, they fail to maintain the false alarm rate constant when the operating environment is of type target multiplicity. Moreover, the non-coherent integration of M pulses ameliorates the processor performance either it operates in homogeneous or multi-target environment.展开更多
Based on the methods of financial analysis, the direct earnings in mergers and acquisition M&A, profit or loss from stock price fluctuation, influence on the earning per stock(EPS) and revenue growth after M&A...Based on the methods of financial analysis, the direct earnings in mergers and acquisition M&A, profit or loss from stock price fluctuation, influence on the earning per stock(EPS) and revenue growth after M&A were analyzed in detail. And several quantitative models were established in relevant part accordingly. It can be useful to improve the present low efficiency in the M&A performance in Chinese capital market.展开更多
In order to obtain higher emission performance than that of a traditional M-type cathode, we have developed a new type impregnated dispenser cathode. The new cathode is impregnated with a new active substance with mol...In order to obtain higher emission performance than that of a traditional M-type cathode, we have developed a new type impregnated dispenser cathode. The new cathode is impregnated with a new active substance with molar ratio of 26BaO·29SrO·8Sc2O3 ·7CaO·Al2O3 . This paper introduces the emission performance, surface active material, and work function of the new cathode. At 1100℃B , the DC current density and pulse current density are 30.6±1.0 A/cm2 and 171.6±2.8 A/cm2 , respectively, 2.1 and 5.4 times of that of an M-type cathode. The work function of the new cathode is 1.668± 0.002 eV. High concentration O-Al-Sc-Sr-Ba and O-Al-Sc-Ba are found in the pores and at pore edges, respectively. By comparing the emission performances and surface characteristics of as-polished and as-cleaned cathodes, it is proposed that, the emission around pore ends forms the major part of the total emission for the new cathodes.展开更多
The growing need for high-performance networking is achieved with parallel processing;several networking functions are processed concurrently in order to accomplish a performance Networking Architecture. Open systems ...The growing need for high-performance networking is achieved with parallel processing;several networking functions are processed concurrently in order to accomplish a performance Networking Architecture. Open systems interconnection (OSI) model is an example of multi-layering structure, and each layer performs definite function unique to that layer. OSI model works on pass it on principle, and it is divided in two stacks lower stack and upper stack. Layers 4 - 7 represent upper stack and responsible for data applications. The remaining 1 - 3 layers represent the lower stack and mostly involve in data movement. There are many techniques are available for server optimization enhancing the availability by distributing the load among peer servers. According to our knowledge, nobody has implemented such splitting architecture across the entire OSI model. In this paper, we present multilayer Split-protocol (MLSP) a high performance, reliable and secure technique for spiting an application or network protocol across OSI model, and we present the design, implementation, and empirical performance evaluation of MLSP. It is the ideal choice for Cloud services where each functional component is considered an independent of each other.展开更多
文摘Hydrological models are very useful tools for evaluating water resources, and the hydroclimatic hazards associated with the water cycle. However, their calibration and validation require the use of performance criteria which choice is not straightforward. This paper aims to evaluate the influence of the performance criteria on water balance components and water extremes using two global rainfall-runoff models (HBV and GR4J) over the Ouémé watershed at the Bonou and Savè outlets. Three (3) Efficacy criteria (Nash, coefficient of determination, and KGE) were considered for calibration and validation. The results show that the Nash criterion provides a good assessment of the simulation of the different parts of the hydrograph. KGE is better for simulating peak flows and water balance elements than other efficiency criteria. This study could serve as a basis for the choice of performance criteria in hydrological modelling.
基金Funded by the National Natural Science Fundation of China(No.51171116)the Ministry of Science and Technology of China(No.2009DFB50350)+1 种基金the Research Foundation of Education Bureau of Hubei Province,China(No.Q20122304)the Foundation of Hubei University of Automotive Technology,China(No.BK201205)
文摘The fabrication of high volume fraction (HVF) M7C3 (M=Cr, Fe) reinforced Fe-based composite coating on ASTM A36 steel plate using plasma transferred arc (PTA) welding was studied. The results showed that the volume fraction of carbide M7C3 was more than sixty percent, and the relative wear resistance of the coating tested on a block-on-ring dry sliding tester at constant load (100 N) and variable loads (from 100 to 300 N) respectively was about 9 and 14 times higher than that of non-reinforced a-Fe coating. In addition, under constant load condition the friction coefficients (FCs) of two coatings increased first and then decreased with increasing sliding distance. However, under variable loads condition the FCs of non-reinforced a-Fe based coating increased gradually, while that of HVF MTC3 reinforced coating decreased as the load exceeded 220 N. The worn surface of non-reinforced a-Fe based coating was easily deformed and grooved, while that of the HVF M7C3 reinforced coating was difficult to be deformed and grooved.
文摘To mitigate the deleterious effects of clutter and jammer, modern radars have adopted adaptive processing techniques such as constant false alarm rate(CFAR) detectors which are widely used to prevent clutter and noise interference from saturating the radar’s display and preventing targets from being obscured.This paper concerns with the detection analysis of the novel version of CFAR schemes(cell-averaging generalized trimmed-mean,CATM) in the presence of additional outlying targets other than the target under research. The spurious targets as well as the tested one are assumed to be fluctuating in accordance with the χ~2-model with two-degrees of freedom. In this situation, the processor performance is enclosed by the swerling models(SWI and SWII). Between these bounds, there is an important class of target fluctuation which is known as moderately fluctuating targets. The detection of this class has many practical applications. Structure of the CATM detector is described briefly. Detection performances for optimal, CAM, CA, trimmed-mean(TM) and ordered-statistic(OS) CFAR strategies have been analyzed and compared for desired probability of false alarm and determined size of the reference window. False alarm rate performance of these processors has been evaluated for different strengths of interfering signal and the effect of correlation among the target returns on the detection and false alarm performances has also been studied. Our numerical results show that, with a proper choice of trimming parameters,the novel model CAM presents an ideal detection performance outweighing that of the Neyman-Pearson detector on condition that the tested target obeys the SWII model in its fluctuation. Although the new models CAS and CAM can be treated as special cases of the CATM algorithm, their multi-target performance is modest even it has an enhancement relative to that of the classical CAcheme. Additionally, they fail to maintain the false alarm rate constant when the operating environment is of type target multiplicity. Moreover, the non-coherent integration of M pulses ameliorates the processor performance either it operates in homogeneous or multi-target environment.
文摘Based on the methods of financial analysis, the direct earnings in mergers and acquisition M&A, profit or loss from stock price fluctuation, influence on the earning per stock(EPS) and revenue growth after M&A were analyzed in detail. And several quantitative models were established in relevant part accordingly. It can be useful to improve the present low efficiency in the M&A performance in Chinese capital market.
基金Supported by the National Natural Science Foundation of China (No. 60871053)the Major State Basic Research Development Program of China (No. 2013CB328901)
文摘In order to obtain higher emission performance than that of a traditional M-type cathode, we have developed a new type impregnated dispenser cathode. The new cathode is impregnated with a new active substance with molar ratio of 26BaO·29SrO·8Sc2O3 ·7CaO·Al2O3 . This paper introduces the emission performance, surface active material, and work function of the new cathode. At 1100℃B , the DC current density and pulse current density are 30.6±1.0 A/cm2 and 171.6±2.8 A/cm2 , respectively, 2.1 and 5.4 times of that of an M-type cathode. The work function of the new cathode is 1.668± 0.002 eV. High concentration O-Al-Sc-Sr-Ba and O-Al-Sc-Ba are found in the pores and at pore edges, respectively. By comparing the emission performances and surface characteristics of as-polished and as-cleaned cathodes, it is proposed that, the emission around pore ends forms the major part of the total emission for the new cathodes.
文摘The growing need for high-performance networking is achieved with parallel processing;several networking functions are processed concurrently in order to accomplish a performance Networking Architecture. Open systems interconnection (OSI) model is an example of multi-layering structure, and each layer performs definite function unique to that layer. OSI model works on pass it on principle, and it is divided in two stacks lower stack and upper stack. Layers 4 - 7 represent upper stack and responsible for data applications. The remaining 1 - 3 layers represent the lower stack and mostly involve in data movement. There are many techniques are available for server optimization enhancing the availability by distributing the load among peer servers. According to our knowledge, nobody has implemented such splitting architecture across the entire OSI model. In this paper, we present multilayer Split-protocol (MLSP) a high performance, reliable and secure technique for spiting an application or network protocol across OSI model, and we present the design, implementation, and empirical performance evaluation of MLSP. It is the ideal choice for Cloud services where each functional component is considered an independent of each other.